Panasonic Kx Tg2700 Operating Instructions Manual

61
Advanced Operation
For assistance, please call: 1-800-211-PANA(7262)
Incoming Call Tone
During an intercom call or while using the Room Monitor feature (p. 51),
you can be informed by two tones if a call arrives. If you set to ON, this
incoming call tone will be heard for as long as the line rings. To delete the
incoming call tone, set to OFF. To set the incoming call tone to sound
twice, set to “2”. Both the handset and base unit are preset to “2”.
Handset incoming call tone
Make sure the handset is...

Wall Mounting
This unit can be mounted on a wall phone plate.
1
Connect the AC adaptor.
2
Tuck the telephone line cord inside the wall mounting adaptor (#).
Connect the telephone line cord ($). Fasten the telephone line cord
to prevent it from being disconnected (%).
To Power
Outlet
3
Insert Aand Bhooks on
the wall mounting adaptor
into the holes on the base
unit.
Hooks
$ #%%
Bottom of the unit
C
AB
AB
C
62 

63
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
6
Connect the telephone line cord.
Mount the unit, then slide down.
•Raise the antennas.
7
To charge the handset battery:
Place the handset on the base unit.
•The CHARGE indicator lights.
5
While keeping the adaptor held
to the base unit, slide the wall 
mounting adaptor to 
the left until it clicks 
into place.
4
Adjust the adaptor to hold the
base unit, aligning the arrow
Con the base unit with the
adaptor.
C
Arrow C
C
Bottom of...

To remove the wall mounting adaptor
Push up the RELEASE LEVER with your thumb (#) and slide the adaptor
to the right ($) with the tab kept up to release the lock. Remove the
adaptor.
Standard Telephone
Single-Line
Telephone Jack
T-Adaptor (KX-J66)Telephone
Line Cord
Adding Another Phone
This unit will not function during a power failure. To connect a standard
telephone on the same line, use the Panasonic T-adaptor KX-J66.
To order, call the accessories telephone number on page 2.
64
Wall Mounting
RELEASE...

65
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
Optional Headset
H
Plugging the optional headset into the handset allows a hands-free phone
conversation. Please use only the Panasonic KX-TCA88 headset. To
order, call the accessories telephone number on page 2.
Connecting the optional headset to the handset
Open the headset jack cover, and connect the optional headset to the
headset jack as shown below.
To switch to the speakerphone while using the headset:
Press  . To return to...

66
Battery Replacement
A nickel cadmium battery that is recyclable powers the
product you have purchased. At the end of its useful life,
under various state and local laws, it is illegal to dispose of
this battery into your municipal waste stream. Please call 
1-800-8-BATTERY for information on how to recycle this
battery. Battery will need to be replaced, even if you cleaned the charge contacts
and charged the battery fully, but after a few telephone calls, “Recharge
battery” is displayed and/or “ ”...

67
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
Canceling Registration/Re -registration
Canceling the Handset Registration
If you no longer need to use the handset or if you need to register the
handset to a different base unit of the same model, it may be necessary to
cancel the registration. Only one handset can be canceled at a time near
the base unit.
Make sure the base unit and the handsets are not being used.
1
Press (CONF/FUNCTION).
2
Scroll to “Initial setting” by...

68
Re-registering the Handset
If you want to re-register the handset to the base unit or a different base unit
of the same model, you need to register it to that base unit. The handset will
be given a new extension number of that base unit. Only one handset can
be registered at a time. Make sure the base unit and the other handsets
are not being used. 
Registration must be completed within 1 minute.
1
Handset:Press (CONF/FUNCTION). 
2
Scroll to “Initial setting” by pressing
Öor Ñ, and press á.
3
Scroll...

69
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
If the Following Appear...
If the unit detects a problem, one of the following messages will be
displayed on the handset. Error beeps or a busy tone will sound.
Display messageCause & Remedy
The battery needs to be charged. Recharge the
battery (p. 13).
The battery has been discharged. The handset
will not work. Charge the battery fully (p. 13).
The handset has lost communication with the
base unit. Walk closer to the base unit, and...

If the Following Appear...
70
Display messageCause & Remedy
When trying to store an item in the directory, the
directory memory is full. To erase other items from
the directory, see page 41.
• When the displayed item is being sent to the
destination handset, the directory memory is
full. The transfer is stopped. If you tried to send
all of the items, the item displayed with 
“---Incomplete---” and items after it have
not been transferred to the destination handset.
You can press
(OFF)to exit the mode (p....