Nokia 6200 User Guide

							[ 142 ] PACEMAKER S
Pacemaker manufacturers recommend that a minimum separation of 
6 inches (20 cm) be maintained between a handheld wireless phone 
and a pacemaker to avoid potential interference with the pacemaker. 
These recommendations are consistent with the independent research 
by and recommendations of Wireless Technology Research. Persons 
with pacemakers:
 Should always keep the phone more than 6 inches (20 cm) from their 
pacemaker when the phone is switched on
 Should not carry the phone in a breast pocket
 Should use the ear opposite the pacemaker to minimize the potential 
for interference.
 If you have any reason to suspect that interference is taking place, 
switch off your phone immediately.
HEARING AIDS
Some digital wireless phones may interfere with some hearing aids. In the 
event of such interference, you may want to consult your service provider.
Other medical devices
Operation of any radio transmitting equipment, including cellular phones, 
may interfere with the functionality of inadequately protected medical 
devices. Consult a physician or the manufacturer of the medical device to 
determine if they are adequately shielded from external RF energy or if 
you have any questions. Switch off your phone in health care facilities 
when any regulations posted in these areas instruct you to do so. 
Hospitals or health care facilities may be using equipment that could be 
sensitive to external RF energy.
Vehicles
RF signals may affect improperly installed or inadequately shielded 
electronic systems in motor vehicles (for example, electronic fuel 
injection systems, electronic antiskid/antilock braking systems, electronic 
speed control systems, air bag systems). Check with the manufacturer or 
its representative regarding your vehicle. You should also consult the 
manufacturer of any equipment that has been added to your vehicle. 
						

							[ 143 ]Reference information
Posted facilities
Switch your phone off in any facility where posted notices so require.
Potentially explosive atmospheres
Switch off your phone when in any area with a potentially explosive 
atmosphere and obey all signs and instructions. Sparks in such areas could 
cause an explosion or fire resulting in bodily injury or even death.
Users are advised to switch off the phone when at a refueling point 
(service station). Users are reminded of the need to observe restrictions on 
the use of radio equipment in fuel depots (fuel storage and distribution 
areas), chemical plants, or where blasting operations are in progress.
Areas with a potentially explosive atmosphere are often but not always 
clearly marked. They include below deck on boats; chemical transfer or 
storage facilities; vehicles using liquefied petroleum gas (such as propane 
or butane); areas where the air contains chemicals or particles, such as 
grain, dust, or metal powders; and any other area where you would 
normally be advised to turn off your vehicle engine.
Vehicles
Only qualified personnel should service the phone or install the phone in 
a vehicle. Faulty installation or service may be dangerous and may 
invalidate any warranty which may apply to the unit.
Check regularly that all wireless phone equipment in your vehicle is 
mounted and operating properly.
Do not store or carry flammable liquids, gases, or explosive materials in 
the same compartment as the phone, its parts, or enhancements.
For vehicles equipped with an air bag, remember that an air bag inflates 
with great force. Do not place objects, including both installed or portable 
wireless equipment in the area over the air bag or in the air bag deployment 
area. If in-vehicle wireless equipment is improperly installed and the air 
bag inflates, serious injury could result.
FCC regulations prohibit using your phone while in the air. Switch off your 
phone before boarding an aircraft. The use of wireless telephones in an 
aircraft may be dangerous to the operation of the aircraft, disrupt the 
wireless telephone network, and may be illegal. 
						

							[ 144 ] Failure to observe these instructions may lead to suspension or denial of 
telephone services to the offender, legal action, or both.
  EMERGENCY CALLS
Important: This phone, like any wireless phone, operates using 
radio signals, wireless, and landline networks as well as user-
programmed functions. Because of this, connections in all conditions 
cannot be guaranteed. Therefore you should never rely solely upon 
any wireless phone for essential communications (for example, 
medical emergencies).
Emergency calls may not be possible on all wireless phone networks or 
when certain network services and/or phone features are in use. Check 
with local service providers.
To make an emergency call:
1If the phone is not on, switch it on. Check for adequate signal 
strength.
Note: Some networks may require that a valid SIM card is properly 
inserted in the phone.
2Press 
i as many times as needed (for example, to exit a call, to exit 
a menu, etc.) to clear the display and ready the phone for calls. 
3Key in the emergency number for your present location (for example, 
911 or other official emergency number). Emergency numbers vary 
by location.
4Press the 
h key.
If certain features are in use, you may first need to turn those features off 
before you can make an emergency call. Consult this user guide and your 
local cellular service provider.
When making an emergency call, remember to give all the necessary 
information as accurately as possible. Remember that your wireless phone 
may be the only means of communication at the scene of an accident - 
do not end the call until given permission to do so. 
						

							[ 145 ]Reference information
  CERTIFICATION INFORMATION (SAR)
THIS MODEL PHONE MEETS THE GOVERNMENT’S REQUIREMENTS FOR 
EXPOSURE TO RADIO WAVES.
Your wireless phone is a radio transmitter and receiver. It is designed and 
manufactured not to exceed the emission limits for exposure to radio 
frequency (RF) energy set by the Federal Communications Commission of 
the U.S. Government. These limits are part of comprehensive guidelines 
and establish permitted levels of RF energy for the general population. The 
guidelines are based on standards that were developed by independent 
scientific organizations through periodic and thorough evaluation of 
scientific studies. The standards include a substantial safety margin 
designed to assure the safety of all persons, regardless of age and health. 
The exposure standard for wireless mobile phones employs a unit of 
measurement known as the Specific Absorption Rate, or SAR. The SAR 
limit set by the FCC is 1.6W/kg.* Tests for SAR are conducted using 
standard operating positions accepted by the FCC with the phone 
transmitting at its highest certified power level in all tested frequency 
bands. Although the SAR is determined at the highest certified power 
level, the actual SAR level of the phone while operating can be well below 
the maximum value. This is because the phone is designed to operate at 
multiple power levels so as to use only the power required to reach the 
network. In general, the closer you are to a wireless base station antenna, 
the lower the power output.
Before a phone model is available for sale to the public, it must be tested 
and certified to the FCC that it does not exceed the limit established by 
the government-adopted requirement for safe exposure. The tests are 
performed in positions and locations (for example, at the ear and worn on 
the body) as required by the FCC for each model. The highest SAR value 
for this model phone as reported to the FCC when tested for use at the 
ear is 0.91 W/kg, and when worn on the body, as described in this user 
guide, is 0.77 W/kg. (Body-worn measurements differ among phone 
models, depending upon available enhancements and FCC requirements).  
						

							[ 146 ] While there may be differences between the SAR levels of various phones 
and at various positions, they all meet the government requirement.
The FCC has granted an Equipment Authorization for this model phone 
with all reported SAR levels evaluated as in compliance with the FCC RF 
exposure guidelines. SAR information on this model phone is on file 
with the FCC and can be found under the Display Grant section of 
http://www.fcc.gov/oet/fccid after searching on FCC ID 
LJP NPL-3. 
For body worn operation, this phone has been tested and meets the FCC 
RF exposure guidelines for use with an enhancement that contains no 
metal and that positions the handset a minimum of 7/8 inch (2.2 cm) from 
the body. Use of other enhancements may not ensure compliance with 
FCC RF exposure guidelines. If you do not use a body-worn enhancement 
and are not holding the phone at the ear, position the handset a minimum 
of 7/8 inch (2.2 cm) from your body when the phone is switched on.
*In the United States and Canada, the SAR limit for mobile phones used 
by the public is 1.6 watts/kilogram (W/kg) averaged over one gram of 
tissue. The standard incorporates a substantial margin of safety to give 
additional protection for the public and to account for any variations in 
measurements. SAR values may vary depending on national reporting 
requirements and the network band. For SAR information in other regions 
please look under product information at 
http://www.nokia.com/us. 
						

							[ 147 ]Reference information
  BATTERY INFORMATION 
This section provides information about the phone battery. Be aware that 
the information in this section is subject to change.
Note: Dispose of used batteries in accordance with any 
local regulations.
The tables shown in this section provide information about battery options 
that are available for your phone, charging times with the Travel Charger 
(ACP-12), the Rapid Travel Charger (ACP-8), the Standard Travel Charger 
(ACP-7), talk-times, and standby times. For more information, contact 
your service provider.
Charging times
The following charging times are approximate:
Talk and standby times
Operation times are estimates only and depend on signal strength, phone 
use, network conditions, features used, battery age and condition 
(including the effect of charging habits), temperatures to which the 
battery is exposed, and many other factors. The amount of time a phone 
is used for calls will affect its standby time. Likewise, the amount of time 
that the phone is turned on and in standby mode will affect its talk-time.
Charger OptionsACP-12ACP-8ACP-7
BLD-3 720 mAh Li-Ion batteryUp to 1.5 hUp to 2 h Up to 3 h 
Talk/Standby Time 850 18001900
Talk-time2.5 h4 h3.5 h
Talk-time with Speakerphone2 h2.5 h3 h
Radio and Headset standby time28.5 h
Radio and Speakerphone standby time6.4 h
Standby time10 d 
						

							[ 148 ]
  TECHNICAL INFORMATION
FeatureSpecification
Weight3.2 oz. (92 grams) with BLD-3 720 mAh 
Li-Ion battery
Wireless networksGSM 850, 1800, and 1900 networks
Size (volume)4.6 cubic inches (75 cubic centimeters)
Frequency range (Tx)GSM 850: 824-849 MHz
GSM 1800: 1710-1785 MHz
GSM 1900: 1850-1910 MHz
Frequency range (Rx)GSM 850: 869-894 MHz
GSM 1800: 1805-1880 MHz
GSM 1900: 1930-1990 MHz
Tx output power2 W (GSM 850 max)
1 W (GSM 1800/GSM 1900 max)
Battery voltage3.7 Vdc
Operating temperature+14°F to +131°F (-10°C to +55°C)
Number of channelsGSM 850: 124
GSM 1800: 374 
GSM 1900: 299
Memory locationsUp to 500 in phone memory 
						

							[ 149 ]Reference information
 ENHANCEMENTS 
If you want to increase phone functionality, a range of enhancements is 
available for you. You can select any of these items to help accommodate 
your specific communication needs. 
Use enhancements safely
A few practical rules for enhancement operation:
 Keep all enhancements out of the reach of small children.
 When you disconnect the power cord of any enhancement, grasp and 
pull the plug, not the cord.
 Check regularly that any vehicle-installed enhancements are 
mounted and are operating properly.
 Installation of any complex car enhancements must be made by 
qualified personnel only.
 Use only batteries, chargers, and enhancements that have been 
approved by the phone manufacturer. The use of any other types 
could invalidate any approval or warranty applying to the phone and 
could be dangerous.
720 mAh Li-Ion Battery (BLD-3)
Provides up to 4 hours of talk time and up to 3 hours 
of talk time with the speakerphone.
For complete information on the phone battery 
(including talk, standby, and charging times), see 
“Battery information” on page 147. 
						

							[ 150 ]
Mobile Charger (LCH-12)
This multivoltage charger plugs into the 
cigarette lighter in a vehicle and is an easy 
and convenient way to charge the compatible 
phone battery in a vehicle.
To use the charger, plug it into a standard 120-Vac outlet and connect the 
lead from the charger to the base of your phone. Calls can be made during 
charging, even with a fully discharged battery.
Also available:
Mobile Charger (LCH-9)
Travel Charger (ACP-12)
This lightweight ac charger can be used with all battery 
options. To use the charger, plug it into a standard 120-Vac 
wall outlet and connect the lead from the charger to the 
base of your phone. Calls can be made during charging, even 
with a fully discharged battery. 
Also available: 
Standard Travel Charger (ACP-7)
Rapid Travel Charger (ACP-8)
Headset Kit (HDB-4)
New over-the-ear design concept boom headset is small, 
lightweight, and provides excellent audio quality.
Also available:
Stereo Headset (HDS-3)
Retractable Headset (HS-10)
Headset (HS-5) 
						

							[ 151 ]Reference information
Camera Headset 
(HS-1C)
The camera headset 
allows you to take 
single-shot pictures 
from a small camera 
which is mounted on the headset. The camera is powered by the Pop-port 
connector on the bottom of your phone, and you use the options in your 
phone to store, send, or delete pictures. A microphone mounted on the 
camera and an answer/end button on the headset allows you to 
conveniently use your phone while snapping pictures.
Loopset (LPS-4)
With the loopset, people who use a T-coil equipped hearing 
aid have the freedom to talk on a digital mobile phone. The 
loopset goes around your neck so it can be worn comfortably 
and discreetly. 
Data Cable (DKU-5)
For e-mail, faxes, Internet, and data 
transmissions. Easy and convenient 
connection with no modem or PC 
card needed.
TTY/TDD Adapter (HDA-10)
The TTY/TDD adapter is a Nokia enhancement 
that allows you to connect your mobile 
phone to a Telecommunications Device 
for the Deaf (TTY/TDD) to make a call in 
digital mode.