Digital Projection Titan Xg-500 User Manual

Rev B 02/2007 Page 7.15
Digital Projection TITAN XG-500 User Manual  7. Appendix
Remote communications protocol
Version: Revision C 02/01/07
Introduction
This protocol document covers all projectors in the Titan series and also the 
Lightning 30/40isx+.
Only one remote connection (RS232, LAN or Wireless LAN) should be used at any 
one time.
Following the transmission of a command, the control system must wait to receive 
the complete reply before sending a new command.
It should be noted that this...

Page 7.16 Rev B 02/2007
7. Appendix  Digital Projection TITAN XG-500 User Manual
Operation Messages
Operation messages are constructed using the following format:
Header Type Size CRC Oper’n 
typeOperation Reserved
2 bytes 1 byte 2 bytes 2 bytes 1 byte 2 bytes 2 bytes
Data BE EF 03 19 00 58 58 00 00 00 00 00
Byte #123456789101112
Operation Target Operation Value Reserved
4 bytes 4 bytes 4 bytes
Data 00 00 00 00 00 00 00 00 00 00 00 00
Byte # 13 14 15 16 17 18 19 20 21 22 23 24
Reserved Reserved
4 bytes 4...

Rev B 02/2007 Page 7.17
Digital Projection TITAN XG-500 User Manual  7. Appendix
Notes
  The following pages contain 
examples of some basic 
Operation commands.
  For full details of all the For 
full details of all the Operation 
commands and Enhanced 
commands, contact Digital 
Projection and ask for a copy 
of the Titan Projector Series 
External Control Protocol.
Enhanced Messages
Enhanced messages are constructed using the following format:
Header Type Size CRC Data type Data length (n)
2 bytes 1...

Page 7.18 Rev B 02/2007
7. Appendix  Digital Projection TITAN XG-500 User Manual
Operation Command examples
All operation commands are located at bytes 9 &10.
All values are located at bytes 17 & 18 unless otherwise indicated
Power  (0102)
Projector On or Standby
  Value
On  00h
Standby  04h
Examples
Set Projector (On)
BEEF  03   1900  5858  01  0102  0000  00000000  00000000  00000000  00000000  00000000
Response
1E  BEEF  03  1900  5858  01  0102  0000  00000000  00000000  00000000  00000000  00000000...

Rev B 02/2007 Page 7.19
Digital Projection TITAN XG-500 User Manual  7. Appendix
Source  (3702)
Projector source select
  Value
RGB1  00h
RGB2  01h
DVI  02h
SDI  03h
Composite 04h
SVideo  05h
Component 06h
Examples
Set Source  (DVI)
BEEF  03  1900  5858  01  3702  0000  00000000  02000000  00000000  00000000  00000000
Response  
1E  BEEF  03  1900  5858  01  3702  0000  00000000  02000000  00000000  00000000  00000000
Set Source  (SVideo)
BEEF  03  1900  5858  01  3702  0000  00000000  05000000  00000000...

Page 7.20 Rev B 02/2007
7. Appendix  Digital Projection TITAN XG-500 User Manual
Brightness (E502)
Adjusts Brightness
Range:    -128 — +127 (00h - FFh)
Centre (0):  128 (80h)
Examples
Set Brightness  97    (128 + 97 = 225  =  E1h)
BEEF  03  1900  5858  01  E502  0000  00000000  E1000000  00000000  00000000  00000000
Response
1E  BEEF  03  1900  5858  01  E502  0000  00000000  E1000000  00000000  00000000  00000000
Get Brightness
BEEF  03  1900  5858  02  E502  0000  00000000  00000000  00000000  00000000...

Rev B 02/2007 Page 7.21
Digital Projection TITAN XG-500 User Manual  7. Appendix
Contrast (E602)
Adjusts Contrast
Range:    -128 — +127 (00h - FFh)
Centre (0):  128 (80h)
Examples
Set Contrast  97    (128 + 97 = 225  =  E1h)
BEEF  03  1900  5858  01  E602  0000  00000000  E1000000  00000000  00000000  00000000
Response
1E  BEEF  03  1900  5858  01  E602  0000  00000000  E1000000  00000000  00000000  00000000
Get Contrast
BEEF  03  1900  5858  02  E602  0000  00000000  00000000  00000000  00000000...

Page 7.22 Rev B 02/2007
7. Appendix  Digital Projection TITAN XG-500 User Manual
Shutter  (CF02)
Closes and opens shutter
   Target  Value
   (Set)  (Get)
Shutter Close   00h  01h
Shutter Open   01h  00h
Examples
Set Shutter  (Close)
BEEF  03  1900  5858  01  CF02  0000  00000000  00000000  00000000  00000000  00000000
Response  
1E  BEEF  03  1900  5858  01  CF02  0000  00000000  00000000  00000000  00000000  00000000
Set Shutter  (Open)
BEEF  03  1900  5858  01  CF02  0000  01000000  00000000  00000000...

Rev B 02/2007 Page 7.23
Digital Projection TITAN XG-500 User Manual  7. Appendix
COMMAND HEX DATA    (MESSAGE LENGTH = 32 BYTES) COMMENTSSwitch Projector On
BE EF 03 19 00 58 58 
01 01 02
 00 00 00 00 00 00 
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Switch Projector to Standby
BE EF 03 19 00 58 58 
01 01 02
 00 00 00 00 00 00 
04 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Select RGB1 input
BE EF 03 19 00 58 58 
01 37 02
 00 00 00 00 00 00 
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Select...

Digital Projection TITAN XG-500 User Manual