Epson AcuLaser C1750N User Manual

Setting the PowerSaver Time Option
You can set the power saver time for the printer. The printer switches to the Power Saver Mode after
the specified time.
1. Press the 
 (Menu) button.
2. Select Admin Menu, and then press the 
 button.
3. Select System Setup, and then press the 
 button.
4. Select PowerSaver Time, and then press the 
 button.
5. Select Mode1 or Mode2, and then press the 
 button.
6. Press the 
 or  button to select the desired value, and then press the  button.
You can select from 5–30...

Chapter 7
Troubleshooting
Clearing Jams
Careful selection of appropriate print media and proper loading allow you to avoid most jams.
See also:
❏“About Print Media” on page 91
❏“Supported Print Media” on page 92
Note:
Before buying large quantities of any print media, it is recommended that you try a sample first.
Avoiding Jams
❏Use only recommended print media.
❏See “Loading Print Media in the Multipurpose Feeder (MPF)” on page 96 and “Loading Print
Media in the Priority Sheet Inserter (PSI)” on page...

❏Overtightening the guides may cause jams.
See also:
❏“About Print Media” on page 91
❏“Supported Print Media” on page 92
Identifying the Location of Paper Jams
c
Caution:
Do not attempt to remove a paper jammed deeply inside the product, particularly a paper wrapped
around a Fusing Unit or a heat roller. Otherwise, it may cause injuries or burns. Switch off the
product promptly and contact your local Epson representative.
Important:
Do not attempt to clear any jams using tools or instruments. This may...

1 Center Output Tray
2 Transfer Belt
3 Levers
4 Rear Door
5Front Cover
6 Multipurpose feeder (MPF)
7 Priority Sheet Inserter (PSI)
Clearing Paper Jams From the Front of the Printer
Note:
To resolve the error displayed on the LCD panel, you must clear all print media from the print media
path.
1. Pull the PSI out.
Epson AcuLaser C1750 Series     User’s Guide
Troubleshooting     154
 

2. Remove any paper jammed from the front of the printer.
3. Replace the PSI in the printer.
Important:
Do not use excessive force on the PSI. Doing so could damage it or the inside of the printer.
Clearing Paper Jams From the Back of the Printer
Important:
❏To prevent electric shock, always turn off the printer and disconnect the power cord from the
grounded outlet before performing maintenance.
❏To avoid burns, do not clear paper jams immediately after printing. The fusing unit becomes
extremely hot...

1. Push the rear cover handle and open the rear door.
2. Lift up the levers.
3. Remove any paper jammed from the back of the printer.
Epson AcuLaser C1750 Series     User’s Guide
Troubleshooting     156
 

4. Lower the levers to their original position.
5. Close the rear door.
Clearing Paper Jams From the Center Output Tray
Important:
❏To prevent electric shock, always turn off the printer and disconnect the power cord from the
grounded outlet before performing maintenance.
❏To avoid burns, do not clear paper jams immediately after printing. The fusing unit becomes
extremely hot during use.
Note:
To resolve the error displayed on the LCD panel, you must clear all print media from the print media
path....

1. Push the rear cover handle and open the rear door.
2. Lift up the levers.
3. Remove any paper jammed from the back of the printer. If no paper is found in the paper path,
then remove any paper jammed out of the center output tray.
Epson AcuLaser C1750 Series     User’s Guide
Troubleshooting     158
 

4. Lower the levers to their original position.
5. Close the rear door.
Epson AcuLaser C1750 Series     User’s Guide
Troubleshooting     159
 

Jam Problems
Misfeed jam
ProblemAction
Print  media  misfeeds  occur. Remove the paper from the PSI, and then ensure that the paper is properly inserted
in the MPF.
Depending on the print media you use, take any of the following actions:
❏For thick paper, use the one that is 163 gsm or less.
❏For thin paper, use the one that is 60 gsm or more.
❏For the envelope, ensure that it is properly loaded in the MPF or the PSI as
instructed in “Loading Envelope in the Multipurpose Feeder (MPF)” on
page 102 or...