Lexmark C736 Service Manual
Have a look at the manual Lexmark C736 Service Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 166 Lexmark manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Repair information4-179 5026 Go Back Previous Next 9.Remove the two screws (G). G (18B1236)
4-180Service Manual 5026 Go Back Previous Next 10.Remove the cleaner shutter actuator (H) from the waste toner HV contact assembly. H
Repair information4-181 5026 Go Back Previous Next 11.Remove the four screws (J), the two screws (K), and the screw (L). Tilt the Waste toner HV contact assembly forward and up to remove it. J (18B0832)K (88A0313)L (27S2838)
4-182Service Manual 5026 Go Back Previous Next Installation note: Do the following procedures when re-installing the waste tone HV contact assembly: 1.Remove the fuser. 2.Remove all four toner cartridges 3.Remove the four sets of torsion springs. Remove the screw (A) and the spring cap (B) of the appropriate contact spring. 4.Press the lower half (C,D) of the springs, and remove the springs. B A D C
Repair information4-183 5026 Go Back Previous Next 5.Install the waste toner HV contact assembly into place. Route the toner level sensor cables (E) through the holes in the waste toner HV contact assembly while positioning the assembly. Make sure the aligner shaft worm gear is aligned as shown. E Ribs aligned Rib
4-184Service Manual 5026 Go Back Previous Next 6.Install the seven screws in the order shown below. Install 1 (18B0832)stInstall 2 (88A0313)ndInstall 4 (18B0832)th Install 3 ()rd 27S2838
Repair information4-185 5026 Go Back Previous Next 7.Use two screws (F) to attach the cleaner shutter actuator to the Waste toner HV contact assembly. Make sure the gear aligns as shown. F (27S2838) RibRibs aligned
4-186Service Manual 5026 Go Back Previous Next 8.Attach the eight springs (G) to the Waste toner HV contact assembly as shown. Make sure the springs are behind the retainers. G Retainer
Repair information4-187 5026 Go Back Previous Next 9.Install the contact springs. When installing each contact spring, make sure the top half (H) of the spring is under the straight spring (J). This is typical for both types of springs. Also make sure that the bottom half (K,L) of both springs are compressed and locked by the appropriate locking tabs (M,N). LKJ M HN
4-188Service Manual 5026 Go Back Previous Next 10.Connect the three top toner level sensor cables to the HVPS, making sure the cables (O) are attached properly to the retainers (P). 11.Reassemble the rest of the printer. PO