Samsung SCX 5530FN User Manual

14.18   
Common Windows problems
Note
Refer to Microsoft Windows 98/Me/NT 4.0/2000/XP User’s Guide 
that came with your PC for furt her information on Windows error 
messages.
ConditionSuggested solutions
“File in Use” 
message appears 
during installation. Exit all software applications. Remove all 
software from the StartUp Group, then restart 
Windows. Reinstall the printer driver.
“Error Writing to 
LPTx” message 
appears. • Ensure that the cables are connected 
correctly, the machine is on.
• If...

14.19   
Common Linux problems
ProblemPossible Cause and Solution
The machine does not 
print • Check if the printer driver is installed in 
your system. Open Unified Driver 
configurator and switch to the Printers 
tab in Printers configuration window to 
look at the list of available printers. Make 
sure that your machine is displayed on 
the list. If not, please, invoke Add new 
printer wizard to set up your device.
• Check if the printer is started. Open 
Printers configuration and select your...

14.20   
The machine does not 
scan • Check if a document is loaded into the 
machine.
• Check if your machine is connected to  the computer. Make sure if it is 
connected properly if I/O error is 
reported while scanning.
• Check if the port is not busy. Since 
functional components of MFP (printer 
and scanner) share the same I/O 
interface (port), the situation of 
simultaneous access of different 
“consumer” application to the same port 
is possible. To avoid possible conflicts, 
only one of them at...

15.1   
15 Installing accessories
Your machine is a full-featured one that has been optimized to meet most 
of your printing needs. Recognizing that each user may have different 
requirements, however, Samsung makes several accessories available 
to enhance your machine’s capabilities.
This chapter includes:
• Precautions when installing accessories
• Installing a memory DIMM
Precautions when installing accessories
Disconnect the power cord
Never remove the control board cover while the power is being...

15.2   
6 Push the DIMM straight into the DIMM slot until it snaps into place. 
Make sure the latches fit over the notches located on either side of 
the DIMM.
7 Replace the control board cover. 
8 Reconnect the power cord and printer cable, and turn the machine 
on.Activating the added memory in the PS printer 
properties
 (SCX-5530FN only)
After installing the memory DIMM, you need to select it in the printer 
properties of the PostScript printer driver so that you can use it.
1 Make sure that the...

16.1   
16 Specifications
This chapter includes:
• General specifications
• Scanner and copier specifications
• Printer specifications
• Facsimile specifications (SCX-5530FN only)
General specifications
ItemDescription
ADF
Up to 50 sheets (75 g/m2)
ADF document size 
Width: 142 to 216 mm
Length: 148 to 356 mm
Paper input capacity
Tray 1/2: 250 multi-pages for plain paper 
(75 g/m2)
Multi-purpose tray: 50 pages for plain paper, 
5 pages for card stock, labels, 
transparencies, and envelopes 
(60 to 163...

16.2   
Scanner and copier specifications
ItemDescription
Compatibility
TWAIN standard / WIA standard
Scanning method
ADF and Flat-bed Color CCD (Charge 
Coupled Device) module 
Resolution
Optical: 600 x 1,200 dpi (mono and color)
Enhanced: 4,800 x 4,800 dpi
Effective scanning 
length
Scanner glass: 297 mm
ADF: 356 mm
Effective scanning 
width
Max 208 mm
Color bit depth
24 bit
Mono bit depth
1 bit for Black & White mode
8 bit for Gray mode
Copy speed
a
a. Copy Speed is based on Single Document Multiple...

1  
INDEX
Numerics
2/4-up, special copy  6.2
A
accessoriesinstalling memory DIMM
  15.1
order information
  12.1
Address Book, use
  8.5
ADF
  1.2
ADF rubber pad, replace
  13.7
ADF, load
  5.1
alarm sound
  2.3
Ans/Fax mode, receiving mode
  9.4
B
background image, erase  6.4
C
characters, enter  2.3
cleaning drum
  13.5
inside
  13.2
LSU
  13.3
outside
  13.2
scan unit
  13.3
clock mode
  2.2
clone, special copy
  6.4
collation, special copy
  6.2
component location
  1.2
control panel
  1.3
copying...

2  
operating systems  4.1
TCP/IP
  4.1
new toner notification, send
  13.6
n-up (multiple pages per sheet) copying
  6.2
O
originalsjam, clear
  14.1
loading
  5.1
output location, select
  5.8
output tray
  5.8
P
paper guidelines  5.4
paper jam, clear duplex area
  14.5
fuser area or around toner cartridge
  
14.3
multi-purpose tray
  14.3
optional tray 2
  14.3
paper exit area
  14.4
tray 1
  14.2
paper level indicator
  5.5
paper load multi-purpose tray
  5.7
tray 1/optional tray 2
  5.5
paper size...

Samsung Printer
Software section
Downloaded From ManualsPrinter.com Manuals