Konica Minolta PagePro 5650EN User Manual
Have a look at the manual Konica Minolta PagePro 5650EN User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 61 Konica manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Finishing 111 Offset Printing If offset printing is selected, the paper is fed out shifted as shown below. When PAPER MENU/COLLATE is set to ON, the pages are fed out in sets as shown below. - When COLLATE is set to ON- When COLLATE is set to OFF 321321 321 333222 111 Downloaded From ManualsPrinter.com Manuals
Media Storage 112 Media Storage How do I store media? „Keep media on a flat, level surface in its original wrapper until it is time to load it. Media that has been stored for a long time out of its packaging may dry up too much and cause misfeeding. „If media has been removed from its wrapper, place it in its original pack- aging and store in a cool, dark place on a level surface. „Avoid moisture, excessive humidity, direct sunlight, excessive heat (above 35°C [95°F]), and dust. „Avoid leaning media against other objects or placing it in an upright posi- tion. Before using stored media, do a trial print to check print quality. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 114 Replacing Consumables Before replacing consumables, make sure that the power of the printer is turned off. Note Failure to follow instructions as outlined in this manual could result in voiding your warranty. Note If an error message (TONER OUT, FUSER UNIT END OF LIFE, etc.) appears, print out the configuration page, and then check the status of the consumables. For details on the error messages, refer to “Error Messages (Warning:)” on page 182. For details on printing the configuration page, refer to “Printing a Configuration Page” on page 150. About toner cartridge This printer uses a toner cartridge that includes the toner and the photosensi- tive drum. If the output image is light or blurred, the toner cartridge may be defective or damaged. In that case, you need to replace it with a new one. Handle the toner cartridge carefully to avoid spilling toner inside the printer or on yourself. Install only a new toner cartridge in your printer. If a used toner car- tridge is installed, the indicator message will not clear and the supplies status in the Status Monitor will not be updated. The toner is nontoxic. If you get toner on your skin, wash it off with cool water and a mild soap. If you get toner on your clothes, lightly dust them off as best as you can. If some toner remains on your clothes, use cool, not hot water, to rinse the toner off. CAUTION If you get toner in your eyes, wash it out immediately with cool water and consult a doctor. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 115 Refer to the following URL for recycling information. US: printer.konicaminolta.net/products/recycle/index.asp Europe: www.konicaminolta.eu/printing-solutions/more-information/ clean-planet.html Other regions: printer.konicaminolta.com Note Do not use refilled toner cartridges or unapproved toner cartridges. Any damage to the printer or quality problems caused by a refilled toner cartridge or an unapproved toner cartridge will void your warranty. No technical support is provided to recover from these problems. When replacing a toner cartridge, refer to the following table. For optimum print quality and performance, use only approved KONICA MINOLTA toner cartridge for your specific printer type, as listed in the table below. You can find your printer type and the toner cartridge part numbers on the consum- ables reorder label inside the front cover your printer. For optimum print quality and performance, use only the corre- sponded TYPE genuine KONICA MINOLTA toner cartridge. Keep toner cartridges: „In their packaging until you’re ready to install them. „In a cool, dry location away from sunlight (due to heat). Printer Ty p ePrinter Parts NumberToner Cartridge Type Toner Cartridge Parts Number AM A0DX 011 (pagepro 4650EN)Standard-Capacity Toner Cartridge - Black (K) A0FN 011 High-Capacity Toner Cartridge - Black (K) A0FN 012 A0DX 012 (pagepro 5650EN)Standard-Capacity Toner Cartridge - Black (K) A0FP 011 High-Capacity Toner Cartridge - Black (K) A0FP 012 EU A0DX 021 (pagepro 4650EN)Standard-Capacity Toner Cartridge - Black (K) A0FN 021 High-Capacity Toner Cartridge - Black (K) A0FN 022 A0DX 022 (pagepro 5650EN)Standard-Capacity Toner Cartridge - Black (K) A0FP 021 High-Capacity Toner Cartridge - Black (K) A0FP 022 AP A0DX 041 (pagepro 4650EN)Standard-Capacity Toner Cartridge - Black (K) A0FN 041 High-Capacity Toner Cartridge - Black (K) A0FN 042 A0DX 042 (pagepro 5650EN)Standard-Capacity Toner Cartridge - Black (K) A0FP 041 High-Capacity Toner Cartridge - Black (K) A0FP 042 Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 116 The maximum storage temperature is 35°C (95°F) and the maximum storage humidity is 85% (noncondensing). If the toner cartridge is moved from a cold place to a warm, humid place, condensation may occur, degrading print quality. Allow the toner to adapt to the environment for about one hour before use. „Level during handling and storage. Do not hold, stand or store a cartridge on its ends or turn it upside down; the toner inside the cartridge may become caked or unequally distributed. „Away from salty air and corrosive gases such as aerosols. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 117 Replacing a Toner Cartridge Note Be careful not to spill toner while replacing a toner cartridge. If toner spills, immediately wipe it off with a soft, dry cloth. If TONER LOW on the SYS DEFAULT MENU/ENABLE WARNING is set to ON, the message TONER LOW appears when the toner cartridge becomes near empty. Follow the steps below to replace the toner cartridge. If TONER LOW on the SYS DEFAULT MENU/ENABLE WARNING is set to OFF, you are advised to replace the toner cartridge when the message TONER OUT appears. 1Open the top cover. 2Hold the toner cartridge by the grip, and then pull it out slowly. 3Take the new toner cartridge out of the box. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 118 4Holding it firmly with both hands, rock the toner cartridge left and right, forward and backward, to distribute the toner evenly. Do not touch the devel- oping roller of the toner cartridge; otherwise image quality may decrease. 5Placing the toner cartridge on a flat surface, pull out the seal hor- izontally. 6Hold the toner cartridge by the grip, and then insert it into the slot inside the printer. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 119 7Close the top cover securely. Note Dispose of the used toner cartridge according to your local regulations. Do not burn the toner cartridge. For details, refer to “About toner cartridge” on page 114. Replacing the Fuser Unit When it is time to replace the fuser unit, the message FUSER UNIT END OF LIFE appears. Printing can continue even after this message appears; however, since the print quality is reduced, the fuser unit should be replaced immediately. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 120 1Turn off the printer and discon- nect the power cord. There are extremely hot parts within the machine. Before replacing the fuser unit, wait about 30 minutes after turning off the machine, and then check that the fusing sec- tion has reached room temperature; otherwise, you may get burnt. 2Lift the lever shown in the figure. 3Open the rear cover. Do not touch any parts inside the printer. Downloaded From ManualsPrinter.com Manuals