Mitel Voice Processing Solutions Instructions Manual

,’ 
Change the Answer or riginate Link Cl? 
Assignment Page 1 of 1 
VoiceMemo Release G.OA and later 
This procedure describes how to change the assignment of a MESA-Net Async link from 
answer to originate or vice-versa. 
ate: You perform this procedure offline; you must activate the configuration for the link 
step assignment changes to take effect. 
1. Reach the Basic Network Menu from the Offline Menu. 
2. Specify the module in which you are configuring links. 
Select: (H) Host number to configure =...

cl? 
View MESA-Net Async, Link Configurations 
Page 1 of 1 
VoiceMemo Release 6.OA and later 
This procedure describes how to review the configuration of your MESA-Net Async 
links. There are two link reports available: 
The Network Link Data Report, which provides information about the network hardware, 
the timeout parameters (data receive, resend, and node inactivity), and the failure counts. 
The Network Link Serial Port Report, which provides information about the 
communication parameters for each...

r 
ESA-Net Async cl? 
Hardware Type 
VoiceMemo Release 6.OA and later 
This procedure describes how to assign a number designation to a pre-programmed 
(default) MESA-Net Async hardware type. A hardware type must have a number 
designation before you can associate it with a link or a node. You can use a maximum of 
seven different hardware types for each MESA-Net node. Follow this procedure if you 
are using one of the following default hardware types: 
0 Concord Trellis 296 modem 
* ATT Paradyne 3800...

Cl? 
Modify a MESA-Net Async Hardware Type 
Page 1 of 4 
VoiceMemo Release 6.OA and later 
This procedure describes how to modify an assigned MESA-Net Async hardware type. 
Use this procedure if the communications equipment used at the site requires actions 
(originate, answer, disconnect, and line drop signal) that are similar to one of the 
following default hardware types: 
0 Concord Trellis 296 modem @ ATT Paradyne 3800 series 
@ Concord Dialaccess 296 modem 0 US Robotics V.34 Courier 
Microcom...

cl? 5733 
Page 2 of 4 
VoiceMemo Release 6.OA and later 
Step 
5. As required, change the Originate Call, Answer Call, and Disconnect Call actions. 
Select: (A) Actions 
prompt: 
ACTION TYPES 
(0) Originate call 
(A) Answer call 
(D) Disconnect call 
(S) Show actions 
(X) Exit 
Response: 0 to change the Originate call actions, 
A to change the Answer call actions, 
D to change the disconnect call actions. 
The system displays the command sequence of the action that you chose, followed 
by the Modify,...

cl? 5733 
Page 3 of 4 
VoiceMemo Release 6.OA and later 
Step 
The system displays the possible actions. 
Prompt: (HI Set signal hi 
(L) Set signal lo 
(W) Wait signal hi 
(V) Wait signal lo 
(P) Sleep 
(C) Send access code 
(S) Send string 
(R) Read string 
(Y) Wait string 
(F) Flush device 
(D) Display actions 
(X) Exit 
Response: The letter of the action that you wan 
action. .t to use in place of the previous 
Most of the action selections will prompt you for more information, 
such as the signal to...