Konica Minolta magicolor 1600W User Manual

Cleaning the Printer 6-14
9Close the top cover.
10Press the Clear key.
The blinking of all indicators stop, and the magenta toner indicator 
lights up.
 
The toner cartridges rotate within the printer.
11After the toner cartridges have 
finished rotating, open the front 
cover.
Downloaded From ManualsPrinter.com Manuals 

Cleaning the Printer6-15
12Align the shaft on each end of 
the toner cartridge with its hold
-
ers, and then insert the car-
tridge.
Note
Do not touch the contact 
indicated in the illustration.
 
 
 
 
 
 
 
 
 
 
 
 
 
Downloaded From ManualsPrinter.com Manuals 

Cleaning the Printer 6-16
13Press in the magenta toner car-
tridge until it locks into place.
14Close the front cover.
Downloaded From ManualsPrinter.com Manuals 

Troubleshooting
Downloaded From ManualsPrinter.com Manuals 

Introduction 7-2
Introduction
This chapter provides information to aid you in resolving printer problems you 
may encounter, or at least guide you to the proper sources for help. 
Preventing Media Misfeedspage 7-3
Understanding the Media Pathpage 7-4
Indicator Messagespage 7-5
Clearing Media Misfeedspage 7-10
Solving Problems with Media Misfeedspage 7-18
Solving Other Problemspage 7-20
Solving Problems with Printing Qualitypage 7-22
Downloaded From ManualsPrinter.com Manuals 

Preventing Media Misfeeds7-3
Preventing Media Misfeeds
Make sure that...
Media matches the printer specifications.
Media is flat, especially on the leading edge.
The printer is on a hard, flat, level surface.
You store media in a dry location away from moisture and humidity.
You always adjust the media guides in Tray 1 after inserting the media (a 
guide that is not properly adjusted can cause poor print quality, media mis
-
feeds, and printer damage).
You load the media printing-side up in the tray...

Understanding the Media Path 7-4
Understanding the Media Path
Understanding the printer’s media path will help you locate media misfeeds.
1 Output tray
2 Imaging cartridge
3 Toner cartridge carousel
4 Tray 1
5 Fuser unit
1
2
45
3
Downloaded From ManualsPrinter.com Manuals 

Indicator Messages7-5
Indicator Messages
The indicators on the control panel provide information about your printer and 
help you locate each problem.
Status Messages (Ready Indicator, Error Indicator)
Status messages indicate the current condition of the printer.  
The printer status also can be checked on the Remote Panel Utility.  
(Refer to “Working with the Remote Panel Utility” on page 3-2.)
Warning Messages
These messages indicate that a warning condition has occurred on the 
printer.
Ready...

Indicator Messages 7-6
* Differs depending on the toner status.
OnOffRapid 
blinkingThe installed toner 
cartridge is of an 
unapproved type.Install a KONI-
CAMINOLTA toner 
cartridge of the 
appropriate type 
(AM, EU, AP or 
GC).
See page 5-3.
BlinkingOffOnToner out
This message 
appears when 
the Toner Out 
Stop in the 
Remote Panel 
Utility is set to 
Off.
Replace the toner 
cartridge.
Printing can 
continue, 
however, 
the printing 
results are 
not 
guaranteed.
On Slow 
blinking *Imaging cartridge...

Indicator Messages7-7
Error Messages
These messages indicate errors which you must correct before a print job 
can continue or the printer status return to “Ready”.
Ready 
indicator 
(green)Error 
indicator 
(orange)To n e r  
indicator 
(orange)ConditionAction
OffRapid 
blinkingOnToner out
This message 
appears when 
the Toner Out 
Stop in the 
Remote Panel 
Utility is set to 
On.
Replace the toner 
cartridge.
If Toner 
Out Stop in 
the Remote 
Panel Utility 
is set to Off, 
printing can 
continue....