Epson Stylus Pro WT7900 User Manual

21
Setting Up the Printer|21
Unpacking the Printer and Mounting It on the Stand
1. Make sure you have all the items shown below:
2. Remove the cardboard panels and other packing materials from around 
the printer.
3. Have four people lift the printer using the handgrips, two in front and 
two in back.
Roll paper 
holders
Documentation 
and software CD
11 Ink cartridges
Power cord Cable guides
Printer
Bundled roll paper
Note: Make sure you 
save the box and 
packaging in case you 
need to ship the...

22
22|Setting Up the Printer
4. Lower the printer onto the stand with the stand’s horizontal strut in 
front, as shown. Align the pegs on the stand with the holes on the 
bottom of the printer. 
5. Fasten the printer to the stand with the wing screws and washers.
 

23
Setting Up the Printer|23
Attaching the Paper Basket
The paper basket is a cloth sheet that attaches to the printer stand and 
catches your paper prints as they come out. 
1. Make sure you have all the parts shown below:
2. Insert the two short posts as shown, one on each side of the stand.
2 Paper guides1 Square 
pole and 2 
round poles 2 Pins
Basket cloth
2 Posts2 Black plastic 
connectors
Rod
 

24
24|Setting Up the Printer
3. Use the pins to fasten the posts in place. Make sure the pins are pushed 
in all the way.
4. Insert the round and square poles into the basket cloth as shown.
 

25
Setting Up the Printer|25
5. Place the basket under the printer as shown.
6. Snap the center pole into the holders on each side of the stand.
 

26
26|Setting Up the Printer
7. Push the black plastic connectors onto both ends of the square pole.
8. Push the black plastic connectors onto the posts on each side of the 
stand.
 

27
Setting Up the Printer|27
9. Snap the back pole into the holders as shown.
10. Hook the loops around the pins on the back of the stand legs.
 

28
28|Setting Up the Printer
11. Insert the rod into the fabric channel.
12. Insert the free ends of the rod into the holes in the sides of the stand.
 

29
Setting Up the Printer|29
13. To keep the cloth off the ground, loop the tabs over the ends of the rod 
as shown.
14. Attach the paper guides to the bottom of the printer as shown:
15. Make sure the paper guides hang straight down, then fold the paper 
basket all the way up so it’s in the vertical position.
 

30
30|Setting Up the Printer
Assembling the Film Basket
The film basket is used when printing on special media such as Epson 
ClearProof Film, and can be detached and stored when printing on paper 
(see page 64). Follow the steps below to prepare it for use.
1. Make sure you have all the parts shown below:
2. Position the film basket guides as shown, with the channels in the guides 
facing each other.
Basket cloth
Straps
Film basket guides 
and pinsPins Scissor arms
Rods