Panasonic Kx Tg2700 Operating Instructions Manual

21
Preparation
For assistance, please call: 1-800-211-PANA(7262)
Registration for Additional Handsets
The included handset is pre-registered at the factory and assigned
the extension number 1. You do not need to register this handset
which has “[1]” on the display.
If you purchase optional handsets, you must register each of them at the
base unit. Only one handset can be registered at a time. A handset will be
assigned the extension number at registration.
The model numbers of the optional handsets are...

Registration for Additional Handsets
22
Making Calls
1
Press .
•“Talk” is displayed.
2
Dial a phone number.
•The dialed number is displayed.
•After a few seconds, the display will show the
length of the call.
3
To hang up, press (OFF)or place the 
handset on the base unit.
•To use “ ” and “ ” features using the soft 
key (p. 9), see pages 50 and 58.
•To use the Reception Booster feature, see page 24.MUTEPRIVACY
Back side
Speaker 
(OFF)
(PAUSE/REDIAL) Display Receiver
     ,     ,     , 
Microphone...

23
Basic Operation
For assistance, please call: 1-800-211-PANA(7262)
Hands-free Digital Duplex Speakerphone
For best performance, please note the following:
•Talk alternately with the caller in a quiet room.
•If the other party has difficulty hearing you, press Öto decrease the speaker
volume.
•If the other party’s voice from the speaker cuts in/out during a conversation,
press Öto decrease the speaker volume.
•While talking using  , you can switch to the hands-free phone conversation
by pressing  . To...

Making Calls
24Reception Booster feature
The feature allows the handset to improve the
sound quality when using in an area with
interference.
Press 
Üin the talk or speakerphone mode.
•“Booster on” will flash on the display.
•To turn the feature off, press Üor á.
•The feature will be off after hanging up or when
putting a call on hold or making a conference.
•The battery operating time will be shortened using
this feature (p. 13).
Talk
00-00-05
I=BoosterI=Booster
Talk
00-00-10
I=Booster onI=Booster on
Ex....

25
Basic Operation
For assistance, please call: 1-800-211-PANA(7262)
SPPRIVACY[1]
Hold
IN USE
To put a call on hold
Press (HOLD/CLEAR)twice.
•“” flashes on the display, “Hold” is displayed
and the call is put on hold.
•To transfer the call to the base unit or another
handset (if the system has one or more additional
handsets, p. 21), see page 47.
•If a call is kept holding for 6 minutes, an alarm tone will start to sound. After 4
additional minutes on hold the call will be disconnected.
To release the...

26
1
Press (DIGITAL!SP-PHONE).
•The DIGITAL SP-PHONE indicator and the IN USE indicator light.
2
Dial a phone number.
3
When the other party answers, talk into the MIC (microphone).
4
To hang up, press (DIGITAL!SP-PHONE).
•The indicator lights go out.
•To switch to the handset while using the base unit speakerphone:
– If the handset is off the base unit, press  or  on the handset, then
press (DIGITAL!SP-PHONE)on the base unit.
– If on the base unit, just lift up.
•To use (PRIVACY)and (MUTE)features, see...

27
Basic Operation
For assistance, please call: 1-800-211-PANA(7262)
To adjust the speaker volume (8 levels) while talking
To increase, press Ñ.
To decrease, press 
Ö.
To redial the last number dialed on the base unit
Press (DIGITAL!SP-PHONE)and press (REDIAL/PAUSE).
To put a call on hold
Press (HOLD).
•The DIGITAL SP-PHONE indicator and IN USE indicator lights start to flash.
•If a call is kept holding for 6 minutes, an alarm tone will start to sound. After 4
additional minutes on hold the call will be...

28
Answering Calls
When a call is received, the unit rings and “Incoming call” is displayed
on the handset and the IN USE indicator flashes quickly on the base unit. 
If you subscribe to a Caller ID service, the calling party information will be
displayed after the first ring (p. 29). In order to view the Caller ID
information, please wait until the second ring to answer a call.
Handset
1
Press .
•You can also answer a call by pressing any dialing
button (0)to (9), (*)or (#)(Any Key Talk).
OR
Press  , and...

29
Basic Operation
For assistance, please call: 1-800-211-PANA(7262)
Caller ID Service
This unit is compatible with a Caller ID service offered by your telephone
company. If you subscribe to a Caller ID service, the calling party’s
information will be shown on the handset after the first ring.
The handset can record information of up to 50 different callers, including
the time and date received and the number of times called, in the Caller
List. The Caller List information is sorted by the most recent to...

30
1
Press Öor Ñto enter the Caller List.
•The display will show, for example, the
following.
2
To search from the most recent call, 
press 
Ö.
To search from the oldest call, press Ñ.
•To scroll between callers, press Öor Ñ.
3
To exit the list, press (OFF).
Using the Caller List
•If “No items stored” is displayed, the Caller List is empty.
•
If there is no name information for a caller, the display will only show the phone number.
•After viewing all of the new call entries in the Caller List, “Received...