Konica Minolta magicolor 1600W User Manual

Cleaning the Printer 6-4
Cleaning the Printer
CAUTION
Be sure to turn off the printer and unplug the power cord before 
cleaning. However, be sure to turn on the printer when cleaning the 
print head window.
Exterior
YMCK
Ready
Rotate
TonerError
Clear
Control Panel Ventilation Grille
Printer Exterior
Downloaded From ManualsPrinter.com Manuals 

Cleaning the Printer6-5
Interior
Cleaning the Media Feed Roller
1Open the top cover.
If there is paper in the 
output tray, remove it, 
and then fold up the out
-
put tray before opening 
the top cover.
2Grab the handle and lift it up 
slightly to the back, and then 
slowly pull the imaging cartridge 
out vertically.
Downloaded From ManualsPrinter.com Manuals 

Cleaning the Printer 6-6
Note
Do not touch the PC drum on the imaging cartridge. 
Position the removed imaging 
cartridge horizontally as shows in 
the illustration at the right.
 
Be sure to keep the imaging 
cartridge horizontal and place it 
where it will not become dirty.
 
Do not leave the imaging 
cartridge removed for more than 
15 minutes, and do not place the 
removed imaging cartridge in a 
location where it would be 
exposed to direct light (such as 
sunlight).
3Clean the media feed rollers by...

Cleaning the Printer6-7
CAUTION
The area around the fuser unit is 
extremely hot. 
 
Touching anything other than the 
indicated levers may result in 
burns. If you get burned, 
immediately cool the skin under 
cold water, and then seek 
professional medical attention.
 
 
 
 
 
 
 
Note
Decreased print quality may 
result if the surface of the 
transfer roller is touched.
 
Be careful not to touch the 
surface of the transfer roller.
 
 
 
 
 
 
 
 
 
 
 
 
BOTTOM
VIEW
Downloaded From ManualsPrinter.com...

Cleaning the Printer 6-8
4Slowly insert the imaging car-
tridge vertically, and then push it 
slightly down toward you to fin
-
ish reinstalling the imaging car-
tridge.
5Carefully close the top cover.
Cleaning the Print Head Window
1Use either operation described below to switch the printer to Print Head 
Cleanup mode.
zHold down the Rotate Toner key for 5 to 10 seconds.
zOn the Panel tab of the Remote Panel Utility, click the P/H Clean Up 
button.
The printer enters Print Head Cleanup mode, and the...

Cleaning the Printer6-9
2Open the front cover.
Before opening the front 
cover, open Tray 1 if it is 
not already open.
3The magenta toner cartridge has 
been moved to the position from 
where it can be replaced.
 
Pull down the handle on the 
toner cartridge until the toner 
cartridge is unlocked and moves 
out slightly toward you.
 
Remove the toner cartridge.
When the magenta toner 
cartridge is removed, a 
gap is created within the 
printer so that the print 
head window can easily 
be cleaned....

Cleaning the Printer 6-10
Note
Do not touch the contact 
indicated in the illustration.
 
 
 
 
 
 
 
 
 
 
 
 
 
4Close the front cover.
The toner cartridge rotate 
within the printer.
5After the toner cartridges have 
finished rotating and all indica
-
tors on the control panel begin 
blinking, open the top cover.
Downloaded From ManualsPrinter.com Manuals 

Cleaning the Printer6-11
6Grab the handle and lift it up 
slightly to the back, and then 
slowly pull the imaging cartridge 
out vertically.
Note
Do not touch the PC drum on the imaging cartridge.
Position the removed imaging 
cartridge horizontally as shows in 
the illustration at the right.
 
Be sure to keep the imaging 
cartridge horizontal and place it 
where it will not become dirty.
 
Do not leave the imaging 
cartridge removed for more than 
15 minutes, and do not place the 
removed imaging...

Cleaning the Printer 6-12
7Clean the print head window by 
wiping it with a soft, dry cloth.
CAUTION
The area around the fuser unit is 
extremely hot. 
 
Touching anything other than the 
indicated levers may result in 
burns. If you get burned, 
immediately cool the skin under 
cold water, and then seek 
professional medical attention.
 
 
 
 
 
 
BOTTOM
VIEW
Downloaded From ManualsPrinter.com Manuals 

Cleaning the Printer6-13
Note
Decreased print quality may 
result if the surface of the 
transfer roller is touched.
 
Be careful not to touch the 
surface of the transfer roller.
 
 
 
 
 
 
 
 
 
 
 
8Slowly insert the imaging car-
tridge vertically, and then push it 
slightly down toward you to fin
-
ish reinstalling the imaging car-
tridge.
BOTTOM
VIEW
Downloaded From ManualsPrinter.com Manuals