HP Z5200 Owners Manual

The complete Full Bleed Foam is constructed of three separate sections, left, center and right. This
procedure only describes how to remove the left section. Removal of the other two sections is identical.
1. Open the Window.
2. Remove the Left Full Bleed Foam from the left platen.
3. Remove the Platen Middle Foams that are exposed once the Full Bleed Foam has been removed.
NOTE: When you reinstall the full bleed foams, take ca re to correctly seat them to avoid possible
damage to the Carriage Assembly....

7 Preventive Maintenance
●Preventive Maintenance
●
Preventive Maintenance Kits
Preventive Maintenance
Moisture on the Printer
Users should use the Printer in an environment between 20% and 80% relative humidity. To recover
from moisture condensation, turn the  Printer Off, and, using the main roller as a reference, wait until the
Printer is completely dry before using it again.
Noisy Carriage Bushing
To prevent noisy movement of the carriage, remove aluminum or dust particles from the bushing at the
back...

You should also lubricate the Carriage Assembly whenever you change any of the following service
parts:
● The Carriage Rear Bushing.
● The Carriage Assembly.
● The Carriage Rail Oiler.
To lubricate the Carriage Assembly you will require the Lubrication Kit (refer to the parts and diagrams
chapter 
Tools 2 on page 164. Use the following pr ocedure to lubricate the Carriage Assembly:
1. Use the IPA alcohol (Q6675-60070) and the clea ning cloth to clean the Carriage Rail and the
Carriage Slider Rod.
2. Use...

One of the EEROM counters is assigned to counting the number of carriage cycles.
Service PartLIFE_VALUEMaintenance Advice
Belt Cycles3000000PMKIT1
Bushings Life3000000PMKIT1
Trailing Cable Cycles3000000PMKIT1
Scan Axis Cycles3000000PMKIT1
Scan Axis Distance Covered4500000PMKIT1
Tubes Cycles3000000PMKIT1
Right Spittoon Volume600000000PMKIT2
Left Spittoon Volume51000000PMKIT2
Cutter Life25000 PMKIT3
When these components of the Printer exceed this amount, the front panel displays the following
message:...

Preventive Maintenance Kit #2
The Preventive Maintenance Kit #2 is available using the following part number Q6675-67012 and
contains the following parts:
Part NumberDescription
Q6718-67025Service Station SV
Q5669-67049 Left spittoon SV
ENWW Preventive Maintenance Kits 331 

8Printer menu Map
The following pages show the Menu Map print which is available through the front panel Internal
Prints r>User Information Prints >Print menu Map.  These menus can be used for guiding the
customer through the menu system when  troubleshooting a printer issue remotely.
Figure 8-1   Paper Menu
Figure 8-2  Job Management Menu
332 Chapter 8   Printer menu Map ENWW 

Figure 8-3  Ink Menu
Figure 8-4  Setup Menu
ENWW 333 

Figure 8-5  Image quality maintenance menu
Figure 8-6  Connectivity Menu
334 Chapter 8   Printer menu Map ENWW 

Figure 8-7  Internal Prints Menu
Figure 8-8  Information Menu
ENWW 335