NEC Neax 2000 Ivs Business/Hotel/Data Features And Specifications

NEAX2000 IVS Business/Hotel/Data Features and Specifications
NDA-24158, Revision 2.8 Addendum-008
Page 217February, 1999
Message Waiting (Single/Multiple)
3. Message Waiting lamp is lit on the called station (X=the number of messages).
4. Restore the handset.
 (XXX=Card No.)
n  n  From the Attendant Console
1. Dial 8; receive service set tone for 3 seconds.
2. Press the RELEASE key or CANCEL key.
n  To retrieve a message
n   n  From a Single Line Telephone
1. Lift the handset and receive dial tone.
2....

NEAX2000 IVS Business/Hotel/Data Features and Specifications
Page 218Addendum-008 NDA-24158, Revision 2.8
February, 1999
Message Waiting (Single/Multiple)
6. When multiple Message Waiting indications are initiated from various points (Attendant Consoles, Front
Desk Instrument, other stations, etc.), clearing one message will remove the Message Waiting indication.
7. The flashing rate for the Message Waiting lamp on the Multiline Terminal is selected on a system-wide basis
for 60 IPM or lit steady.
8....

NEAX2000 IVS Business/Hotel/Data Features and Specifications
NDA-24158, Issue 2
Page 219
Miscellaneous Trunk Access
CCSA Access
Miscellaneous Trunk Access
General Description
This feature allows the connection of various types of external facilities.  In addition to Loop and Ground Start
Trunks, the following can also be interfaced with the NEAX2000 IVS:  CCSA Lines Code Calling Equipment,
Dictation Equipment, Foreign Exchange (FX) Lines, Radio Paging Equipment, and Wide Area Telephone Ser-
vice (WATS)...

NEAX2000 IVS Business/Hotel/Data Features and Specifications
Page 220NDA-24158, Issue 2
Miscellaneous Trunk Access
Code Calling Equipment Access
Service Conditions
1. An access code needs to be assigned for CCSA Access.
2. 4-Wire Tie Line circuits (ODT board) must be provided for the interface with CCSA network.
3. The maximum number of ODT boards are 32/PIM.
4. Immediate, second dial tone, wink start or delay dial operation is available by system data on a trunk route
basis. 
5. When the called station...

NEAX2000 IVS Business/Hotel/Data Features and Specifications
NDA-24158, Issue 2
Page 221
Miscellaneous Trunk Access
Foreign Exchange (FX) Access
Operating Procedure
To access the Dictation Equipment from any station:
1. Go off hook and receive dial tone.
2. Dial the Dictation Equipment feature access code.
3. Proceed according to operation procedures of the Dictation Equipment.
Service Conditions
1. One trunk circuit is required for each piece of dictation interface equipment accessed.
2. Dictation...

NEAX2000 IVS Business/Hotel/Data Features and Specifications
Page 222NDA-24158, Issue 2
Miscellaneous Trunk Access
Radio Paging Equipment Access
2. Care should be excerised in system data assignment when using this feature in conjunction with Least Cost
Routing (LCR) since FX lines may require that the digit 1 be dialed prior to the desired number, or that the
area code be deleted.
3. The maximum capacity of all trunk, including FX lines, cannot exceed 256 lines.
4. Access to this feature can be allowed...

NEAX2000 IVS Business/Hotel/Data Features and Specifications
NDA-24158, Issue 2
Page 223
Miscellaneous Trunk Access
Wide Area Telephone Service (WATS) Access
 Wide Area Telephone Service (WATS) Access
General Description
This feature allows any station user direct dial access to outgoing WATS lines.
Station Application
All stations.
Operating Procedure
Normal call handling procedures apply.
Service Conditions
1. One circuit on the COT card is required for each WATS line interface.
2. Least Cost Routing...

NEAX2000 IVS Business/Hotel/Data Features and Specifications
Page 224NDA-24158, Issue 2
Multiline Terminal Attendant Position
Multiline Terminal Attendant Position
General Description
A Multiline Terminal with LCD can be programmed to function similar to an Attendant position.  This Atten-
dant position has limited access to Attendant related features and functions and can be substituted where an At-
tendant is required but an Attendant Console is not necessary.  When an EDW-48-2A unit is associated with...

NEAX2000 IVS Business/Hotel/Data Features and Specifications
NDA-24158, Issue 2
Page 225
Multiline Terminal Attendant Position
3. Press the DND key to return to the normal DSS mode.
To set/cancel Night Service
•
Press the NT key on the EDW-48-2A unit.
OR
Dial the Night Service set/cancel code when off-hook on the primary extension.
Answering an Operator call
1. Press the OPE key.  The associated LED lights steady green and the LCD will display either the trunk name
and number or station name and number....

NEAX2000 IVS Business/Hotel/Data Features and Specifications
Page 226Addendum-001 NDA-24158, Revision 2.1
February, 1996
Music on Hold
Music on Hold
General Description
This feature plays music when a line is placed on hold.  Music is provided by a circuit board memory chip or a
local music source, such as a CD player or a radio.
Station Application
All stations.
Operating Procedure
No manual operation is required.
Service Conditions
1. Music may be played in three different cases: CO lines, Tie Lines,...