Panasonic Cz Rtc4cz Rtc3 Operating Instructions Manual

21(EN)
  If [Sleeping] button does not work.
Or, in the case of operation not being started even if [SET] is pressed.
Check the following table.
ItemDisplay of the remote control unit
(Lighting/fl ashing indication)Contents
1
 The Error indication fl ashes 
(for several seconds).The clock is not set.
2
 “This function is not available” indication 
lights up (for several seconds).When the operation mode is set to AUTO or 
FAN, this function is not available.
3
 Centralized control indication fl ashes 
(for...

22(EN)
ECONAVI Function
This function is available by attaching an optional ECONAVI sensor.
The ECONAVI sensor detects human activity and conserves energy based on the 
activity level. 
Overview of the ECONAVI function
High activity• Cooling:  Target temperature is the same as the set temperature.
• Heating:  Target temperature is 1 °C lower than the set 
temperature.
Low activity• Cooling:  Target temperature is 1 °C higher than the set 
temperature.
• Heating:  Target temperature is the same as the set...

23(EN)
ECONAVI Function
Using the remote controller, you can switch the ECONAVI function ON/OFF.
1
Press [ECONAVI] to ON the 
ECONAVI function.
* When ECONAVI is enabled,  
will appear.

1 / 2
2
Press [ECONAVI] to OFF.
* When the indoor unit is stopped,  will disappear.
ON/OFF setting of ECONAVI function
Note
  Turn the ECONAVI function OFF if:
-  You want to maintain the room temperature at a set temperature.
-  You want to keep air conditioner running while nobody is in a room.
-  The sensor fails.
-...

24(EN)
Blackout?
  After recovery from blackout, press 
[Start/Stop] again.
  àIf operation does not start, turn off the circuit 
breaker and consult the dealer of purchase 
about the symptom and Model No.
Is the circuit breaker 
turned off?   Turn it on and press [Start/Stop] again.   àIf operation does not start, turn off the circuit 
breaker and consult the dealer of purchase 
about the symptom and Model No.
Is  blinking? 
  After blinking stops, press [Start/Stop] 
again.
  àIf operation does...

25(EN)
The remote 
controller screen 
displays a fl ashing 
“ 
 ”.
  Faulty sensor or incorrect installation. Turn OFF the ECONAVI function with the 
remote controller and contact the retailer or 
point of purchase with the Model No. and 
problem.
The remote 
controller screen 
does not display the 
 
.
  The indoor unit has stopped. Turn on the 
indoor unit.
  The unit is in Fan mode. The ECONAVI 
function does not operate in Fan mode.
  The ECONAVI function is set to OFF. Turn 
the ECONAVI function...

26(EN)
Specifi cations
Model No. CZ-RTC4
Dimensions (H) 120 mm x (W) 120 mm x (D) 20 + 4.75 mm
Weight 160 g
Temperature/
Humidity range 0 ˚C to 40 ˚C / 20 % to 80 % (no condensation)
*Indoor use only.
Power Source DC16 V (supplied with indoor unit)
Clock Precision
± 30 seconds/month (at normal temperature 25 
˚C) 
*Adjust periodically.
Holding 
time 24 hours (when fully charged)
*Approx. 8 hours are required for full charge.
Number of 
connected indoor 
units Up to 8 units
© Panasonic Corporation 2015 

Panasonic Corporation
1006 Kadoma, Kadoma City, Osaka, Japan
Operating Instructions
High-spec Wired Remote Controller
Model No. CZ-RTC3
Installation Instructions
Separately Attached.
ENGLISHBefore operating the unit, read these operating instructions thoroughly \
and keep them for future 
reference.
CV6233312187
WEB-URL Panasonic Corporation  
 Website:http://panasonic.net/ 

2(EN)
Part Names Control panel
Note
LCD screen   Return button
Returns to the previous screen.Menu buttonDisplays the menu 
screen (P. 10).
Operation indicatorIlluminates during operation.
Blinks during alarm. 
Start/Stop buttonStarts/Stops operation.
Enter buttonFixes the selected content.
Press centre No glove No pen
Energy saving 
button
Switches Energy 
saving/Normal 
operation.
Cross key buttonsSelects an item.Up
DownRight Left 

3(EN)
Safety Precautions
CAUTIONS
This appliance is intended to be used by expert or 
trained users in shops, in light industry and on farms, or 
for commercial use by lay persons.
This appliance can be used by children aged from 8 
years and above and persons with reduced physical, 
sensory or mental capabilities or lack of experience 
and knowledge if they have been given supervision or 
instruction concerning use of the appliance in a safe 
way and understand the hazards involved.
WARNING
Do not use...

4(EN)
Note:
  This device complies with Part 15 of the FCC Rules. 
Operation is subject to the following two conditions: (1) This 
device may not cause harmful interference, and (2) this 
device must accept any interference received, including 
interference that may cause undesired operation.
  This equipment has been tested and found to comply with 
the limits for a Class B digital device, pursuant to Part 15 
of the FCC Rules. These limits are designed to provide 
reasonable protection against...