Panasonic Multi-Function Printer Kx Mb2060 Kx Mb2061 Operating Instructions

1.6.2 Base unit rear view
Recording paper guides
LED
LAN interface connector
R 10Base-T/100Base-TX
Power inlet
Manual input tray (Rear cover)
Telephone line jack
USB interface connector
1.6.3 Cordless handset (KX-MB2060
optional)
Charge indicator
Ringer indicator
Message indicator
Nonslip pad
Speaker
Headset jack
Receiver
Microphone
Charge contacts
For assistance, please visit http://www.panasonic.com/help111. Introduction and InstallationB A
EF DG
C        A
D C BE
F
G         

1.7 Toner cartridge and drum
cartridge
The supplied toner cartridge is a starter toner cartridge.
Caution:
R Read the following instructions before you begin
installation. After you have read them, open the
drum cartridge protective bag. The drum
cartridge contains a photosensitive drum.
Exposing it to light may damage the drum. Once
you have opened the protective bag:
– Do not expose the drum cartridge to light for
more than 5 minutes.
– Do not touch or scratch the black drum
surface inside of the drum...

6Open the top cover ( H) by holding the indentations
( I ) on both sides of the base unit.
Note:
R Do not touch the transfer roller ( J).
R If the lower glass ( K) is dirty, clean it with a soft
and dry cloth.
7 Install the drum and toner cartridge ( L) by holding
the tabs.
R Make sure that the arrows ( M) match, to install
the drum and toner cartridge correctly.
For assistance, please visit http://www.panasonic.com/help131. Introduction and InstallationHJ
I
I K L M  

8Close the top cover by holding the indentations on
both sides of the base unit, until locked.
Caution:
R To prevent injuries, be careful not to put your
hands under the top cover.
When to replace the toner and drum cartridges
When the display shows the following, replace the toner
cartridge.
– “TONER LOW ”
– “TONER EMPTY ”
Note:
R To check the drum life and quality, please print the
printer test list (page 137) and refer to page 140 for
information on the drum life. If printing quality is still
poor or...

1.8 Output tray
Insert the output tray ( A) until it clicks into place, and
then press the center part ( B) of the extender to open it.
Note:
R Do not place the base unit in an area where the output
tray may be easily bumped into.
R The output tray can hold up to approximately 100
sheets of printed paper (the number of sheets may
vary depending on the usage environment). Remove
the printed paper before the output tray becomes full.
If the top part of the extender is detached
1. With the top part of the...

1.9 Recording paper
The paper input tray unit can hold:
– Up to 250 sheets of 64 g/m 2
 to 75 g/m 2
 (17 lb to
20 lb) paper.
– Up to 230 sheets of 80 g/m 2
 (21 lb) paper.
– Up to 200 sheets of 90 g/m 2
 (24 lb) paper.
R A4, letter, B5 and 16K-size paper can be used. B5
and 16K -size paper can only be used when using the
unit for printing or copying.
R Please refer to page  138 for information on recording
paper.
R The unit is set for printing letter-size plain paper
by default.
– To use other paper...

3Load the paper, print-side up ( B).
Important:
R Push down to lock the plate ( C) in the paper
input tray, if necessary.
4 Adjust the recording paper guides. Pinch the front
side of the recording paper guide ( D), then slide it to
match the paper size mark. Pinch the right side of the
recording paper guide ( E), then slide it to adjust the
width to the size of the recording paper.
R Make sure that the recording paper is under the
paper limit mark ( F), and the paper should not
be loaded over the...

1.9.1 Manual input tray
You can use the manual input tray for printing with the
computer and for copying. It can hold one page at a time.
When printing or copying multiple pages, add the next
page after the first page has been fed into the base unit.
R Please refer to page  138 for information on recording
paper.
R The unit is set for printing letter-size plain paper
by default.
– To use other paper sizes, change the
recording paper size setting (feature #381 on
page 81).
– To use thin paper, change the...

3Insert the tab ( C) and rib ( D).
Caution:
R When moving the base unit, be sure to hold by
the grip. Do not hold by the handset unit.
CorrectIncorrect
Note:
R While talking to the other party, you can send a fax
using the scanner glass by pressing  MStart N, and
then  M1 N (To receive a fax, press  M2 N).
To remove the handset unit
1. Pull the handset unit slightly forward ( A), then lift it
in the direction of the arrow ( B) to remove the rib.
2. Remove the tab ( C), then disconnect the handset...

1Press the notch on the cordless handset cover firmly,
and slide the cover.
R When replacing batteries, remove the old
batteries positive (
) terminal first.
2 Insert the batteries negative () terminal first. Close
the cordless handset cover.
Attention:
A nickel metal hydride battery that is recyclable powers
the product you have purchased.
Please call 1-800-8-BATTERY (1-800-822-8837) for
information on how to recycle this battery.
1.12 Belt clip (KX-MB2060
optional)
To attach
To remove
20For assistance,...