Mitel Sx 200 Ml Pabx Lightware 16 Instructions Guide

Regulatory Notices 
Federal Communications Commission (FCC) Notice 
Note: 
This equipment has been tested and found to comply with the limits for a Class A digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference when the equipment is operated in a commercial environment. This 
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used 
in accordance with the instruction manual,...

Safely Instructions 
2-4 Issue 1 Revision 0 March 1997  

SX-200@ ML PABX 
Installation 
Information 
no, @ - Trademark of Mite1 CorporatioI’L 
0 Copyright 1997, Mite1 Corporation. 
All right9 reserved 
Printed in Canada.  

lns~alla~ion Information 
Special Accessories Required for Compliance with FCC Rules Part 15 
The following special accessories are used with the SX-200ML equipment. 
Refer to the appropriate section of this practice for special accessory in- 
stallation information. 
Special Accessory Special Accessory Installation Information 
Split Ferrite Block Chart 5-l 
NOTICE 
The information contained in this document is believed to be accurate in all re- 
spects but is not warranted by Mite1 Corporation...

IMPORTANT SAFETY INSTRUCTIONS 
These instructions are intended to be used as a general guide to provide 
basic installation information which is necessary for the proper and safe 
functioning of this equipment. 
WARNING: Failure to follow all instructions may result in improper 
equipment operation and/or the risk of electric shock. 
General 
l Read and understand all instructions. Keep these instructions with the 
equipment. 
l Do not attempt to install or service this equipment unless you are skilled...

Installation Information 
l Never touch uninsulated telephone wires or terminals unless the 
telephone line has been disconnected at the network interface. 
l Use caution when installing or modifying telephone lines. 
Use of Notices and Symbols 
The following information provides an explanation of the notices and 
symbols which appear on the product and in the practices for this product. 
Danger indicates an imminently hazardous situation 
l-=-l i”ju~. which if not avoided, will result in death or...

’ 1. 
2. 
3. 
4. 
5. 
6. Table of Contents 
Introduction ........................................................ ..I- i 
Installation information .................................................... l-l 
Intent of this Document ................................................. l-l 
IntendedAudience ................................................... ..I- 1 
Peripheral Devices, Software and Documentation ............................. l-l 
Summary of Practice Contents...

Installation Information 
Install Night Bell ............................................. ........... 6-9 
Install Paging Equipment ...................................... ........... 6-11 
Install Music-On-Hold Equipment ............................... ........... 6-12 
Install Alternate Music Source for ACD ........................... ........... 6-13 
7. Cabling and Cross Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-l 
System Cabling . . . . . . . . . . . . . ....

Table of Contents 
Chart l-l 
Chart 2-l 
Chart 2-2 
Chart 2-3 
Chart 2-4 
Chart 2-5 
Chart 3-l 
Chart 3-2 
Chart 4-l 
Chart 4-2 
Chart 4-3 
Chart 4-4 
Chart 5-l 
Chart 5-2 
Chart 5-3 
Chart 5-4 
Chart 6-l 
Chart 6-2 
Chart 6-3 
Chart 6-4 
Chart 6-5 
Chart 6-6 
Chart 6-7 
Chart 6-8 
Chart 6-9 
March 1997 Issue 1 Revision 0 vii 
List of Charts 
How to Use This Practice ..................................... l-3 
Prepare For Installation ...................................... .2-4 
Unpack and Inspect an...

installation Information 
. . 
VIII Issue 1 Revision 0 
March 1997