Panasonic Kx-Td500 Features Guide

AFeatures Guide
12 Features Guide
Automatic Route Selection (ARS)
DescriptionAutomatic Route Selection (ARS) is a system programmable fea-
ture that automatically selects the least expensive route available at
the time an outgoing outside call is made.  ARS applies to an out-
going CO call made by dialing the feature number for Local
Access/ARS (9 = default).  Pre-programming eliminates the need
of dialing the access code of the least expensive carrier.
The appropriate Trunk Group is selected and the...

Features GuideA
Features Guide 13
Step 3.Check all carriers available to call the stored telephone number
and their Trunk Groups. Supposing that there are three carriers available
to call the XYZ Company and each carrierÕs line is assigned to a Trunk
Group as follows:    
Carrier E Ñ Trunk Group 1    
Carrier F Ñ Trunk Group 2    
Carrier G Ñ Trunk Group 3
Then check the fee charged by each carrier:
As shown in Table 2, the least costly route varies with the day of the
week and the time of day.  To...

AFeatures Guide
14 Features Guide
To program the time zones listed on the previous page, use the program
Section 4.7.1 ÒARS - ARS Time TableÓ  In this table, up to four time
zones (Time-A, Time-B, Time-C, Time-D) can be programmed.  Enter
the starting hour for each zone.
Step 4.Determine the priority of the Trunk Groups in each time zone.  
The table below shows the carriers and Trunk Groups selected for each
priority and time zone:
Assign the above Routing Plan (Table 4) to Section 4.7.3 ÒARS -
Routing...

Features GuideA
Features Guide 15
Step 5.Create a Digit Modification Table.  Carriers E, F and G match
the Trunk Groups and Modification Tables as follows and have the fol-
lowing Access  Code:
According to Table 6, enter the Access Codes in the respective
Modification Tables as follows:
If Modification Table 1 is applied, the user-dialed number Ò9-1-234-567-
8910Ó is modified to Ò9-10333-1-234-567-8910Ó to access the least
expensive Carrier E. 
Similarly, if Modification Table 2 is applied, it is...

AFeatures Guide
16 Features Guide
A long distance call is initiated.
Toll Restriction CheckCall is not made.
Is ARS Access Code (Default: 9) dialed?
Are the leading digits found in an
ARS Leading Digit Table?Call is routed via selected line.
(ARS Override)
Obtains applicable Route Plan Table 
number from the ARS Leading Digit Table.Call is routed via an idle line.
Determines the Trunk Group of priority 1 in the ARS
Routing Plan Table by the current time of day.
Obtains applicable Modification
Table...

Features GuideA
Features Guide 17
Automatic Station Release
DescriptionIf the extension user fails to dial any digits within a specified time
period after going off-hook, the user will be disconnected from the
line after reorder tone is sent.  To get a line again, the user must go
on-hook first and then go off-hook.
Conditions¥  This function works in the following cases: 
When making a call
(1)The first digit has not been dialed within 10 seconds.
(2)After a digit is dialed, the next one is not dialed...

BFeatures Guide
18 Features Guide
Background Music (BGM) 
DescriptionAllows the PT user in on-hook status to listen to Background
music (BGM) from the built-in speaker of his/her PT.
Conditions¥Hardware Requirements
A user-supplied external music source, such as a radio, is required to
utilize this feature. Up to two music sources can be connected to the
system.  
¥Tenant Service
If ÒTenant ServiceÓ is utilized, a music source for BGM is determined
by System Programming on a tenant basis.
¥Turning...

Features GuideB
Features Guide 19
Background Music (BGM) Ð External 
DescriptionBackground Music (BGM) can be broadcast throughout the office
via the external pagers.  The BGM through External Pagers can be
turned on/off by the Manager and the Operators.
Conditions¥ Hardware Requirements
It is required to connect a user-supplied external pager. Up to two
pagers and up to two external music sources can be installed in the sys-
tem.
¥ To make BGM-External possible, you must enable BGM and select a
music...

BFeatures Guide
20 Features Guide
Bilingual Display 
DescriptionProvides the display PT user with either an English or French dis-
play.  Either display can be selected by Station or System
Programming.
ConditionsNone
Programming References
System Programming................................Installation Manual, Section 4
4.4.2  Line - Extension Line
Ñ Language
Station Programming..........................................User Manual, Section 2
Bilingual Display Selection
Feature ReferencesNone 
Operation...

Features GuideB
Features Guide 21
Busy Lamp Field 
DescriptionThe LED (Light Emitting Diode) indicators of the DSS (Direct
Station Selection) buttons, each of which corresponds to a selected
extension, display whether the corresponding extensions are idle or
busy.
Conditions ¥DSS Button Assignment
This function is available for DSS buttons on DSS Consoles and for 
flexible CO buttons assigned as DSS buttons on PTs.
¥Log-in/Log-out
DSS buttons reflect the Log-in/Log-out status of the extensions in the...