Panasonic Wv Ns202 Operating Instructions Manual

LOCK
WV-NS202
OPEN
Before attempting to connect or operate this product,
please read these instructions carefully and save this manual for future use.
Network Camera
Network Operating Instructions 
Model No.WV-NS202 

2
CONTENTS
Preface ............................................................................................................................ 3
About these operating instructions  .............................................................................. 3
Trademarks and Registered Trademarks  ................................................................... 3
Viewer Software  .......................................................................................................... 3
Monitor...

3
Preface
About these operating instructions
There are 2 sets of operating instructions for the WV-NS202 as follows.
• Installation Guide
• Network operating instructions
These network operating instructions contain descriptions of how to operate this product using a PC via a network
and of how to configure the settings.
Refer to the installation guide for descriptions of how to install this product and of how to connect to a network.
Adobe
®Reader is required to read PDF. When the Adobe ®Reader is not...

4
Monitor Images on a PC
The following are descriptions of how to monitor images from the camera on a PC.
Monitor images from a single camera
Notes:
• When ON is selected for User Authentication, the
authentication window will be displayed before dis-
playing live images for the user name and password
entries. The default user name and password are as
follows.
User name: admin
Password: 12345
When accessing the camera without changing the
default password, the pop-up window saying that it
is recommended...

5
About the Live page
q[Setup] button (*1)
Click this button to display the setup menu. The but-
ton will turn green and the setup menu will be dis-
played.
w[Live] button
Click this button to display the Live page. The but-
ton will turn green and the Live page will be dis-
played.
eMulti-screen buttons
Images from multiple cameras can be displayed on
a multi-screen by registering cameras on the setup
menu. (page 9)
rImage type buttons
:The letters MPEG-4 on the button will
turn green and an MPEG-4...

6
u[SD] button (manual SD recording
button) (*2)
This button will be displayed only when Manual is
selected for Save trigger on the setup menu.  
(page 22)
Click this button to manually record images on the
SD memory card.  Refer to page 10 for descriptions
of how to manually record images on the SD memo-
ry card. 
iZOOM buttons (*2)
:Click this button to adjust the zoom ratio
to the WIDE side. 
:Click this button to adjust the zoom ratio
to the TELE side. 
oFocus buttons (*2)
:Click this button to...

7
In this case, the camera will not move when the
thumbnail image is clicked. (For example, when pre-
set position 3 is unregistered, the thumbnail image
of preset position 2 will be displayed as the thumb-
nail image of preset position 3. The camera will not
move when the thumbnail image of preset position 3
is clicked.)
• The camera will not always returns to the exactly
same position where it was before 360° map-shot
or Preset map-shot was carried out. (It may some-
times be slightly different.)
• The...

8
!9Audio output button (*3)
Turns on/off the audio transmission (play audio from
the PC on the camera speaker). This button will be
displayed only when Audio output or Interactive is
selected for Audio mode on the setup menu. 
(page 40)
The button blinks while the audio transmission is
being carried out.
When this button is clicked, the button will turn into
the  button and audio from the PC will not be
heard.
Audio volume can be adjusted (Low/Middle/High) by
moving the volume cursor  .
Notes:
• When a...

9
Monitor images from multiple cameras
Images from multiple cameras can be displayed on a multi-screen. Images from 4 cameras (up to 16 cameras) can
be displayed simultaneously. To display images on a multi-screen, it is necessary to register cameras in advance. 4
cameras can be registered as a group and up to 4 groups (16 cameras) can be registered. (page 42)
Important:
• When simultaneously displaying images from 16 cameras on a multi-screen, panning, tilting and zooming are
unavailable.
• Only JPEG...

10
Record images on the SD memory card manually
Images displayed on the Live page can be recorded on the SD memory card manually.
This button is operable only when Manual is selected for Save trigger on the setup menu. (page 22)
Images recorded on the SD memory card can be copied onto the PC. (page 24)
Step 1
Display the Live page. (page 4)
Step 2
Click the [SD] button in the SD memory card box.
→The SD recording window will open.
Step 3
Click the [START] button to start recording images on
the SD...