Konica Minolta magicolor 1690MF User Manual

Replacing Consumables 7-18
Note
Do not touch the wires and flat 
cable shown in the illustration.
3Push the blue handles back as 
far as possible.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables7-19
4Grab the blue handles and lift 
the fuser unit to remove it.
Note
Do not touch the matching 
connectors of the fuser unit 
and the machine. 
M
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 7-20
5Prepare a new fuser unit.
6Pull the fuser separator levers 
forward as far as possible.
7Remove the fuser separator 
material, and then return the 
fuser separator levers to their 
original positions.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables7-21
Note
Be careful not to touch the paper exit sensor and the surface of the 
fuser roller in the fuser unit.
8While lifting the fuser unit with 
the blue handles (one on each 
side), vertically insert the fuser 
unit.
M
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 7-22
Note
Do not touch the paper exit 
sensor on the fuser unit. 
Note
Do not touch the matching 
connectors of the fuser unit 
and the machine. 
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables7-23
9After the fuser unit is firmly 
installed, flip the blue handles 
down toward you. 
10Carefully close the scanner unit.
Note
Do not touch the wires and flat 
cable shown in the illustration.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 7-24
11Reconnect the power cord, and 
turn on the machine.
Downloaded From ManualsPrinter.com Manuals 

8Maintenance
Downloaded From ManualsPrinter.com Manuals 

Maintaining the Machine 8-2
Maintaining the Machine
CAUTION
Read all caution and warning labels carefully, making sure to follow any 
instructions contained in them. These labels are located on the inside of 
the machine’s covers and the interior of the machine body.
Handle the machine with care to preserve its life. Abuse handling may cause 
damage and void your warranty. If dust and paper scraps remain on the 
inside or outside of the machine, machine performance and print quality will 
suffer, so the...

Maintaining the Machine8-3
„Do not cover the machine immediately after using it. Turn it off and wait 
until it cools down.
„Do not leave the machine’s covers open for any length of time, especially 
in well-lit places; light may damage the toner cartridges.
„Do not open the machine during printing.
„Do not tap media stacks on the machine.
„Do not lubricate or disassemble the machine.
„Do not tilt the machine.
„Do not touch the electrical contacts, gears, or laser devices. Doing so may 
damage the...