Konica Minolta magicolor 1600W User Manual

Replacing Consumables 5-14
5Carefully close the top cover.
The printer must complete a calibration cycle (less than 2 minutes) 
after the imaging cartridge has been replaced. If you open the top 
or front cover before the printer is reset, the calibration stops, then 
starts over again after the cover is closed.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables5-15
Replacing the Fuser Unit
For optimum print quality and performance, use only approved KONICA 
MINOLTA fuser unit for your specific printer type.
1Turn off the machine and discon-
nect the power cord.
Note
There are extremely hot parts within the machine. Before replacing 
the fuser unit, wait about 20 minutes after turning off the machine, 
and then check that the fusing section has reached room 
temperature, otherwise, you may get burnt.
2Open the top cover.
If there is paper...

Replacing Consumables 5-16
3Push the blue handles back as 
far as possible.
4Grab the blue handles and lift 
the fuser unit to remove it.
Note
Do not touch the matching 
connectors of the fuser unit and 
the machine. 
 
 
 
 
 
 
 
 
 
 
 
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables5-17
5Prepare a new fuser unit.
Be careful not to touch 
the surface of the fuser 
roller.
6While lifting the fuser unit with 
the blue handles (one on each 
side), vertically insert the fuser 
unit.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 5-18
Note
Do not touch the paper exit 
sensor on the fuser unit. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Note
Do not touch the matching 
connectors of the fuser unit 
and the machine. 
 
 
 
 
 
 
 
 
 
 
 
M
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables5-19
7After the fuser unit is firmly 
installed, flip the blue handles 
down toward you. 
8Carefully close the top cover.
9Reconnect the power cord, and 
turn on the machine.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 5-20
Downloaded From ManualsPrinter.com Manuals 

Maintenance 
Downloaded From ManualsPrinter.com Manuals 

Maintaining the Printer 6-2
Maintaining the Printer
CAUTION
Read all caution and warning labels carefully, making sure to follow any 
instructions contained in them. These labels are located on the inside of 
the printer’s covers and the interior of the printer body.
Handle the printer with care to preserve its life. Abuse handling may cause 
damage and void your warranty. If dust and paper scraps remain on the 
inside or outside of the printer, printer performance and print quality will suffer, 
so the...

Maintaining the Printer6-3
„Do not leave the printer’s covers open for any length of time, especially in 
well-lit places; light may damage the imaging cartridge.
„Do not open the printer during printing.
„Do not tap media stacks on the printer.
„Do not lubricate or disassemble the printer.
„Do not tilt the printer.
„Do not touch the electrical contacts, gears, or laser devices. Doing so may 
damage the printer and cause the print quality to deteriorate.
„Keep media in the output tray at a minimum level....