NEC Neax 2000 Ivs Ccis Features And Specifications

NEAX2000 IVS CCIS Features and Specifications
Page 50NDA-24159, Issue 2
Distinctive Ringing - CCIS
General Description
This feature provides distinctive station ringing patterns for terminated calls, through the CCIS network, so that
a station user can distinguish between incoming internal and external calls.
Operating Procedure
No manual operation is required.
Service Conditions
1. Ringing patterns for incoming internal calls on the CCIS network:
A. 1 second ring, 2 seconds silence
B. 2 seconds ring, 4...

NEAX2000 IVS CCIS Features and Specifications
NDA-24159, Issue 2
Page 51
Do Not Disturb - CCIS
General Description
This feature allows a station user to establish Do Not Disturb (DND) status on a temporary basis, during which
time incoming CCIS calls will be denied access to the station.
Operating Procedure
To set Do Not Disturb from a Single-Line Telephone or Multiline Terminal:
1. Lift the handset; receive dial tone.
2. Dial the Do Not Disturb - CCIS feature access code; receive service set tone.
3....

NEAX2000 IVS CCIS Features and Specifications
Page 52NDA-24159, Issue 2
Do Not Disturb - CCIS
6. When a Multiline Terminal is set to DND, calls to the primary and secondary extensions will not ring. Trunks
programmed to ring will not do so while DND is set, but flashing LED indications are still provided. DND
will not deny an Executive Override.
7. If the Do Not Disturb feature access key is pressed while connected to a trunk or station, the following inter-
ruptions are denied until that call is...

NEAX2000 IVS CCIS Features and Specifications
NDA-24159, Issue 2
Page 53
Dual Hold - CCIS
General Description
This feature allows two connected Multiline Terminals to be placed on hold simultaneously over the CCIS link.
This enables the held parties to answer or originate a call from a secondary extension or the idle primary exten-
sion.
Operating Procedure
To operate Dual Hold - CCIS from a Multiline Terminal:
1. The user at Station A presses the HOLD key; the user at Station B is placed on hold.
2. The...

NEAX2000 IVS CCIS Features and Specifications
Page 54NDA-24159, Issue 2
Elapsed Time Display - CCIS
General Description
This feature provides an LCD display which shows the duration of time that a Multiline Terminal is connected
to any trunk through the CCIS network.
Operating Procedure
No manual operation is required.
Service Conditions
1. The elapsed time is displayed in the seven left-most positions of the LCD display.
2. The elapsed time can reach a maximum of 9 hours, 59 minutes and 59 seconds,...

NEAX2000 IVS CCIS Features and Specifications
NDA-24159, Issue 2
Page 55
Flexible Numbering Of Stations - CCIS
General Description
This feature allows voice and data station numbers to be assigned to any instrument in the CCIS network, based
solely upon numbering plan limitations.
Office location is indicated by all digits of the station number (see below).
Operating Procedure
No manual operation is required.
Service Conditions
1. Careful consideration should be given to the network numbering plan to...

NEAX2000 IVS CCIS Features and Specifications
Page 56NDA-24159, Issue 2
Hands-Free Answerback - CCIS
General Description
This feature allows a Multiline Terminal station user to respond to a voice call, through the CCIS network, with-
out lifting the handset.
Operating Procedure
To answer a Voice Call-CCIS:
1. Press the FNC key followed by 1 to turn on the microphone; MIC LED is lit.
2. Respond to the call in a hands-free manner.
Service Conditions
1.Hands-Free Answer Back - CCIS may only be utilized...

NEAX2000 IVS CCIS Features and Specifications
NDA-24159, Issue 2
Page 57
Hot Line - CCIS
General Description
This feature allows two stations, at different nodes in the CCIS network, to be mutually associated on an auto-
matic ringdown basis through the CCIS network.
Operating Procedure
To place a Hot Line - CCIS call:
1. The user at Station A lifts the handset.
2. Station B is rung.
3. The user at Station B lifts the handset and the connection is established.
Service Conditions
1. If both phones in a...

NEAX2000 IVS CCIS Features and Specifications
Page 58Addendum-003 NDA-24159, Revision 2.3
July, 1998
House Phone - CCIS
General Description
This feature allows selected stations to call an Attendant Console, through the CCIS network, simply by going
off hook.
Operating Procedure
To call an Attendant in another office:
1. The House Phone - CCIS user lifts the handset.
2. The Attendant in another office is automatically called. The AT N D
 lamps on the Attendant Console flash and
the console buzzer...

NEAX2000 IVS CCIS Features and Specifications
NDA-24159, Issue 2
Page 59
Incoming Call Identification - CCIS
General Description
This feature allows an Attendant to visually identify the type of service and/or trunk group which is arriving or
waiting to be answered at the Attendant Console through the CCIS network.
Operating Procedure
No manual operation is required.
Service Conditions
1. A flashing lamp indicates a call waiting to be answered.
2. A steady lamp indicates an answered call.
3. A maximum of...