Eiki Projector Lc Hdt700 User Manual

							Wired Setting
Projector Set-up and Operation
Owner’s Manual
Network Set-up and Operation 
This is the manual for the Network function.  
Read this manual thoroughly to operate the Network function.
First,  read  the  owner's  manual  of  the  projector  to  understand  the  basic 
operation of the projector and the safety instructions.
The safety instructions in the owner's manuals should be followed strictly.
 for HDT700 
						

							2
ComplianceFederal Communications Commission Notice
This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for 
a  Class  A  digital  device,  pursuant  to  Par t  15  of  FCC  Rules.  These  limits  are 
designed  to  provide  reasonable  protection  against  harmful  interference  when 
the  equipment  is  operated  in  a  commercial  environment.  This  equipment 
generates,  uses,  and  can  radiate  radio  frequency  energy  and,  if  not  installed 
and used in accordance with the instruction manual, may cause harmful inter -
ference  to  radio  communications.  Operation  of  this  equipment  in  a  residen -
tial  area  is  likely  to  cause  harmful  interference  in  which  case  the  user  will  be 
required to correct the interference at his own expense.
Do not make any changes or modifications to the equipment unless otherwise 
specified in the instructions. If such changes or modifications should be made, 
you could be required to stop operation of the equipment.
WARNING
This  is  a  Class  A  product.  In  a  domestic  environment  this  product  may  cause 
radio  interference  in  which  case  the  user  may  be  required  to  take  adequate 
measures. 
						

							3
ENGLISH
 
Safety instructions
 CAUTION IN USING THE PROJECTOR VIA NETWORKS
● When  you  find  a  problem  with  the  projector,  remove  the  power  cable 
immediately  and  inspect  the  unit.  Using  the  projector  with  failure  may  cause 
fire or other accidents. 
● If you remotely use the projector via networks, carry out a safety check regularly  and take particular care to its environment. Incorrect installation may cause fire 
or other accidents.
 CAUTION IN USING NETWORK  FUNCTION
● We  assume  no  responsibility  for  the  loss  or  damage  of  data,  or  damage  of  the 
computer  caused  by  using  this  projector.  Making  back-up  copies  of  valuable 
data in your computer is recommended. 
						

							4
Compliance ........................................................................\
............................................................................................................ 2
Safety instructions  ........................................................................\
............................................................................................. 3
Table of contents  ........................................................................\
................................................................................................ 4
Chapter 1 Preparation ........................................................................\
........................ 5
Features........................................................................\
........................................................................................................... 6
Required operating environment for computers  ........................................................................\
................7
Network specifications of the projector  ........................................................................\
.................................... 7
Flow of installation  ........................................................................\
................................................................................... 9
Notice about installing Software CD-ROM  ........................................................................\
.............9
Chapter 2 Setup Procedures........................................................................\
.......... 11
Connecting to the LAN line ........................................................................\
............................................................ 12
Network configuration  ........................................................................\
....................................................................... 12
Network PIN code  ........................................................................\
................................................................................. 14
Network information  ........................................................................\
........................................................................... 14
AMX D. D.  ........................................................................\
.................................................................................................... 15
Network factory default  ........................................................................\
.................................................................... 15
Wired LAN factory default settings  ........................................................................\
............................................ 16
Chapter 3 Basic Setting and Operation  .............................................................17
Login the setting page of the projector  ........................................................................\
................................. 18
[1] Enter the IP address  ........................................................................\
...................................................... 18
[2] Login  ........................................................................\
...................................................................................... 18
[3] Display of main setting page  ........................................................................\
................................. 19
How to use the setting page  ........................................................................\
......................................................... 20
Initial setting  ........................................................................\
............................................................................................. 22
Network PIN code setting  ........................................................................\
............................................... 23
PJLink and password setting  ........................................................................\
......................................... 23
Network configuration  ........................................................................\
....................................................................... 24
E-mail setting  ........................................................................\
........................................................................................... 26
Examples: Type and contents of alert mail  ........................................................................\
..........29
SNMP setting  ........................................................................\
............................................................................................ 30
Chapter 4 Controlling the Projector  ...................................................................33
Power control and status check ........................................................................\
................................................... 34
Control  ........................................................................\
.......................................................................................................... 36
Input  ........................................................................\
............................................................................................. 36
System  ........................................................................\
......................................................................................... 37
Image adjustment ........................................................................\
................................................................ 38
PC adjustment  ........................................................................\
......................................................................................... 39
Setting up the projector  ........................................................................\
................................................................... 40
Screen setting   ........................................................................\
....................................................................... 40
Lens adjustment ........................................................................\
.................................................................... 41
Setting 1  ........................................................................\
..................................................................................... 42
Setting 2  ........................................................................\
..................................................................................... 42
Setting 3  ........................................................................\
..................................................................................... 43
Information  ........................................................................\
................................................................................................ 44
Chapter 5 Appendix   ........................................................................\
........................ 47
Examples of connection ........................................................................\
................................................................... 48
Use of telnet  ........................................................................\
.............................................................................................. 50
Web browser setting  ........................................................................\
........................................................................... 52
Examples: OS/Browsers  ........................................................................\
..................................................................... 53
Q&A  ........................................................................\
................................................................................................................ 57
Table of contents 
						

							ENGLISH
5
ENGLISH
1Chapter 1 
 Preparation
Describes features and operating environment of this projector. 
						

							6
Chapter 1 Preparation
Features
E-Mail Alert function (+p.26)
The  projec tor  sends  mes-
sages  to  the  registered  e -mail 
addresses  when  a  lamp  abnor -
malit y  or  power  failure  occurs 
with  the  projec tor.  This  mes -
sage describes how to solve the 
cause  of  the  problems.  You  can 
take  ef ficient  ac tion  for  quick 
recovery.
PC4
PC3PC6PC5
PC1PC2
Y o u’ve  got 
Mail. 
PJ2PJ1
Web Management function (+p.33)
With  this  func tion,  you  can 
m o n i to r  p r o j e c to r  f u n c t i o n s 
such  as  power  status,  lamp 
status,  input  mode,  signal 
condition,  lamp -use  time,  etc. 
through  the  net work  by  using 
the  web  browser  installed  on 
your computer.
PC4
PC3PC6PC5
PC1PC2
T urn ON  P J 2
PJ2PJ1
SNMP Agent function (+p.30)
To  send  the  information  of  the  projector  to  the  SNMP  manager.  Enables  you  to  manage 
the projector condition with the supplied SNMP manager software.
SNMP Manager function
A  func tion  to  manage  the 
condition  of  projectors  in  the 
network  by  using  the  SNMP 
protocol.  The  managing 
computer  needs  to  provide 
an  SNMP  managing  software. 
Refer  to  the  owner's  manual 
of  the  "PJ  Network  Manager" 
supplied separately for further 
details.
PC6PC4
PJ2PJ3PJ4
PC5
PJ1
You receiv ed
a  Tr ap .
SNMP Manager
Tr ap
Tr ap 
						

							7
ENGLISH
 
Features
Operating SystemWindows 2000, Windows XP (32bit version),  
Windows Vista (32bit version), Windows 7 (32bit version)
Mac OS X v 10.4 or 10.5
Computer environment
Recommended CPUWindows: Pentium III 900MHz or more
Macintosh :  800 MHz PowerPC G4 or faster,or 1.8 GHz Intel Core 
Processor or faster
Memory
  Windows :   64MB (Minimum)/ 128MB or more (Recommended) 
128MB or more for Windows XP 
1GB or more for Windows Vista or Windows 7
Macintosh : 256MB or more (512MB is recommended)
Free disk space 100MB or more
Drive equipmentCD-ROM drive
Display settings  Support one of following resolutions;
VGA (640 x 480), SVGA(800 x 600), XGA(1,024 x 768) Number of col -
ors: Either of 16 bit (65,536 color 24/32 bit (16.77 million colors))
Network cardThe computer must provide a 10Base-T or 100Base-TX network 
card.
Web Browser*
Internet Explorer version 6.0, 7.0 or 8.0
Netscape Navigator version 7.1 or 9.0
Safari  3.1
*   Used to control and set up the projector. The layout of pages in 
the browser may slightly differ from each type of application or 
operating system you use.
Recommended Internet 
Mailer*
- Microsoft Outlook    - Microsoft Outlook Express
- Netscape Mail   
*   Required the internet e-mail application software to receive an 
e-mail alert sent from this projector. If you do not use the func -
tion E-mail Alert, this application is not required.
Required operating environment for computers
When  operating  the  projector  via  networks,  computers  should  meet  the  operating  envi -
ronment below.
LAN Terminal
Data communication standards 10Base-T/100Base-TX/1000Base-T compatible
Physical layer 10Base-T
Protocol TCP/IP
Network specifications of the projector 
						

							8
Chapter 1 Preparation
Notice
Expression/Abbreviation
The  OS  of  the  computer  and  the  Web  browser  described  in  this  manual  are  Windows  XP 
Professional and Internet Explorer 6.0. In case of another OS or Web browser, some instruc-
tion  procedures  may  differ  from  the  actual  operation  depending  on  your  computer  envi -
ronment.
Use of this manual
This  manual  does  not  provide  the  detailed  description  of  basic  operation  and  functions 
for  computer,  web  browser,  projector  and  network.  For  instructions  about  each  piece  of 
equipment or application software, please refer to the respective manual.
Trademarks
Ethernet  is  a  registered  trademark  of  Xerox  Corporation.  Microsoft,  Windows,  Windows 
2000,  Windows  XP,  Windows  Vista  and  Windows  7  are  registered  trademarks  of  Microsoft 
Corporation  in  the  United  States  and  other  countries.  Internet  Explorer  is  a  registered 
trademark of Microsoft Corporation. Netscape Navigator and Netscape Communicator are 
trademarks or registered trademarks of Netscape Communications Corporation. JavaScript 
is a registered trademark of Sun Microsystems, Inc. 
Macintosh is a registered trademark of Apple, Inc. in the USA and other countries. PowerPC 
is  a  registered  trademark  of  IBM  Corporation.  Intel  Core  is  a  registered  trademark  of  Intel 
Corporation in the USA and other countries.
Other  product  or  brand  names  in  this  manual  are  registered  trademarks  or  trademarks  of 
their respective owners.
* Unauthorized use of a part or whole of the contents in this manual is prohibited.
* The contents of this manual are subject to change without notice.
Cabling Between the Projector and a Hub or computer*1 
Use an appropriate cable when connecting the projector and a hub or computer.
Connection Ethernet  cable type Max. cable length
Projector - Hub STP straight-through  category 5 *
2 cable100m (328feet)
Projector - Computer STP crossover category 5*
2 cable100m (328feet)
*1   There may be other limitations depending on your network environment or LAN specification. 
Please consult your network administrator for further details.
*2   Cable category indicates cable quality.  
						

							9
ENGLISH
 
Flow of installation
Flow of installation
To use the projector via the networks, follow the setup procedures below.
STEP 1Connect the LAN and set the configuration.
STEP 2Network Configuration has completed.
Decide depending on the LAN environment.
	➔ “2. Setup Procedures” (pp.11–16).
Detailed LAN configurations need to be done with a browser later.
First, complete the Wired LAN connection between computers and projec -
tors, then start browser configurations.
	➔  “3. Basic setting and operation” (pp.17–31).
Follow each chapter to operate the projector.
■	Operate and manage the projector ➔	“4. Controlling the projector” (pp.33-45)
 ➔	“Power Control and status check” (p.34)
  ➔	“Control” (p.36)
  ➔	“PC adjustment” (p.39)
  ➔	“Setting up the projector” (p.40)
  ➔	“Information” (p.44)
Install  the  software  recorded  in  CD-ROM  on  each  computer  which  will  be 
operated. Refer to the owner's manual of PJ Network Manager.
STEP 3
Install the Software on computers.
Notice about installing Software CD-ROM
It is available for controlling and setting of the projector by using the web browser without 
installing any software. So it is not required to install the software into your computer.
For PJ Network Manager function, it is required to install the software. Please see the own -
er's manual of "PJ Network Manager Function". 
						

							10
Chapter 1 Preparation