Midway Kart Fury 27in Operations Manual

C.A.R.T. FURY3
CHAPTER 5 WIRING
Main Cabinet Wiring 

4MIDWAY AMUSEMENT GAMES, LLC 
CHAPTER 5 WIRING
RF Cage Wiring 

C.A.R.T. FURY5
CHAPTER 5 WIRING
Control Panel Wiring 

6MIDWAY AMUSEMENT GAMES, LLC 
CHAPTER 5 WIRING
Power Wiring Diagram 

C.A.R.T. FURY7
CHAPTER 5 WIRING
DIP SWITCH U13 SETTING TABLE
DIP Switch Setting for Coinage
There are many ways to select the type and quantity of currency recognized by the game machine.
1. The most common coin combinations for several countries are pre-programmed and may be selected
from the table when Standard Pricing is activated (see Game Adjustments).
2. DIP Switch settings may be changed with the power switched on. Set any switch then observe the
screen to verify that the desired selection is...

8MIDWAY AMUSEMENT GAMES, LLC 
CHAPTER 5 WIRING
CPU BOARD JUMPER LOCATION TABLE
CPU BOARD JUMPER POSITION TABLE
Notes on CPU Jumper Position
1. Boxes containing “----” means not applicable 
2. Memory type numbers shown are for blank parts. Your game requires programmed parts. 
SOUND SIO BOARD JUMPER POSITION TABLE
Notes on SIO Jumper Position
1. Configure I/O port P2 by setting both jumpers J1 and J8 to input or output mode. 
2. Configure I/O port P4 by setting both jumpers J3 and J5 to input or output...

C.A.R.T. FURY9
CHAPTER 5 WIRING
SOUND I/O BOARD LED INDICATOR STATUS TABLE
Notes on SIO LED Indicator Status
1. Software controls this LED. Indications are game and revision specific. Changing the EPROM’s on this 
board may alter the function of this LED. Firmware damage may also cause new or different LED 
behavior.
2. Hardware controls this LED. Indications depend on hard-wired circuitry. A change in normal LED
behavior may indicate a circuit fault. Changing the EPROM’s on this board shouldn’t alter...

10 MIDWAY AMUSEMENT GAMES, LLC 
CHAPTER 5 WIRING
CPU BOARD LED INDICATOR STATUS TABLE
Notes on LED Indicator Status
1. LED 1 monitors CPU power (+3.3V). If this LED is off or blinking, investigate processor circuits. If other 
LED’s are off or blinking at the same time, check +5V circuits or the game power supply.
2. LED 2 flashes when the hard disk is operating during game play. LED 2 may light continuously during
start-up. If this LED remains lighted, the hard drive may be locked-up or faulty.
3....

CHAPTER SIX
C.A.R.T. FURY 
• Before servicing electronics, turn off AC power to the VGM. Wait for capacitors to discharge.
 Before touching or handling electronic assemblies, discharge static electricity on your body. To dis-
charge static, begin by connecting the line cord to a properly grounded outlet, but do not turn on the 
power! Next, touch the safety ground stud of the power supply chassis.
 Store electronic assemblies in an anti-static area. Use anti-static bags to store or transport circuit...

TROUBLESHOOTING - 2 MIDWAY AMUSEMENT GAMES, LLC 
COIN MECHANISM AND PRICING TROUBLESHOOTING 
Symptom Cause Required Action
Video Game Machine 
(VGM) accepts cur-
rency or tokens, but 
number of credits per 
coin or bill is incorrect. Improper settings 
at Pricing Menu1. Press and hold TEST MODE switch inside coin 
door to enter Menu System. Select SWITCH 
TEST from Diagnostics menu. Conduct test to 
confirm operation of game switches.
2. Select either the STANDARD or CUSTOM PRIC-
ING MENU from Game...