Miele Cva 6202 User Manual

Switching the pre-brewing function on or
off
When the pre-brewing function is switched on, the
freshly ground coffee is first moistened with a little
hot water. Then the remaining water is forced
through the moistened coffee at high pressure. This
pre-brewing process allows the aroma and froth on
the coffee to develop to the full.
When the pre-brewing function is switched off, the
hot water is forced through the coffee immediately.
^Turn the selector anti-clockwise to the
programming position.
The...

^Press ENTER tosavethis setting, or
turn the selector to 0 toundo the alterations if a
mistake has been made.
This will bring you back from the sub-menu.
When making coffee with the pre-brewing function
switched on, the word Pre-brewing will appear in
the display after the coffee has been ground.
Switching the pre-grinding function on
or off
When the pre-grinding function is switched on, a
new portion of beans will be ground immediately
each time a cup is prepared, so there is always a
portion of ground...

^Press theebutton to switch the pre-grinding
function to On or Off.
^Press ENTER tosavethis setting, or
turn the selector to 0 toundo the alterations if a
mistake has been made.
This will bring you back from the sub-menu.
Switching the programmed quantity of
hot water on or off
If the function Prog. hot water is switched on, the
machine will dispense a precise, pre-programmed
quantity of hot water when the hot water buttond
is pressed. (See Setting the portion sizes). When
the function is switched off,...

^Press theebutton to switch the function to On or
Off.
^Press ENTER tosavethis setting, or
turn the selector to 0 toundo the alterations if a
mistake has been made.
This will bring you back from the sub-menu.
Displaying the number of cups of coffee
already dispensed (Total coffee)
Select function Total coffee and press ENTER to
display the number of cups of coffee
(small/espresso, medium coffee, large coffee) that
have been dispensed to date. Press ENTER again to
bring you back from the sub-menu.
Setting...

^Turn the selector anti-clockwise to the
programming position.
The machine is now in programming mode and
will respond according to the symbols shown
under the buttons.
The following will appear in the display:
^Press theebutton to highlight programming
option Timer with an asterisk.
^Press ENTER to confirm this option.
The sub-menu will appear in the display as
follows:
^Press theeor-button to select the required
length of time (ecounts down,-counts up). The
time can be set in 15 minute stages.
^
Press...

The machine can be locked to ensure that it is not
operated by unsupervised children or persons who
are unacquainted with the operating instructions.
Activating the system lock
^Turn the selector anti-clockwise to the Lock
position:
The following will appear in the display:
^Press the-button until
the following appears in the display:
The machine is now locked and cannot dispense.
The system will remain locked even if the selector is
turned to other positions and the lighting will remain
switched off....

Please clean the machine thoroughly before
filling the water container and the coffee bean
container, (see Cleaning and care).
Filling the water container
The quality of the water plays an
important part in the overall quality of the
coffee.  The water container should
therefore be emptied and filled with fresh water
every day. To remind you to do this the following
message will appear in the display when you switch
the machine on:
Hot water and other liquids could damage the
machine. Use cold, clean...

^Take the lid off and fill the container with cold,
clean drinking waterup to a maximum of 2 cm
below the top.
A valve in the base of the container will ensure
that no water can escape.
^Replace the lid making sure that the small handle
faces towards the front and then push the
container all the way back into the machine.
The container should now be sitting flat on the
floor of the machine to ensure the valve is sealed.
If the water container does not sit flat on the floor,
check whether the surface that...

Filling the coffee bean container
Only put roasted espresso or coffee beans in the
container. Anything else, including ground coffee
will damage the grinder.
Do not use coffee beans which have been
treated with caramel, sugar or other substances.
Do not put drinks containing sugar, or instant
coffee in the machine. Sugar will damage the
machine.
For technical reasons, the coffee bean container
must not be removed from the machine.
^Carefully pull the container out as far as it will go,
so that the lid is...

Important: the water piping must be rinsed
through and the machine cleaned thoroughly
before the first drink of coffee is prepared. Use
the rinse button for this, (see Cleaning and
care), and then prepare hot water afterwards,
(see Preparing drinks).
The flavour of the coffee produced depends on the
type of coffee, how finely the beans are ground and
the quantity of water used. Espresso, coffee and tea
cups vary in size. To ensure the machine uses
exactly the amount of water to suit your taste and
your...