Kyocera TASKalfa 181 User Manual

Troubleshooting
6-10
Notes
• Do not reuse jammed paper.
• If paper is torn during removal, be sure to remove any loose scraps of paper from inside the machine. Failure to do so may cause another paper jam later.
• Once all jammed paper has been removed, warm-up will begin. The error message will  disappear and the machine will return to the same settings as prior to the paper jam.
Removal Procedures
Paper Jam inside Cassette 1
If Paper misfeed in cassette 1. Remove 
paper  appears and the jam location...

Troubleshooting6-11
Notes• Check to see if paper is out of position in the cassette. If the paper is out of position, set the paper properly.
•If  JAM21  is displayed, remove the  jammed paper referring to  Paper Jam in the Left Cover  on 
page 6-13.
Paper Jam inside Cassettes 2 to 4
If Paper misfeed in cassette 2 (to  4). 
Remove paper [ Misfeed in paper cassette 2  
(to  4). Remove paper] and  Paper misfeed. 
Open left cover 2 (to  4) and remove paper 
appears and the jam location indicator shown in...

Troubleshooting
6-12
4Pull out the cassette.
5Remove any jammed paper without tearing it.
NoteIf the paper does happen to tear, remove any loose scraps from inside the machine.
6Push the cassette back in firmly.
Paper Jam in the Multi-Purpose Tray (JAM10)
If Paper misfeed in stack bypass. Remove 
paper  appears and the jam location indicator shown in 
the illustration blinks, a paper jam has occurred in the 
multi-purpose tray. Perform the following procedure to 
remove the jammed paper.
1Remove all of...

Troubleshooting6-13
Paper Jam in the Multi-Purpose Tray (except JAM10)
Important!•If JAM20 is displayed, remove the  jammed paper referring to Paper Jam in the Left Cover .
•If  JAM40 is displayed, remove the  jammed paper referring to Paper Jam in the Left Cover .
• When removing jammed paper, do not pull  it out from the multi-purpose tray side.
Paper Jam in the Left Cover
If Paper misfeed. Open left cover and 
remove paper appears and the jam location indicator 
shown in the illustration blinks, a...

Troubleshooting
6-14
3If the optional duplex unit is installed, raise the duplex 
unit and remove any paper.
NoteIf the paper does happen to tear, remove any loose scraps from inside the machine.
4Close the left cover.
Paper Jam in the Paper Output Slot
If Paper  misfeed in Eject section Remove 
paper  appears and the jam location indicator shown in 
the illustration blinks, a paper jam has occurred in the 
paper output slot. Perform the following procedure to 
remove the jammed paper.
Important!The drum...

Troubleshooting6-15
3Remove any jammed paper without tearing it.
NoteIf the paper does happen to tear, remove any loose scraps from inside the machine.
4Close the left cover.
Paper Jam in the Optional Document Processor
If Misfeed in DP. Remove original(s)  appears 
and the jam location indicator shown in the illustration 
blinks, a paper jam has occurred in the optional 
document processor. Perform the following procedure 
to remove the ja mmed original(s).
1Remove all of the originals remaining in the...

Troubleshooting
6-16
4Raise the paper feed unit A.
5Remove any jammed originals without tearing them.
NoteIf the original does happen to tear, remove any  loose scraps from inside the document processor.
6Turn the dial as shown in the illustration to remove the 
jammed original.
7Close the left cover to its original position.
Reset all the originals and start copying again.
Paper Jam in the Optional Finisher
If  Paper misfeed in Finisher, lower 
Process Tray and remove paper  appears and 
the jam...

Troubleshooting6-17
2Remove any paper.
3Raise the process tray.
4Remove the finisher tray.
5Pull the left cover handle up to open the left cover.
6Remove any jammed paper.
NoteIf the paper does happen to tear, remove any loose scraps from inside the machine.
Downloaded From ManualsPrinter.com Manuals 

Troubleshooting
6-18
7Close the left cover.
8Reattach the finisher tray.
9Lower the process tray temporarily and return it. The error message disappears.
Paper Jam in the Optional Job Separator
If Paper misfeed at Job separator. Remove 
paper  appears and the jam location indicator shown in 
the illustration blinks, a paper jam has occurred in the 
optional job separator. Perform the following procedure 
to remove the jammed paper.
Important!The drum section inside the main body is sens itive to...

Troubleshooting6-19
3Remove any jammed paper without tearing it.
NoteIf the paper does happen to tear, remove any loose scraps from inside the machine.
4Close the left cover.
Downloaded From ManualsPrinter.com Manuals