Panasonic Kx Tg2382 Operating Instructions Manual

51
Answering System
For assistance, please call: 1-800-211-PANA(7262)
To stop
operation Press (STOP).
•
To resume playback, press the  (MESSA\fE\bPLAYBACK).
• If you do not press any button for 60 seconds or if you press 
(STOP) again, the playback mode will be canceled.
Press (REPEAT).
•If you press within 5 seconds of playback, the previous
message will be played.
Press (SKIP).
During playback
To  repeat
message
To  skip
message
Erasing Messages
The unit will announce the remaining recording time after...

52
Voice menu
If no commands are entered after doing steps 1 and 2, or if no commands 
are entered after you heard new or all messages and “End of final 
message”,
the following voice menu will be heard through the handset.
“ Press 4 to play back new messages. Press 5 to play back all messages. ”
•You can enter direct commands even if the voice menu has started.
Remote Operation with the Handset
You can access the Answering System
from your handset and listen to
messages. 
If new messages have been...

53
Answering System
For assistance, please call: 1-800-211-PANA(7262)For assistance, please call: 1-800-211-PANA(7262)
•
The unit will announce the remaining recording time after playback, if i\
t is less 
than 5 minutes.
• If a call is being received during the remote operation, you will hear i\
ncoming
call tones (p. 48). To answer the call, press  or  .
• If you hear “ Memory full” after playback, erase some, or all, of the messages
(see below).
Direct commands
NEW MESSAGE PLAYBACK 
• Only new...

54
Remote Operation from a Touch Tone Phone
You can operate the Answering 
System from any touch tone phone.
A synthesized voice menu will guide
you on how to operate the unit
(p. 56).
•To skip the voice menu and operate the 
unit directly, see page 57.
• The unit will announce the remaining recording time after playback, if i\
t is less
than 5 minutes.
* If “ No new messages ” is heard, the Answering System has only old messages. 
If “ No messages ” is heard, the Answering System has no messages....

55
Answering System
For assistance, please call: 1-800-211-PANA(7262)
Remote Code
The remote code prevents unauthorized people from accessing your unit 
and listening to your messages. Choose any 2-digit number (00–99). 
The factory preset remote code is “ 11”. If you do not program your own
remote code, you can use “11”.  
Make sure the unit is not being used and the handset is lifted off the 
base unit.
1
Press (MUTE/FUNCTION).
2
Scroll to “ Initial set ” by pressing 
Öor Ñ, and press á.
3
Scroll to...

56
Remote Operation from a Touch Tone Phone
All message playback.
All recorded messages are played 
back. At the end of the last
message, “End of final message ” is
heard. The unit will announce the
remaining recording time if it is
less than 5 minutes.
• 3 seconds after playback, the voice menu will start again from the begin\
ning.
• If you hear “ Memory full” after playback, erase some, or all, of the messages
(p. 57).
Voice Menu
The shaded parts are voice prompts.
Press 1 to play back 
all messages....

57
Answering System
For assistance, please call: 1-800-211-PANA(7262)
Direct Remote Operation
Once you have entered the remote code, you can also control your unit by\
 
direct commands instead of using the voice menu. To end the remote
operation, hang up anytime.
Direct commands
NEW MESSAGE PLAYBACK 
•Only new messages are
played back.
ALL MESSAGE PLAYBACK
• All messages are played back.
REPEAT (During playback)
• The current message is
repeated.
• If you press within 5 seconds
of playback, the...

Wall Mounting
58
This unit can be mounted on a wall phone plate.
2
Press the tabs in the direction 
of the arrows (#), then remove
the wall mounting adaptor ( $).
3
Connect the AC adaptor. Tuck
the telephone line cord inside
the wall mounting adaptor, then
push it in the direction of the
arrow ( #and  $).
•The word “UP WALL” should face 
upward.
1
Push the hook and turn it around. 
Turn the hook until a click is heard.
2
11
Base unit
12
2
To Power 
Outlet 

59
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
4
Connect the telephone line cord. 
Mount the unit, then slide down.
•Raise the antenna.
5
To charge the handset battery:
Fix the charge contacts ( #) and insert
the hook to the handset hole ( $).
•The CHARGE indicator lights.
2
1
Hook
Hole
OR
Hooks 

$
#%
60
This unit will not function during a power failure. To connect a standar\
d 
telephone on the same line, use the Panasonic T-adaptor KX-J66.
To order, call the accessories telephone number on page 2.
Standard Telephone 
Single-Line 
Telephone Jack
T-Adaptor (KX-J66) Telephone
Line Cord
Adding Another Phone
Wall Mounting
Wall Template
2.45 cm
(15⁄16)
Charger unit
2.45 cm (15⁄16)
Screws 
To Power 
Outlet
The charger can be wall mounted. Connect the AC adaptor. Install screws 
using the wall...