Land Rover Range Rover 98my Owners Nas Rover Manual

							Wipers & washers
58
REAR SCREEN
Pull the lever towards the steering wheel for
rear screen intermittent wipe.
All front wiper functions are also available in
this position, using the four positions
described on the previous page.
If the front wipers are operating in intermittent
mode, then the rear wiper will wipe on every
second operation of the front wipers. If the
front wipers are operating in continuous
mode, then the thumbwheel controls the delay
of the rear wiper.WINDSCREEN WASHER
Front screen wash/wipe
Press and hold the lower button to operate the
front screen wash/wipe. The washers will
continue operating for as long as the button is
pressed. After releasing the button, the wipers
will complete 3 full wipes before either
parking or continuing with any other selected
wiper function.
A momentary press on the lower button, will
initiate a programmed wash/wipe. The
washers will operate briefly and then stop
automatically, the wipers then completing 3
full wipes before either parking or continuing
with another function. Moving the lever to any
other front wipe position during the
programmed wash/wipe, will cancel the
remainder of the programme.
NOTE:If the wiper system senses a low fluid
level in the washer reservoir, then the
programmed wash/wipe will only operate for
as long as the button is pressed, i.e. there will
be no timed wash and no additional 3 wipes. 
						

							Wipers & washers
59 Washer jets
To adjust the front screen washer jets, insert a
needle into the jet orifice and use it to position
the jet so that the spray is directed towards
the horizontal centre line of the windscreen.
If the jets become obstructed, a needle or
strand of wire can be used to clear the
blockage.
Rear screen wash/wipe
Press and hold the upper button to operate
the rear screen wash/wipe. The washer will
continue operating for as long as the button is
pressed. After releasing the button, the wiper
will complete 3 full wipes before either
parking or continuing with any other selected
function.
A momentary press on the upper button will
initiate a programmed wash/wipe. The washer
will operate briefly and then stop
automatically, the wiper then completing 3 full
wipes before either parking or continuing with
another function. Moving the lever to any
other rear wipe position during the
programmed wash/wipe will cancel the
remainder of the programme.The rear wiper will operate automatically
whenever reverse gear is selected, provided
the front screen wipers are operating in either
intermittent, or continuous mode.
HEADLIGHT WASH/WIPE
Headlight wash/wipe is controlled by a timer
unit, and operates automatically on every
second wash of the front screenwash system
when the headlights are switched on.
NOTE:If the wiper system registers a low
screen wash fluid level the headlight
wash/wipe will not operate at all.
LOW SCREEN WASH FLUID
When the screen wash level is low, the
message centre displays LOW SCREEN
WASH. The message appears whenever the
front or rear wash/wipe systems are used and
is also activated whenever the starter switch is
turned to, or from, position II. To reset the
system the reservoir must be filled when the
starter switch is turned off. (SeeWindscreen
washer top-up) 
						

							Switches
60
DASHBOARD CENTRE CONSOLE SWITCHES
The following switches are located on the
centre console between the driver and front
seat passenger:
Front fog lights
Press to switch on and off; the
switch illuminates while the lights
are switched on.
The lights operate only with the starter switch
in position II and the headlights switched on
(low beam only). Note that the fog lights
extinguish automatically if the headlights are
changed to main beam, and will have to be
re-selected if the headlights or the starter
switch have been turned off.
DO remember to switch off as soon as
visibility is clear.
Rear fog guard lights
Press to switch on and off; the
switch illuminates while the lights
are switched on. The rear fog guard lights will
operate only when the starter switch is in
position II, and when the headlights are
switched on.
Note that the fog guard lights will have to be
reselected if the headlights have been turned
off.
REMEMBER:In clear conditions rear fog
guard lights can dazzle other road users. Use
only when visibility is severely restricted;
Hazard warning lights
Press to operate; all the direction
indicators, including those fitted
to a trailer, will flash in conjunction with each
other.
Use ONLY in an emergency to warn other
road users when your stationary vehicle is
causing an obstruction, or is in a hazardous
situation. Remember to switch off before
moving away.
NOTE:The functions of the electronic air
suspension system switches are described
under Air suspension. The cruise control
master switch is described under Cruise
control. 
						

							Switches
61
STEERING WHEEL SWITCHES
The following switches are located on the
steering wheel:
Cruise control
The functions of the cruise control switches
SET+ and RES are described underCruise
control.
Mode switch
Press the MODE switch to select
either: radio, tape, or CD player
(seeIn-car entertainment).
Seek/search forward
Press to select the NEXT preset
station on the selected
waveband. When tape or CD player are being
used, seek/search is used to select the next
track.
Seek/search backward
Press to select the PREVIOUS
preset station on the selected
waveband. When tape or CD player are being
used, seek/search is used to select the
previous track.
Volume up
Press the positive switch to
increase the volume.
Volume down
Press the negative switch to
decrease the volume.
Horn
To operate the horn press one of the horn
symbols on the edge of the steering wheel
pad. 
						

							Electric windows
62
The switches on the centre console operate
the following windows:
1.Right hand front window.
2.Left hand front window.
3.Right hand rear window.
4.Left hand rear window.
5.Switch to isolate rear door window
switches (when carrying children).
NOTE:Rear windows can also be operated by
individual window switches mounted on each
rear door, provided the isolation switch is not
activated.Operating the windows
The electric windows can be operated when
the starter switch is in position I or II and
for up to 45 seconds after the starter switch is
turned off (provided neither front door is
opened in the meantime).
NOTE:Only manual mode (not one-touch) is
available for the 45 second period(s).
Press and hold the lower part of a switch to
lower and the upper part to raise the window.
The window will stop moving as soon as the
switch is released.
WARNING
Accidental closing of a window on fingers,
hands or any vulnerable part of the body,
can result in serious personal injury.
Always observe the following precautions:
·ISOLATE the rear window switches when
carrying children.
·ENSURE children are kept clear when
raising or lowering a window.
·NEVER leave children alone in the
vehicle.
·ENSURE that all adult passengers are
fully familiar with the controls and the
potential dangers of
electrically-operated windows.
·ENSURE the anti-trap function is
activated (see overleaf). 
						

							Electric windows
63 One-touch up & down
By briefly pressing and then releasing a switch
(within
1/2second), a window can be opened
or closed at a single touch. Window
movement can be stopped at any time by
pressing the opposing side of the switch.
Anti-trap function
The anti-trap function is a safety feature
which prevents a window from closing when
an obstruction is sensed (WINDOW
BLOCKED appears in the message centre). It
is recommended that this is set at all times,
but particularly when carrying children.
NOTE:If the one-touch and anti-trap
functions have not been set, an audible
warning sounds and WINDOW NOT SET is
displayed in the message centre whenever a
window is closed and also whenever the
starter switch is turned on or off.Setting the one-touch & anti-trap
functions
If the battery has been disconnected, it will be
necessary to reset the one-touch and
anti-trap functions on each window, using
the following procedure:
1.FULLY open and close each window in
one continuous operation (note that as the
window is closing, an audible warning
sounds and WINDOW NOT SET is
displayed in the message centre).
2.Once the window has been fully opened
and closed, an audible warning sounds
and WINDOW SET (together with a
window identifier message) is displayed in
the message centre.
The one-touch and anti-trap functions will
now be operational.
NOTE:The one-touch up function is
available on front windows only. 
						

							Electric windows
64 Overriding the anti-trap function
Under certain conditions, you may wish to
override the anti-trap function. If, for
example, you attempt to operate the windows
with the operating mechanism partially frozen,
the anti-trap function may falsely sense a
trap situation and fail to close the window
(always clear any ice from the window to
prevent overloading the operating
mechanism).
The anti-trap function can be overridden as
follows:
1.Using the centre console switches only,
press and hold the upper part of the
appropriate window operating switch
within 10 seconds of the window backing
off (after it has falsely sensed a trap
situation).
2.Continue to hold the switch until the
window is either closed or has reached the
desired position (note that as the window
is closing, an audible warning sounds and
ANTI-TRAP OFF is displayed in the
message centre).
NOTE:The anti-trap function will be
operational again, as soon as the window
operating switch is released.Rear window isolation switch
Press the bottom of the switch to isolate the
rear window controls (a tone will sound and
the message centre displays REAR
WINDOWS OFF); press the top of the switch
to restore independent control.
Always isolate the rear window switches when
carrying children. 
						

							Electric sunroof
65
The sunroof can be operated when the starter
switch is in position I or II and for up to 45
seconds after the starter switch is turned off
(provided neither front door is opened in the
meantime).
NOTE:Only manual mode (not one-touch) is
available for the 45 second period(s).
NOTE:The sunroof blind can be opened and
closed manually, but will retract automatically
when the sunroof is opened.The sunroof opens and closes in two separate
phases as follows:
To TILT the roof:
With the sunroof closed, press and hold the
lower part of the switch, releasing when the
sunroof is at the desired angle. Press and hold
the upper part of the switch to close the
sunroof.
To OPEN the roof:
Press and hold the upper part of the switch,
releasing when the sunroof is in the desired
position. Press and hold the lower part of the
switch to close the sunroof.
WARNING
Accidental closing of a sunroof on fingers,
hands or any vulnerable part of the body,
can result in serious personal injury.
Always observe the following precautions:
·ENSURE that passengers are kept clear
when closing the sunroof.
·NEVER leave children alone in the
vehicle.
·ENSURE that all adult passengers are
fully familiar with the controls and the
potential dangers of operating an
electrically-operated sunroof.
·DO NOT allow passengers to extend any
part of their bodies through the sunroof
while the vehicle is moving.
·ENSURE the anti-trap function is
activated whenever possible.
·DO NOT operate the sunroof in freezing
conditions or when the roof panel is
covered with ice or snow. 
						

							Electric sunroof
66 One-touch operation
Briefly press and then release the upper part
of the switch (within
1/2second): The sunroof
will open to a pre-set position which
minimises air turbulence (and noise) within
the vehicle. To fully open the sunroof, press
and release the switch for a second time.
Press and release the lower part of the switch
(within
1/2second) to close the sunroof at a
single touch.
Sunroof movement can be stopped at any
time by pressing the opposing part of the
switch.
Anti-trap function
The anti-trap function is a safety feature
which prevents the sunroof from closing
when an obstruction is sensed (message
centre shows SUNROOF BLOCKED). It is
recommended that this is set at all times, but
particularly when carrying children.
NOTE:If the one-touch and anti-trap
functions have not been set, an audible
warning sounds and SUNROOF NOT SET is
displayed in the message centre whenever the
sunroof is operational and also whenever the
starter switch is turned on or off.
Setting the one-touch & anti-trap
functions
If the battery has been disconnected, it will be
necessary to reset the one-touch and
anti-trap functions using the following
procedure.
1.FULLY open and close and then FULLY tilt
and close the sunroof in one continuous
operation; an audible warning sounds, and
SUNROOF NOT SET is displayed in the
message centre whilst the sunroof is in
motion.2.Once this operation has been successfully
completed, an audible warning sounds
and SUNROOF SET is displayed in the
message centre.
The one-touch and anti-trap functions will
now be operational.
Overriding the anti-trap function
Under certain conditions you may wish to
override the anti-trap function. If, for
example, you attempt to operate the sunroof
with the operating mechanism partially frozen,
the anti-trap function may falsely sense a
trap situation and fail to close the sunroof (it
is recommended that you clear any ice from
the sunroof to prevent overloading the
operating mechanism).
The anti-trap function can be overridden as
follows:
1.Press and hold the appropriate (upper or
lower) part of the switch within 10
seconds of the sunroof backing off (after it
has sensed a trap situation).
2.Continue to hold the switch until the
sunroof is closed; an audible warning
sounds and ANTI-TRAP OFF and
SUNROOF are displayed in the message
centre.
The anti-trap function will be operational
again, as soon as the switch is released.
Leaving the vehicle
The message centre will show SUNROOF
OPEN if the starter key is removed and the
drivers door opened with the sunroof still
open.
If you are leaving the vehicle ALWAYS close
the sunroof. 
						

							Electric sunroof
67
Emergency operation
If sunroof operation should fail, first check the
fuse and renew if necessary.
If necessary, the emergency operating key
(stowed in the glovebox) can be engaged in
the sunroof motor spindle and used to
manually turn the spindle clockwise to close
the sunroof (see illustration).
The spindle is accessible by prising the front
courtesy light unit from the headlining.
On completion of manual operation, the
spindle must be turned back one quarter of a
turn to re-engage the drive mechanism.