Konica Minolta magicolor 2550DN User Manual

Loading Media 67
Note
Since a media misfeed or 
decreased print quality may 
occur, be sure to return the levers 
on the fuser unit to the setting for 
plain paper before printing on 
media other than envelopes.
9Carefully close the top cover.
!Before printing on media 
other than envelopes, be 
sure to move the fuser 
separator levers on the 
fuser unit to its original 
position.
Downloaded From ManualsPrinter.com Manuals 

Loading Media 68
Loading Labels/Postcard/Thick Stock/Glossy Stock and 
Transparency
1Remove the lid from Tray 1, and 
then open the front panel of 
Tray 1.
2Remove any media from the tray.
3Slide the media guides to pro-
vide more space between them.
4Load the media face up in the 
tray.
!Up to 50 sheets can be 
loaded into the tray at 
one time.
Downloaded From ManualsPrinter.com Manuals 

Loading Media 69
5Slide the media guides against 
the edges of the media.
6Close the front panel of Tray 1 
tray, and then reattach the lid.
Tray 2
Loading Plain Paper
1Pull out Tray 2 as far as possi-
ble.
Downloaded From ManualsPrinter.com Manuals 

Loading Media 70
2Lift up Tray 2 to remove it.
3Remove the lid from Tray 2.
4Press down the media pressure 
plate to lock it into place.
Downloaded From ManualsPrinter.com Manuals 

Loading Media 71
5Load the paper face up in the 
tray.
!Do not load above the 
100% line. Up to 500 
sheets (80 g/m
2 [22 lb]) of 
plain paper can be 
loaded into the tray at 
one time.
6Reattach the lid to Tray 2.
1
0
0%
7
5
5
0
Downloaded From ManualsPrinter.com Manuals 

Loading Media 72
7Reinsert Tray 2 into the printer.
Downloaded From ManualsPrinter.com Manuals 

Duplexing 73
Duplexing
Select paper with high opacity for duplex (double sided) printing. Opacity 
refers to how effectively paper blocks out what is written on the opposite side 
of the page. If the paper has low opacity (high translucency), then the printed 
data from one side of the page will show through to the other side. Check 
your application for margin information. For best results, print a small quantity 
to make sure the opacity is acceptable.
Duplex (Double sided) printing can be done...

Output Tray 74
In addition, if “N-up” has been set to “Booklet”, autoduplex printing is per-
formed.
The following Order settings are available when “Booklet” is selected.
1Load plain paper into the tray.
2From the printer driver, specify the layout for duplex printing.
3Click OK.
!With autoduplexing, the back side is printed first, and then the front 
side is printed.
Output Tray
All printed media is output to the face-down output tray on top of the printer. 
This tray has a capacity of approximately...

Media Storage 75
Media Storage
How do I store media?
#Keep media on a flat, level surface in its original wrapper until it is time to
load it.
Media that has been stored for a long time out of its packaging may dry up 
too much and cause misfeeding.
#If media has been removed from its wrapper, place it in its original pack-
aging and store in a cool, dark place on a level surface.
#Avoid moisture, excessive humidity, direct sunlight, excessive heat (above 
35°C [95°F]), and dust.
#Avoid media leaning...

Downloaded From ManualsPrinter.com Manuals