Kyocera FS 2020D User Manual

COMMAND CENTER Pages
Operation Guide 47
user’s settings on the basic page, and the users document box and shared document 
box pages. 
Advanced > Management > Notificat ion/Maintenance > Maintenance 
Notification
This feature defines the recipient of maintenance information reports.
Advanced > Management > Main tenance Notification > Job Log 
Notification
This feature defines the Job Log  Notification information reports.
Item
Description
Equipment ID This is the name by which 
the machine will be...

COMMAND CENTER Pages
48KYOCERA COMMAND CENTER
Advanced > Security > Secure Protocols
You can encrypt communication between a PC and this machine using SSL encryption. 
After you have changed this setting, you must restart this machine. For the restarting 
procedure, refer to Basic > Defaults > Reset  on page 9.
Auto Sending
Determines whether the job log report is sent or not. Set this 
to 
On  to send the report.
Max Job Log Set the number of job logs for sending, from 1 to 1500.
Run once now You can...

COMMAND CENTER Pages
Operation Guide 49
NOTE: When the SSL is set to On and HTTP Security is set to Secure (HTTPS), the 
document boxes cannot be accessed the TWAIN driver.
Advanced > Security > IEEE802.1x
The IEEE802.1x security protocol allows the user to login to the secured networks based 
on the client certificates.
Advanced > Security > IPSec > General
This page allows you to set access restrictions for IPSec protocol-based communication.
ItemDescription
IEEE802.1x Specifies whether or not to 
use...

COMMAND CENTER Pages
50KYOCERA COMMAND CENTER
Advanced > Security > IPSec > Rule1 (to Rule3)
These pages allow you to select or edit rules to use for IPSec protocol-based communication.
Authentication 
Ty p eSpecifies the authentication type
 used for IKE phase1. To set 
a character string as the shared key and use it for 
communication, select  Pre-shared and enter the string of 
the pre-shared key in the text box. To use a CA-issued 
device certificate or root certificate, select  Certificates.
When...

COMMAND CENTER Pages
Operation Guide 51
ProtocolSelect ESP or AH for the protocol. ESP protects the privacy 
and integrity of the packet contents. Select the hash algorithm 
and encryption algorithm below. 
AH protects the integrity of 
the packet contents using encryption checksum. Select the 
hash algorithm below.
HashSelects the hash algorithm.
EncryptionSelects the encryption algorithm. (When ESP is selected 
under 
Protocol.)
PFSWhen PFS is set to On (enabled), even if a key is decrypted, 
the...

Troubleshooting
52KYOCERA COMMAND CENTER
4 Troubleshooting
Consult the table below to find basic solutions for problems you may encounter with 
COMMAND CENTER.
Symptom Check Items Corrective Action Reference
I can’t access 
COMMAND 
CENTER. Is the power turned on 
to this machine?
Turn the power on to 
this machine, wait until 
it is a ready state, and 
try to access 
COMMAND CENTER. Operation 
Guide
Is the network cable 
properly connected? Connect the network 
cable properly. Operation 
Guide
Are the...

Troubleshooting
Operation Guide 53
Characters do 
not display 
properly in 
COMMAND 
CENTER.Does the version of 
your browser 
application support 
operation using 
COMMAND 
CENTER? Use a browser 
application that 
supports COMMAND 
CENTER.
page 1
Is the same language 
as that displayed on 
the operation panel 
selected? Select the same 
language as that 
displayed on the 
operation panel. page 9
I can’t access 
the other 
pages. Has the administrator 
set a password?
Enter the password.
page 12
I can’t...

Downloaded From ManualsPrinter.com Manuals 

    First Edition 2009.9
Downloaded From ManualsPrinter.com Manuals