Oce PlotWave 300 User Manual

Chapter 7
Solve problems
Downloaded From ManualsPrinter.com Manuals 

How to solve problems with jobs
1.If there is a problem with a job, the color of the green 'Jobs - Queue' bar in the Océ Ex-
press WebTools turns red.
The System Monitor section of the Océ Express WebTools displays the message: 'User
intervention required'.
The job that has the problem remains in the queue as an active job, displayed in bold
fonts.
2.On the user panel detailed information about the problem is displayed. You can use this
information to help you to solve the problem.
Note:...

Clear an original jam on the scanner
Introduction
When an original jam occurs on the scanner, the message 'Scanner original jam' appears
on the user panel. You must remove the original from the scanner.
If an original jam occurs often:
■Check if you use the correct type of original.
■Check if you must use a carrier sheet.
■Check if the original is damaged before you insert it.
How to remove a jammed original
1.Use both hands to push up the left and right scanner open levers (5) to fully open the...

Clear a media jam in the fuser section
Attention:
During normal use the fuser must be closed. Only open it to remove the media after a
media jam.
1.Wait a few moments to let the fuser cool down.
Chapter 7 - Solve problems
274
Clear a media jam in the fuser section
Downloaded From ManualsPrinter.com Manuals 

2.Press the green knob on the media jam clearance handle to open the upper back cover.
Chapter 7 - Solve problems
275
Clear a media jam in the fuser section
Downloaded From ManualsPrinter.com Manuals             

3.Remove any jammed printing material from the fuser section.
4.Press the green knob on the media jam clearance handle and close the upper back cover.
Chapter 7 - Solve problems
276
Clear a media jam in the fuser section
Downloaded From ManualsPrinter.com Manuals   

Clear a media jam in the media bypass section
1.Open the lower front cover.
Chapter 7 - Solve problems
277
Clear a media jam in the media bypass section
Downloaded From ManualsPrinter.com Manuals    

2.Lower the media bypass by pressing the handles on the left and the right.
3.Remove any jammed media.
Chapter 7 - Solve problems
278
Clear a media jam in the media bypass section
Downloaded From ManualsPrinter.com Manuals                   

Note:
If the material cannot be removed easily, you must open the upper back cover with the
media jam clearance handle to access to the jammed material. (see ‘Clear a media jam in
the fuser section’ on page 274).
4.Pull up the media bypass.
5.Close the lower front cover.
Chapter 7 - Solve problems
279
Clear a media jam in the media bypass section
Downloaded From ManualsPrinter.com Manuals          

Clear a media jam in the roll feed section
1.Pull firmly to open the media drawer.
2.Remove any jammed printing material from the paper path and, if necessary, pull back
the media and rewind it.
3.Reload the media roll if necessary and press the clean cut button to trim a strip of the
media roll. (see ‘Load a media roll (position 1)’ on page 250)
4.Close the media drawer.
Chapter 7 - Solve problems
280
Clear a media jam in the roll feed section
Downloaded From ManualsPrinter.com Manuals