Panasonic Kx Tg2357 Operating Instructions Manual

Answering System
For assistance, please call: 1-800-211-PANA(7262)61
Recording a Memo Message
You can record a voice memo message of up to 3 minutes in memory.  
• If you record for over 3 minutes in step 2, the unit will stop recording.
• If “ ” is displayed, 6 beeps sound and “Your message was not recorded. Record your 
message again.” is announced, start again from step 1.
1Press [MEMO].
2After the long beep, talk clearly 20 cm 
(8 inches) away from the MIC.
• The base unit display shows the elapsed...

62
Remote Operation from a Touch Tone Phone
While outside, you can operate the Answering System from any touch tone phone. 
A synthesized voice menu will guide you through the Answering System (p. 64).
• To skip the voice menu and operate the unit directly, see page 65.
Summary of remote operation
• The unit will announce the remaining recording time after playback if it is less than 
3 minutes.
• The messages are saved.
* If “No new messages” is announced, the unit has only old messages.
If “No...

For assistance, please call: 1-800-211-PANA(7262)63
Remote Operation from a Touch Tone Phone
Answering System
Remote Code 
The remote code prevents unauthorized people from accessing your unit and 
listening to your messages. Choose any 2-digit number (00–99) for your remote 
code. The factory preset remote code is “11”. If you do not program your own 
remote code, you can use “11”.
To confirm the remote code, repeat steps 1 to 4.
• The remote code is displayed. When finished, press [OFF].
1Press...

Remote Operation from a Touch Tone Phone
64
Vo i c e  M e n u
The shaded parts are voice prompts.
• 3 seconds after playback, the voice menu will start again from the beginning.
• The unit will announce the remaining recording time after playback if it is less than 
3 minutes.
• If you hear “Memory full” after playback, erase unnecessary messages (p. 65).
• If you do not press any buttons within 10 seconds after a voice prompt, “Thank you 
for your call.” will be heard and the call will be disconnected....

Remote Operation from a Touch Tone Phone
Answering System
For assistance, please call: 1-800-211-PANA(7262)65
Direct Remote Operation
Once you have entered the remote code, you can also control your unit by direct 
commands instead of using the voice menu. To end remote operation, hang up at 
anytime.
Direct commands
To turn on the Answering System:
Call your unit and wait for 15 rings.
• The unit will answer and the greeting will be played.
• The Answering System will be turned on. Hang up or enter the...

66
Belt Clip
You can hang the handset on your belt or pocket using the included belt clip.
To attach the belt clip To remove the belt clip  
Optional Headset
Connecting an optional headset to the handset allows hands-free phone 
conversation. Please use only a Panasonic KX-TCA60, KX-TCA86, KX-TCA88, 
KX-TCA88HA, KX-TCA91, KX-TCA92, or KX-TCA98 headset. To order, call the 
accessories telephone number on page 2.
Connecting an optional headset
Open the headset jack cover, and insert the headset plug into...

Useful Information
For assistance, please call: 1-800-211-PANA(7262)67
Wall Mounting
This unit can be mounted on a wall phone plate.
Base unit
1
Push the hook and turn it 
upward. Turn the hook until a 
click is heard.
2Press the tabs in the direction 
of the arrows (1), then remove 
the wall mounting adaptor (2).  
 3Connect the AC adaptor. Tuck 
the telephone line cord inside 
the wall mounting adaptor, then 
push the adaptor in the direction 
of the arrows (1 and 2).
• The word “UP WALL” should face...

Wall Mounting
68
Charger unit
The charger can be wall mounted. Connect the AC adaptor. Install screws using the 
wall template (see below). Mount the charger (
1). Slide it down (2), then slide it 
down to the right (
3) until it is secured.
Wall Template for the Charger unit
2
3
1
To  P o w e r  
Outlet  Screws 2.45 cm
(
31/32)
2.45 cm
(31/32)
PQQX13991YA.book  68 ページ  ２００４年２月２５日　水曜日　午前１１時１２分 

Useful Information
For assistance, please call: 1-800-211-PANA(7262)69
Direct Commands
After pressing [MENU], you can also program menu items directly by pressing ([0] 
to [9], [*] and [#]) instead of using the soft keys.
Menu item Command Selection items Page
Ringer volume[1] [1]  [0] : Off  [1] : Low  [2] : Medium   
[3] : Highp. 17
Ringer tone 
(for handset)[1] [2] [1]–[3] : Tone pattern 1–3 
[4]–[7] : Melody pattern 1–4
[8]–[9] : Downloaded melody 
pattern 1–2 *
1
p. 18
Incoming call tone 
(for...

Direct Commands
70
During programming:
When “Save” is displayed, press the right soft key to save the new settings.
To exit programming, press [OFF].
• If you press the direct command incorrectly, press [OFF], then re-enter 
programming mode by pressing [MENU].
• For function details, see the corresponding pages.
*
1You need to first download melody data from the openLCR web site.
*2Can be used to activate Caller IQ. See the leaflet included with this unit for more 
information.
*
3For openLCR...