Dell 2230d User Guide

235.yy Paper jam
 - On
 - Blinking
 - Blinking
 - On
Remove the jam from the standard exit bin.
24x.yy Paper jam
 - On
 - On
 - On
 - On
Try one of the following:
Remove Tray 1.
Open the front door, and then remove the photoconductor kit and toner cartridge unit.
Remove Tray 2.
Clearing jams
101
 

251.yy Paper jam
 - On
 - On
 - On
 - On
Remove the jam from the manual feeder.
Clearing jams behind the photoconductor kit and
toner cartridge
1Push the release button, and then lower the front door.
Clearing jams
102
 

2Lift and pull the unit containing the photoconductor kit and the toner cartridge out of the printer. Set the unit
aside on a flat, clean surface.
Warning—Potential Damage: Do not touch the photoconductor on the underside of the photoconductor kit.
Use the cartridge handle whenever you are holding the cartridge.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
3Remove the jammed paper.
Note: If the...

Clearing jams from the standard exit bin
A paper size that is not supported for duplex printing can jam the standard exit bin.
To remove the jam, gently pull the sheet straight out of the standard exit bin.
Clearing jams from Tray 1
To see whether paper is jammed in or behind Tray 1, the standard tray:
1Remove Tray 1.
Clearing jams
104
 

2Remove the jammed paper.
3If necessary, depress the lever to free the paper and remove the jam.
4Insert the tray.
5Press  to continue printing.
Clearing jams
105
 

Clearing jams from Tray 2
To see whether paper is jammed in or behind Tray 2:
1Remove Tray 2.
2Remove the jammed paper.
Clearing jams
106
 

3Insert the tray.
4Press  to continue printing.
Clearing jams in the manual feeder
Paper jammed in the manual feeder can usually be grasped and pulled straight out. If the jam cannot be removed
this way, check for jammed paper behind the photoconductor kit and toner cartridge unit. For more information,
see “Clearing jams behind the photoconductor kit and toner cartridge” on page 102.
Clearing jams
107
 

Clearing jams behind the rear door
If the paper is exiting the printer, pull the paper out. If the paper is not exiting the printer:
1Push the release button, and then lower the front door.
2Pull open the rear door.
The paper may be jammed with one end caught in the standard exit bin.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
Clearing jams
108
 

3Remove the jammed paper.
4Close both the front and rear doors.
5Press  to continue printing.
Clearing jams
109
 

Troubleshooting
Solving basic printer problems
If there are basic printer problems, or the printer is unresponsive, ensure the following:
The power cord is plugged into the printer and a properly grounded electrical outlet.
The electrical outlet is not turned off by any switch or breaker.
The Ground Fault Circuit Interrupter (GFCI) has not tripped.
The printer is not plugged into any surge protectors, uninterrupted power supplies, or extension cords.
Other electronic equipment plugged into the outlet is...