Konica Minolta PagePro 5650EN User Manual

Replacing Consumables 131
Replacing the Feed Roller (inside the Printer)
1Open the top cover.
Do not touch any parts 
inside the printer.
2Hold the toner cartridge by the 
grip, and then pull it out slowly.
3While pushing down the shaft of 
the feed roller, widen the tab of 
the feed roller to loosen it (1) 
and then slowly remove the feed 
roller from the shaft on the tray 
(2).
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 132
4Hold the tab on the new feed 
roller and slowly push it into the 
shaft on the tray.
5Aligning the small tabs on the 
feed roller with the slots of the 
shaft, push the feed roller com-
pletely in so that the tab fits into 
the slot.
6Hold the toner cartridge by the 
grip, and then insert it into the 
slot inside the printer.
Do not touch any parts 
inside the printer.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 133
7Close the top cover securely.
Replacing the Backup Battery
When the backup battery is at its end of life, the printers date and time cannot 
be retained. Follow the procedure described below to replace the backup bat-
tery.
Note
Only use the coin-shaped 3V lithium battery CR2032. It’s very important 
to protect the printer controller board and any associated circuit boards 
from electrostatic damage. Before performing this procedure, review 
the antistatic caution on page 219....

Replacing Consumables 134
2Using a screwdriver, loosen the 
screw of the right cover, located 
at the rear side.
3Remove the right side cover.
4Using a screwdriver, loosen the 
two screws. (Do not remove 
them from the printer.)
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 135
5Remove the panel.
6Remove the backup battery.
7Insert a new backup battery.
When inserting the new 
backup battery, be sure 
that the + side faces 
front.
Risk of explosion if bat-
tery is replaced by an 
incorrect type.Dispose of 
used batteries according 
to your local regulations. 
Do not burn the backup 
battery.
8Reinstall the panel and tighten the two screws.
9Attach the right side cover.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 136
10Reconnect all interface cables.
11Reconnect the power cord, and 
turn on the printer.
12Use DATE on the SYS DEFAULT MENU/CLOCK menu to set the date, 
and use 
TIME on the SYS DEFAULT MENU/CLOCK menu to set the 
time.
Downloaded From ManualsPrinter.com Manuals 

Maintaining the
Printer
Downloaded From ManualsPrinter.com Manuals 

Maintaining the Printer 138
Maintaining the Printer
CAUTION
Read all caution and warning labels carefully, making sure to follow any 
instructions contained in them. These labels are located on the inside of 
the printer’s covers and the interior of the printer body.
Handle the printer with care to preserve its life. Abuse handling may cause 
damage and void your warranty. If dust and paper scraps remain on the 
inside or outside of the printer, printer performance and print quality will suffer, 
so the...

Maintaining the Printer 139
„Do not leave the printer’s covers open for any length of time, especially in 
well-lit places; light may damage the toner cartridges.
„Do not open the printer during printing.
„Do not tap media stacks on the printer.
„Do not lubricate or disassemble the printer.
„Do not tilt the printer.
„Do not touch the electrical contacts, gears, or laser devices. Doing so 
may damage the printer and cause the print quality to deteriorate.
„Keep media in the output tray at a minimum level....

Cleaning the Printer 140
CAUTION
If you get toner in your eyes, wash it out immediately with cool water 
and consult a doctor.
„Make sure any parts removed during cleaning are replaced before you 
plug in the printer.
Cleaning the Printer
CAUTION
Be sure to turn off the printer and unplug the power cord before 
cleaning.
Exterior
Control Panel Ventilation Grill
Printer Exterior
Downloaded From ManualsPrinter.com Manuals