Panasonic Digital Business System 576 Technical Manual Section 300

Section 300-Installation Chapter 5 - Trunks and Extensions
576-13-300 DBS 576 (USA), issued 6/2/98  5-47
Figure 5-18. Connection of S-point ISDN Primary Rate Interface (PRI) 

Chapter 5 - Trunks and Extensions Section 300-Installation
5-48 DBS 576 (USA), issued 6/2/98 576-13-300
Key Phone Wall Mounting
Guidelines
• DBS 576 key phones can be mounted on the wall using the wall mounting adapter 
on the bottom of the phone.
Installation
1.  Remove the wall mounting adapter from the bottom of the phone taking care not 
to damage the adapter hooks.
2.  Rotate the wall mounting adapter by 180 degrees, then slot it into the two 
guides.
3.  Remove the handset guide, rotate it by 180...

Section 300-Installation Chapter 5 - Trunks and Extensions
576-13-300 DBS 576 (USA), issued 6/2/98  5-49
Figure 5-19. Wall mounting of phone 

Chapter 5 - Trunks and Extensions Section 300-Installation
5-50 DBS 576 (USA), issued 6/2/98 576-13-300 

576-13-300 DBS 576 (USA), issued 6/2/98  6-1
Chapter 6. Peripheral Equipment
This chapter describes how to install and connect DSS, doorphone adaptors, other 
peripheral equipment, and replacing the backup battery of CPC card.
Music-On-Hold (MOH)
Guidelines
• A music source such as a CD player or tape recorder can be connected to the 
MOH input of a CPC96, CPC288, or CPC576 card installed in the CPC slots of 
the cabinet to provide music-on-hold (MOH).
• CPC96, CPC288, and CPC576 cards cannot be...

Chapter 6. Peripheral Equipment Section 300-Installation
6-2 DBS 576 (USA), issued 6/2/98 576-13-300
Figure 6-1. Installation of music-on-hold source
Background Music (BGM)
Guidelines
• A music source such as a CD player or tape recorder can be connected to the 
BGM input (RCA) of an SCC card installed in one of the optional card slots of the 
cabinet to provide background music (BGM).
• SCC cards cannot be installed and removed while the cabinet is operating. First, 
turn the power off.
• If an FM radio...

Section 300-Installation Chapter 6. Peripheral Equipment
576-13-300 DBS 576 (USA), issued 6/2/98 6-3 
Installation
1.  Install the SCC card in an available optional card slot.
2.  Connect one end of an RCA pin cable (2-core shielded cable) to the CN4 (RCA) 
connector on the SCC card.
3.  Connect the other end of the RCA pin cable to the output (AUX) of a music 
source such as a CD player or tape recorder.
Fit the appropriate connector (RCA or mini-plug, etc.) as required to the 
end of the RCA pin cable...

Chapter 6. Peripheral Equipment Section 300-Installation
6-4 DBS 576 (USA), issued 6/2/98 576-13-300
Paging
Guidelines
• Paging can be performed by connecting a paging amplifier, relays, and speakers 
to an SCC card installed in one of the optional card slots.
• SCC cards cannot be installed and removed while the cabinet is operating. First, 
turn the power off.
• The paging amplifier, relays, and speakers are not provided with the DBS 576 and 
must therefore be purchased separately.
• Table 6-1 shows...

Section 300-Installation Chapter 6. Peripheral Equipment
576-13-300 DBS 576 (USA), issued 6/2/98 6-5 
Installation
1.  Set SW2 on the SCC card to match the input impedance of the connected device. 
See Table 6-2 for SW2 settings.
Table 6-2.  Settings of SW2 on SCC card
2.  Install the SCC card in an available optional card slot.
3.  Prepare a cable with a DDK connector and connect one end of it to CN3.
4.  Connect the other end of the cable to the paging amplifier, relays, and speakers.
Switch No....

Chapter 6. Peripheral Equipment Section 300-Installation
6-6 DBS 576 (USA), issued 6/2/98 576-13-300
Figure 6-3. Connection of paging device