Epson Aculaser CX28DN User Manual

Scanning With the Machine 179
1In the main screen (Scan mode), press the + or , key to select CANCEL 
RESERV
., and then press the Select key.
2Press the + or , key to select the job to be deleted, and then press the 
Select key.
To check the information for the selected job, press the ) key.
If no jobs are queued for transmission, NONE appears.
3Press the + or , key to select YES, and then press the Select key.
The main screen (Scan mode) appears again.
 

Scanning With the Machine 180
 

9Replacing
Consumables
 

Replacing Consumables 182
Replacing Consumables
Note
Failure to follow instructions as outlined in this manual could result in 
voiding your warranty.
Note
If an error message (Toner Empty, I-UNIT END, etc.) appears, print 
out the configuration page, and then check the status of the other 
consumables. For details on the error messages, refer to “Error Messages” 
on page 255. For details on printing the configuration page, refer to 
“Printing a Configuration Page” on page 213.
About Toner Cartridges...

Replacing Consumables 183
When replacing a toner cartridge, refer to the following table. For optimum 
print quality and performance, use only approved Epson toner cartridges, as 
listed in the table below. You can find the toner cartridge part numbers on the 
consumables reorder label inside the front cover your machine.
For optimum print quality and performance, use only the corre-
sponded TYPE genuine Epson toner cartridges.
Keep toner cartridges: 
„In their packaging until you’re ready to install...

Replacing Consumables 184
Replacing a Toner Cartridge
Note
Be careful not to spill toner while replacing a toner cartridge. If toner 
spills, immediately wipe it off with a soft, dry cloth.
If 
MACHINE SETTING/TONER EMPTY in the UTILITY menu is set to 
STOP, the message TONER EMPTY/CHANGE X TONER (where “X” indi-
cates the color of the toner) appears when the toner cartridge is nearly empty. 
Follow the steps below to replace the toner cartridge. 
1Check the message window to see which color toner...

Replacing Consumables 185
4Lower the lever to release the 
lock.
5Grab the handle of the toner car-
tridge to be replaced, and then 
pull out the cartridge. 
The following instructions show 
the procedure to replace the 
toner cartridge(Y).
Note
Dispose of the used toner cartridge according to your local regulations. 
Do not burn the toner cartridge.
For details, refer to “About Toner Cartridges” on page 182.
6Check the color of the new toner cartridge to be installed.
7Remove the toner cartridge from...

Replacing Consumables 186
8Shake the cartridge to distribute 
the toner.
9Make sure that the toner car-
tridge is the same color as the 
machine compartment, and then 
insert the toner cartridge into the 
machine.
10Make sure that the toner car-
tridge is securely installed, and 
then peel off the protective film.
Y
3 ×
YY
Y
Y
 

Replacing Consumables 187
11Raise the front lever to its origi-
nal position.
12Pull the lever to the left to lock it 
in place.
The front lever should be 
securely returned to its 
original position; other-
wise, the front cover of 
the machine cannot be 
closed.
13Close the front cover.
Y
Y
Y
 

Replacing Consumables 188
Replacing an Imaging Unit
When replacing an imaging unit, refer to the following table. For optimum print 
quality and performance, use only approved Epson imaging units, as listed in 
the table below. You can find the imaging unit part numbers on the consum-
ables reorder label inside the front cover your machine.
Note
Do not touch the OPC drum 
surface. This could lower image 
quality.
Exposure to light can damage the 
drum, causing dark or light areas 
to appear on the...