Panasonic Central Processing Unit Wj Mpu955a Operating Instructions

81
System Status Table
The table shows the system status in real time.
1. Select a desired monitor. (Refer to p. 56 Monitor
Selection.)
2. Display SysStat menu. (Refer to Step 1 and 2 of p. 77
To Recall Menu Functions.)
3. Select a desired function by pressing one of the F1 to
F3 buttons. 
Available buttons and functions
F1: On
Opens the SYSTEM STATUS table.
F2: Off
Closes the SYSTEM STATUS table.
F3: Blk
Changes the monitor background beween camera
images and black picture.
MON:Monitor number
AREA:Area...

82
4. To display the next page, press the + button.
To display the previous page, press the – button.
Notes: 
•To display the first page of table, press the + but-
ton while holding down the SHIFT button.
•To display the last page of table, press the – button
while holding down the SHIFT button.
5. To exit the VIDEO LOSS HISTORY table, perform either
of the following.
•Select a camera. (Refer to p. 56 Camera Selection.)
•Press the MON(ESC) button.
•Press the EXIT button.
Area Change
Note: The following...

83
APPENDIX 

84
The power cord insulation is
damaged.
Troubleshooting
Before asking for technical support, please check the following symptoms and their possible causes and solutions. If the solu-
tions below do not solve the problem, or the symptom is not listed below, contact your installer or sales representative.
Power Related Failure
CPU-Related Problems
SymptomPossible cause / Possible solutionReference
The power cord, connector, or
power plug are hot-damaged.
The power cord gets warm or
hot if bent or pulled...

85
System Controller-Related Problems
WV-CU950 controller fails to
start. LCD shows: Connecting
to Main CPU…
SymptomPossible cause / Possible solutionReference 
Admin Console
Users GuideCheck the network connection between the CPU and CU950
controller. Check the controller database and make sure it
has the correct controller Ethernet address.
Encoder and Decoder-Related problems (NTSC model only)
The encoder or decoder does
not start up normally.
SymptomPossible cause / Possible solutionReference...

86
Specifications
Power Supply NTSC model: 120 V AC, 60 Hz
PAL model: 220 V - 240 V AC, 50 Hz
Power Consumption: 60 W
Controllable Encoders (NTSC model only): 256 Encoders
Controllable Decoders (NTSC model only): 64 Decoders
Ethernet Ports: 10Base-T/100Base-TX, 8-conductor modular jack (x3)
System controller* (1 port), encoder and decoder control (1 port)**, other (1 port)
* Maximum 64 controllers
** NTSC model only
RS-232C Port: 9-pin D-sub connector (x2)
Ambient Operating Temperature: +5 °C to +45 °C...

For U.S., Canadian and Puerto Rican fields:
Panasonic System Solutions Company, 
Unit Company of Panasonic Corporation of North America
Security Systems
www.panasonic.com/security
For customer support, call 1.877.733.3689
Executive Office: Three Panasonic Way 2H-2, Secaucus, New Jersey 07094
Zone Office
Eastern: Three Panasonic Way, Secaucus, New Jersey 07094
Central: 1707 N. Randal Road, Elgin, IL 60123
Southern: 1225 Northbrook Parkway, Suwanee, GA 30024
Western: 6550 Katella Ave., Cypress, CA 90630...