Konica Minolta magicolor 1690MF User Manual

Scanning With the Machine 6-28
Setting the Scan Size
The size of the scan data can be specified.
The default setting is LETTER for USA and Canada, and A4 for other 
countries.
1In the main screen (Scan mode), press the + or , key to select the cur-
rent scan size setting, and then press the Select key.
2Press the + or , key to select the desired size, and then press the Select 
key.
The main screen (Scan mode) appears again.
Setting the Scan Color
The color of the scan data can be specified.
1In the...

Scanning With the Machine6-29 Deleting a Queued Transmission Job
The list of jobs queued for transmission can be displayed, and a job can be 
deleted.
1In the main screen (Scan mode), press the + or , key to select CANCEL 
RESERV
., and then press the Select key.
2Press the + or , key to select the job to be deleted, and then press the 
Select key.
To check the information for the selected job, press the ) key.
If no jobs are queued for transmission, NONE appears.
3Press the + or , key to select YES,...

Scanning With the Machine 6-30
Downloaded From ManualsPrinter.com Manuals 

7Replacing
Consumables
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 7-2
Replacing Consumables
Note
Failure to follow instructions as outlined in this manual could result in 
voiding your warranty.
Note
If an error message (TONER OUT, I/C LIFE END, etc.) appears, print 
out the configuration page, and then check the status of the other 
consumables. For details on the error messages, refer to “Error Messages” 
on page 9-39. For details on printing the configuration page, refer to 
“Printing a Configuration Page” on page 9-3.
About Toner Cartridges...

Replacing Consumables7-3
Note
Do not use refilled toner cartridges or unapproved toner cartridges. Any 
damage to the machine or quality problems caused by a refilled toner 
cartridge or an unapproved toner cartridge will void your warranty. No 
technical support is provided to recover from these problems.
When replacing a toner cartridge, refer to the following table. For optimum 
print quality and performance, use only approved KONICA MINOLTA toner 
cartridges for your specific machine type, as listed...

Replacing Consumables 7-4
For optimum print quality and performance, use only the corre-
sponded TYPE genuine KONICA MINOLTA toner cartridges.
Keep toner cartridges: 
„In their packaging until you’re ready to install them.
„In a cool, dry location away from sunlight (due to heat). 
„The maximum storage temperature is 35°C (95°F) and the maximum stor-
age humidity is 85% (noncondensing). If the toner cartridge is moved from 
a cold place to a warm, humid place, condensation may occur, degrading 
print...

Replacing Consumables7-5 Replacing a Toner Cartridge
Note
Be careful not to spill toner while replacing a toner cartridge. If toner 
spills, immediately wipe it off with a soft, dry cloth.
If 
MACHINE SETTING/TONER OUT STOP in the UTILITY menu is set to 
ON, the message TONER OUT/CHANGE X TONER (where “X” indicates 
the color of the toner) appears when the toner cartridge is nearly empty. Fol-
low the steps below to replace the toner cartridge.
If MACHINE SETTING/TONER OUT STOP in the UTILITY menu 
is...

Replacing Consumables 7-6
6Open the front cover.
Before opening the front 
cover, open Tray 1 if it is 
not already open.
7Check that the toner cartridge to be replaced has been moved to the front.
You can identify the toner cartridge by the color of the handle.
8Pull down the handle on the 
toner cartridge until the toner 
cartridge is unlocked and moves 
out slightly toward you.
Remove the toner cartridge.
Do not manually rotate 
the toner cartridge carou-
sel. In addition, do not 
rotate the...

Replacing Consumables7-7
Note
Do not touch the contact 
indicated in the illustration.
Note
Dispose of the empty toner cartridge according to your local 
regulations. Do not burn the toner cartridge.
For details, refer to “About Toner Cartridges” on page 7-2.
9Check the color of the new toner cartridge to be installed.
10Remove the toner cartridge from the bag.
11Shake the cartridge a few times 
to distribute the toner.
Make sure that the toner 
roller cover is securely 
attached before shaking 
the...