Lexmark X 950 User Manual

5Gently pull the printhead wipers out until it stops, and then slowly slide them back into place.
3x
3x
3x
6Close the cover.
Maintaining the printer231 

7Slide the release lever to the right to lock the cover.
8Close the front door.
Maintaining the printer232 

Emptying the hole punch box
1Open door G.
2Pull out the hole punch box.
Maintaining the printer233 

3Empty the container.
4Insert the emptied hole punch box back into the finisher until it stops.
5Close door G.
Storing supplies
Choose a cool, clean storage area for the printer supplies. Store supplies right side up in their original packing
until you are ready to use them.
Do not expose supplies to:
Direct sunlight
Temperatures above 35°C (95°F)
High humidity above 80%
Salty air Maintaining the printer234 

Corrosive gases
Heavy dust
Checking the status of parts and supplies
A message appears on the display when a replacement supply item is needed or when maintenance is required.
Checking the status of parts and supplies on the printer control panel
From the home screen, touch Status/Supplies > View Supplies.
Checking the status of parts and supplies from a network computer
Note: The computer must be connected to the same network as the printer.
1Open a Web browser, and then type the printer IP address in...

Ordering a photoconductor unit
When 84.xx [Color] photoconductor low or 84.xx [Color] photoconductor nearly low
appears, order a replacement photoconductor unit.
When 84.xx Replace [color] photoconductor appears, replace the specified photoconductor.
Part name Part number
Photoconductor unit
Black
Cyan
Magenta
Ye l l o wC950X71G
CMY (Cyan, Magenta, Yellow) Photoconductor Kit
Note: CMY photoconductor units may reach end of life all
at the same time.C950X73G
Ordering a waste toner bottle
When 82.xx Waste...

Maintenance kit Service part number
320K (100 V) Maintenance Kit 40X7568
320K (110 V) Maintenance Kit 40X7550
320K (220 V) Maintenance Kit 40X7569
480K Maintenance Kit 40X7560
Replacing parts and supplies
Replacing a maintenance kit
1Replace the maintenance kit.
2Reset the maintenance count to zero to clear the 80 scheduled maintenance [x] message.
Note: For more information on replacing the maintenance kit and resetting the maintenance count, see the
instruction sheets that came with the maintenance...

2Rotate the release lever counterclockwise to open the cover.
3Lower the cover.
Warning—Potential Damage: To avoid overexposing the photoconductor unit, do not leave the door
open for more than 10 minutes. Maintaining the printer238 

4Grasp the handle of the photoconductor unit and pull it out of the machine.
5Unpack the replacement photoconductor unit.
6Align and insert the end of photoconductor unit.
Maintaining the printer239 

7Remove the tape from the top of the photoconductor unit.
8Push the tab forward to insert the photoconductor unit.
Maintaining the printer240