Kyocera FS 2000D User Manual

							2F8/2F9/2GA
1-2-13
1-2-4  Installing the memory card or hard disk (optional)

1. Turn off the printer and disconnect the 
power cord and printer cable.
2. Remove the two screws and then open the 
option interface slot cover.
3. Install the memory card or hard disk into the 
memory slot.
4. Close the option interface slot cover.
Figure 1-2-17
Memory card slotMemory card o
rhard disk
Option interface
slot cover
Screw Screw
Downloaded From ManualsPrinter.com Manuals 
						

							2F8/2F9/2GA
1-2-14
1-2-5  Installing the network interface card (optional)

1. Turn off the printer and disconnect the 
power cord and printer cable.
2. Remove the two screws and then open the 
option interface slot cover.
3. Install the network interface card to the 
option interface slot.
4. Secure the network interface card by two 
screws.
Figure 1-2-18
Screw
Screw Option interface
slot cover Option interface slotNetwork interface card
Downloaded From ManualsPrinter.com Manuals 
						

							2F8/2F9/2GA-1
1-2-15
1-2-6  Installing the network interface card (optional for 30/31 ppm printer [EUR/USA model] only)

1. Turn off the printer and disconnect the 
power cord and printer cable.
2. Open the right side cover.
3. Remove the one screw and then open the 
inner cover.
Figure 1-2-19
4. Remove the two screws and then open the 
option interface slot cover.
Figure 1-2-20
Right side cover
Inner cover
Screw
Screw
Screw
Option interface slot cover
Downloaded From ManualsPrinter.com Manuals 
						

							2F8/2F9/2GA
1-2-165. Connect the relay cable connector to the 
network interface card connector.
6. Secure the relay cable to the clamp.
Figure 1-2-21
7. Install the network interface card to the 
option interface slot.
8. Put the relay cable connector through the 
hole.
9. Secure the network interface card by two 
screws.
 
Figure 1-2-22
Network interface card
Relay cable
Connector
Clamp
Connector
Relay
cable
connector
Option interface slotHole
Screw
Screw
Network interface card
Downloaded From ManualsPrinter.com Manuals 
						

							2F8/2F9/2GA
1-2-17 10. Connect the relay cable connector to the 
main PWB’s connector.
11. Close and secure the inner cover by one 
screw.
12. Close the right side cover.
Figure 1-2-23
Relay cable
connectorMain PWB
Inner cover
Connector
Downloaded From ManualsPrinter.com Manuals 
						

							2F8/2F9/2GA
1-2-18This page is intentionally left blank.
Downloaded From ManualsPrinter.com Manuals 
						

							2F8/2F9/2GA
1-3-1
1-3 Maintenance Mode1-3-1  Maintenance mode
The printer is equipped with a maintenance function which can be used to maintain and service the machine.
(1) Executing a maintenance item
>>Developer
>>Drum
>>DRUM-CTRL Ready
Print
Menu Map
Others >
>MSG Language
English
>Service >
>>Print
Status Page
>>Print
Event Log
>>Paper Feed
>>Maintenance

 Press the MENU key. Message display
To print a status page for service purpose.
To print an event log (EVENT LOG)
(Displayed when FRPO I1 is set to 1)
To set paper feed operation as printer driver
priority mode.
To reset counter for the maintenance kit.
To initialize the developer unit. (toner install mode)
To perform a automatic drum refreshing.
To perform a drum refreshing.  Press the 
 or  key several times
     until [Others >] is displayed.
Service mode items  Press the  key.
 Press the  key.  Press the 
 or  key several times
     until [>Service >] is displayed.
To scroll these items,
press the  or 
 key repeatedly.
(See page P.1-3-2)
(See page P.1-3-12)
(See page P.1-3-18)
(See page P.1-3-18)
(See page P.1-3-19)
(See page P.1-3-19)
(See page P.1-3-20)
Downloaded From ManualsPrinter.com Manuals 
						

							2F8/2F9/2GA-4
1-3-2Service items Description
Printing a status page for service purpose
Description
Prints a status page for service purpose. The status page includes various printing settings 
and service cumulative.
Purpose
To acquire the current printing environmental parameters and cumulative information.
Procedure
1. Enter the service mode [>>Print Status Page].
2. Press the OK key. [Print Status Page?] will be displayed.
3. Press the OK key. Two*
1/Five*2 pages will be printed. (The second page includes 
service information.
 *
1: 30/31 ppm printer (EUR/USA model)
  *2: 35/37 and 45/47 printer (EUR/USA model)
Figure 1-3-1Service status page
>>Print
Status Page
Released:  29/Aug/2006 Firmware version: 2F9_3000.008.002
/12.1( Toner Coverage(%) Average)/165868.2
/ 3.5( Toner Coverage(%)  Last Page)Toner Coverage
Firmware version: 2F9_3000.008.002
Service InformationReleased:  29/Aug/2006
/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/
/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/
/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/
/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/
/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/
/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/00000000/
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/00000000/00000000/00000000000000000000000000000000/00000000000000000000000000000000/0000/00/00/
DN:SPL9200007 SN:SPL9200010
[XXXXXXXX/XXXXXXXX][XXXXXXX][XXXXXXXX][01/00]                          Printed Page(s)           9690
/t/P00/S00/U00/F00/N00/D50:DM0301.DAN:0002001001210052
/0020/0020/1061/0811/   0/   0/   0/   0/   0/   0/   0/  0/  0/  0/  0/  0/  0/   0/
/AAAAAAA/
/AAAAAAA/AAAAAAA/AAAAAAA/
/AAAAAAA/
/AAAAAAA/AAAAAAA/AAAAAAA/
/AAAAAAA/
/AAAAAAA/
/003D/0005/0005/0005/0005/0000/
/0000/
/RS2/FF/00/[0003-0003]/81/31/50/50/0
00.00.00.00.00.00
A:1234567890123456
Main PWB firmware version Service information
(Refer to next page) Firmware release date
Toner coverage (Refer to next page)
Downloaded From ManualsPrinter.com Manuals 
						

							2F8/2F9/2GA-4
1-3-3 Toner coverage
Service information (30/31 ppm printer [EUR/USA model])
Detail of service information (30/31 ppm printer [EUR/USA model]) Service items Description
/ 3.1( Toner Coverage(%) Average)/379.6:
/ 1.1( Toner Coverage(%)  Last Page)
Toner Coverage
Toner coverage (%)
Toner coverage (%) of the page printed most previously. Number of pages printed coverted in reference to A4 or Letter size.
Service information
[XXXXXXXX/XXXXXXXX][XXXXXXX][XXXXXXXX][01/00]                          Printed pages(s)         9690
/t/P00/S00/U00/F00/N00/D50:DM0301.DAN:0002001001210052
/0020/0020/1061/0811/   0/   0/   0/   0/   0/  0/  0/  0/  0/
/AAAAAAA/
/AAAAAAA/AAAAAAA/
/AAAAAAA/
/AAAAAAA/
/AAAAAAA/
 
/003D/0000/
/0000/
/RS2/FF/00/[0003-0003]/81/31/50/50/0
XXXXXXXXXXXXXXXX/00.00.00.00.00.00
A:1234567890123456
/03030303/03030303/03030303/03000000/00000000/03030303/03030303/
SPD1:0203040508090A0B0C0D0F101112131415161718191A1B1C1D1E1F202122235E
/00/
/00000000000000000000000000000000/
8088808880808000/8088808880808000/8088808880808000/8088808880808000
8088808880808000/8088808880808000/8088808880808000/8088808880808000
8088808880808000/8088808880808000/8088808880808000/8088808880808000
8088808880808000/8088808880808000/8088808880808000/8088808880808000
8088808880808000/8088808880808000/8088808880808000/8088808880808000
8088808880808000/8088808880808000/8088808880808000/8088808880808000
8088808880808000/8088808880808000/8088808880808000/8088808880808000
8088808880808000/8088808880808000/8088808880808000/8088808880808000
00000000/00000000/00000000000000000000000000000000/00000000000000000000000000000000/0000/00/00
DN:SPL9200007  SN:SPL9200010


   
   









	
	






  

       
 	 
  
Downloaded From ManualsPrinter.com Manuals 
						

							2F8/2F9/2GA-2
1-3-4Service items Description
Code conversion
ABCDE F GHI J
0123456789
No.ItemsDescription
 
Engine ROM information[Flash ROM version]
 Operation panel ROM infor-
mation[Operation panel mask ROM version]
 Boot ROM information[Boot ROM version]
 Software jumper switch 
information
(hexadecimal)
[First byte/Second byte 
(displayed in OEM model 
only)]First byte
  bit 0 = 1: (Fixed)
  bit 1 = 0: Overseas, 1: Domestic (Japan)
  bit 2, 3 (Not used)
  bit 4 = 0: Kyocera, 1: OEM
  bit 5 = 0: For Europe, 1: For US
  bit 6 = 0: Non MICR mode, 1: MICR mode
  bit 7 (Not used)
 Second byte: Displayed in OEM model only
 To t a l  p a g e-
 Toner install information-
 Parallel I/O information-
 Serial information00: Not connected
bit0: Framing errorbit1: Overrun error
bit2: Parity error
 	USB information00: Not connected
01: Full-Speed
02: Hi-Speed
 
Operation panel lock sta-
tus (displayed only when 
locked)01: Partial lock
02: Full lock
 
NVRAM error (displayed 
only when any error has 
occurred)01: ID error
02: Version error03: Checksum error
04: NVRAM crush error
 

NVRAM download00: Normal
bit0: Font data
bit1: Host data
bit2: Macro data
bit3: Program data
bit4: Operation panel message data download (file name displayed)
bit5: OEM data
bit6: Web template data (version displayed)
bit7: Error occurred
 
Printable area setting/Top offset/Left offset/Page length/Page width
 
Left offset for each paper 
source/MP tray/Paper cassette1/Paper cassette 2/Duplex
(1/600 inches unit)
 
Top offset for each paper 
source/MP tray/Paper cassette 2/Duplex
(1/600 inches unit)
 
Offset for rotation/Top offset/Left offset/
(1/600 inches unit)
 
Paper source life counter/MP tray/
 
Paper source life counter/Cassette 1 total/Paper feeder 1 (cassette 2) total/
Downloaded From ManualsPrinter.com Manuals