NEC Ds2000 Hardware Manual Instructions Manual
Have a look at the manual NEC Ds2000 Hardware Manual Instructions Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 1168 NEC manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
6. Specifications and Parts 6-1 Section 6, SPECIFICATIONS AND PARTS LIST In this section . . . PageSpecifications . . . . . . . . . . . . . . . . . . . . . . .6-2 Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . .6-6
6-2 SPECIFICATIONS System Capacities Conference Circuits 32 Conference circuits dynamically allocated, with 8 parties max. per Conference. Conference circuits provided on CPU. 8ATRU Analog Trunk PCB:Refer to System Config- 4ATRU Analog Trunk PCB:uration - U Slot on page 16DSTU Digital Station PCB:1-15 and System Config- 8ASTU Analog Station PCB:uration - Fixed Slot on 4ASTU Analog Station PCB:page 1-18 for capacities. CPU Central Processing Unit: 1 REJ Recording Jack Units 1 max. per keyset System Capacities Cabinets: 1 Talk Timeslots (Intercom/line): Non-blocking Analog Trunks (CO/PBX lines): 4 Slot Fixed: 16 4 Slot U: 24 8 Slot U: 48 Digital and/or Analog Telephones: 4 Slot Fixed: 32 4 Slot U: 40 8 Slot U: 96 DSS Consoles: 1 max. per keyset, 4 max. per system Power Failure Telephones: 2 per ATRU PCB Door Boxes (digital): 1 per digital station port External Paging Zones: 1 (1 per CPU) Internal Paging Zones: 8 (7 and All Call)
6. Specifications and Parts 6-3 SPECIFICATIONS Electrical Specifications The following specifications apply to each power supply installed. Power Supply: 120 VAC ±- 10% @ 50-60 Hz Output Power 91 Watts @ 100% full load Input Current 1.50A @ 110 V VA 165 Kwh .165 BTU 563 Grounding Requirements: 12 AWG copper wire Environmental Specifications Cabinets and Key Telephones Temperature: 0-45 oC (32-113 oF) Humidity: 10-95% (non-condensing) Door Box Temperature: 0-45 oC (32-113 oF) Humidity: 10-95% (non-condensing) Not intended for outdoor installation. Power Requirements A dedicated 110 VAC 60 Hz circuit located within seven feet of the cabinet is required. You should install a separate dedi- cated outlet for each cabinet. Environmental Requirements Meeting established environmental standards maximizes the life of the system. Refer to the Standard Practices Manual for further information. Be sure that the site is not: 1. In direct sunlight or in hot, cold or humid places. 2. In dusty areas or in areas where sulfuric gases are produced. 3. In places where shocks or vibrations are frequent or strong. 4. In places where water or other fluids comes in contact with the main equipment. 5. In areas near high-frequency machines or electric welders. 6. Near computers, telexes, microwaves, air conditioners, etc. 7. Near radio antennas (including shortwave). T i d c
6-4 SPECIFICATIONS External Paging Output Impedance: 600 Ohm Output Level: 0 dBr at 1.0 KHz CPRU Relay Contacts Contact Configuration: Normally open Maximum Load: 60 mA @ 30 VDC 10 mA @ 90 VDC Maximum Initial Contact Resistance: 50 mOhms Mechanical Specifications Equipment Width Depth Height Weight 4-Slot KSU 10 3/4””5 7/8””13 11/16”4 lbs 5 oz 8-Slot KSU 19 1/2””5 7/8””13 11/16”6 lbs 12 oz Non-display Keyset 7 1/4”9”2 7/8””1 lb 11 oz Display Keyset 7 1/4”9”2 7/8”1 lb 12 oz Super Display Keyset 7 1/4”9”2 7/8”1 lb 16 oz DSS Console 7 7/8”8 7/8”2 3/4”1 lb 6 oz Door Box 4”1 1/2”5 3/16”10 oz 2-OPX Module 9 3/8”7 3/8”1 1/4”3 lbs
6. Specifications and Parts 6-5 SPECIFICATIONS Cabling Requirements 1. Do not run station cable parallel with the AC source, telex or com- puter, etc. If the cables are near cable runs to those devices, use shielded cable with grounded shields or install the cable in conduit. 2. When cables must be run on the floor, use cable protectors. 3. Cable runs for key telephones, single line telephones, and Door Boxes must be a dedicated, isolated cable pair.Device Cable Type Cable Run Length (ft) Notes Key Telephone, 2-wire 26 AWG 1300 2-wire 24 AWG 2000 Single Line 2-wire 26 AWG 11,500 at constant 20 mA Telephone 3150 at constant 35 mA 2-wire 24 AWG 18,000 at constant 20 mA 5050 at constant 35 mA 2-wire 22 AWG 29,000 at constant 20 mA 8000 at constant 35 mA Door Box 2-wire 24 AWG 2000 2-wire 22 AWG 2000 2-OPX 2-wire 24 AWG 1000 FCC Registration Information Model: DS2000 Manufacturer: NEC Infrontia, Inc. FCC Part 15 Registration: Class A FCC Registration Number: 1ZDTHA27007-KF-E 1ZDTHA27044-MF-E Industry CanadaCertificate (DOC) Number 854 9522 AReg. FIC Mfrs. Port Network Status Identifier JacksOriginal 02LS2 80010 REN 0.6B RJ11C 80011 RJ21X Registered OL13A 2OPX-A SOC 9.0F RJ21X OL13B 2OPX-A SOC 9.0F RJ21X OL13C 2OPX-A SOC 9.0F RJ21X BGM/MOH Music Source Input Input Impedance: 10K Ohms Input Level: +18 dBr (+/- 2 dBr) t 1.0 KHz Music input is located on the CPU PCB.
6-6 PARTS LIST Common Equipment Description Part Number 4-Slot KSU 80000 8-Slot KSU 80001 DS2000 Power Supply 80005 80005A Installation Cable 80892 Blank PC Card 85880 PC Card with system software preloaded 80051-V**.** (**.** denotes the system software level) 8-Pin DIN to Mod-8 Cable 80893 DB9 to Mod-8 Adaptor 85980 DB25 to Mod-8 Adaptor 85981 Spare KSU Hanger 80578 You must use an A version Power Supply in an 8 Slot Cabinet Peripheral Station Equipment Description Part Number 2-OPX Module 92177A DS2000 Digital Door Box 80560 Station Equipment Description Part Number 34-Button Super Display Telephone 80673 34-Button Display Telephone 80663 22-Button Telephone 80570 22-Button Display Telephone 80573 24-Button DSS Console 80556 110-Button DSS Console 80555 Wall Mount Kit 80579 Analog Telephones (customer provided)
6. Specifications and Parts 6-7 PARTS LIST Replacement Parts Description Part Number Handset and Cord Assembly 80150 Noise Canceling Handset 80150NC Handset Coil Cord - Black 9’92297-9 Handset Coil Cord - Black 13’92297-13 Handset Coil Cord - Black 25’92297-25 Telephone Line Cord - Black 7”82476-7 Telephone Line Cord - Black 14”82476-14 34 Btn Super Display Tel Clear Plastic Cover 80600-S34 34 Btn Tel Clear Plastic Cover 80600-34 22 Btn Tel Clear Plastic Cover 80600-22 110-Button DSS Console Clear Plastic Cover 80600-DSS 24-Button DSS Console Clear Plastic Cover 80600-24DSS Directory Tray 92602 Wall Mount Handset Clip Holder 80578 DS2000 RFI Bead Kit 88901 PCBs Description Part Number CPU Central Processing Unit 80025 80025A 16DSTU Digital Station PCB 80021 80021A 8ASTU 8 Port Analog Station PCB 80041 80041A 4ASTU 4 Port Analog Station PCB 80040 80040A 4ATRU 4 Port Analog Trunk PCB (loop start) 80010 80010A 8ATRU 8 Port Analog Trunk PCB (loop start) 80011 80011A 4 Circuit Caller ID Daughter Board 92012 Installs on 4ATRU PCB P/N 80010A 8 Circuit Caller ID Daughter Board 80013 Installs on 8ATRU PCB P/N 80011A You must use all A version PCBs in an 8 Slot Cabinet
Th 6-9 co NEC America, Inc., Corporate Networks Group 4 Forest Parkway, Shelton, CT 06484 Tel: 800-365-1928 Fax: 203-926-5458 cng.nec.comOther Important Telephone Numbers Sales: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .203-926-5450 Customer Service: . . . . . . . . . . . . . . . . . . . . . . . . . . .203-926-5444 Customer Service FAX: . . . . . . . . . . . . . . . . . . . . . . .203-926-5454 Technical Service: . . . . . . . . . . . . . . . . . . . . . . . . . . .203-925-8801 Discontinued Product Service: . . . . . . . . . . . . . . . . . .900-990-2541 Technical Training: . . . . . . . . . . . . . . . . . . . . . . . . . . .203-926-5430 Emergency Technical Service (After Hours) . . . . . . . .203-929-7920 (Excludes discontinued products)
NEC America, Inc., Corporate Networks Group 4 Forest Parkway, Shelton, CT 06484 TEL: 203-926-5400 FAX: 203-929-0535 cng.nec.com