Canon scanner imageFORMULA DR6030C User Manual

Appendices115
Chapter 4
Attaching the Pickup Roller
1.Hold the new pickup roller (or the one you removed) by both sides of its shaft, 
and place it on the hooks.
IMPORTANT
Take note of the orientation of the pickup roller. Putting it in backward and 
forcing it may damage the scanner.
2.Place the shaft of the pickup roller on the hooks, and then press it into place.
3.Make sure that the shaft of the pickup roller is correctly inserted. 

116Appendices
4.Close the upper unit slowly. Be sure that the upper unit is completely closed by 
pushing on both edges with both hands until you hear a click.
IMPORTANT
Do not force the upper unit to close. Doing so may damage the scanner.
Removing and Attaching the Feed Roller
Follow the procedure below to remove and attach the feed roller unit for 
cleaning or replacement.
CAUTION
Do not use excessive force when removing or attaching the 
rollers. Doing so may damage them.
Removing the Feed Roller...

Appendices117
Chapter 4
2.Remove the roller cover.
3.Move the roller lock lever down and forward (➀), and then slide it to the right 
(➁).
4.Shift the feed roller to the right to remove it. 

118Appendices
Attaching the Feed Roller
1.Position the feed roller so the notch in the roller is facing the scanner’s shaft.
2.Slide the roller lock lever to the left, and insert it into the feed roller hole.
3.Lift up the roller lock lever and lock the feed roller.
4.Attach the roller cover. 

Appendices119
Chapter 4
5.Close the upper unit slowly. Be sure that the upper unit is completely closed by 
pushing on both edges with both hands until you hear a click.
IMPORTANT
Do not force the upper unit to close. Doing so may damage the scanner.
Removing and Attaching the Retard Roller
Follow the procedure below to remove and attach the retard roller for cleaning 
or replacement.
CAUTION
Do not use excessive force when removing or attaching the 
rollers. Doing so may damage them.
Removing the Retard...

120Appendices
2.Remove the roller cover.
3.Move the roller lock lever upward (➀), and then slide it to the right (➁).
4.Shift the retard roller to the right to remove it. 

Appendices121
Chapter 4
Attaching the Retard Roller
1.Position the retard roller so the notch in the roller is facing the scanner’s shaft.
2.Slide the roller lock lever to the left, and insert it into the retard roller hole.
3.Push the roller lock lever towards the back of the scanner to lock the retard 
roller in place. 

122Appendices
4.Attach the roller cover in order of ➀ Æ ➁.
5.Close the upper unit slowly. Be sure that the upper unit is completely closed by 
pushing on both edges with both hands until you hear a click.
IMPORTANT
Do not force the upper unit to close. Doing so may damage the scanner. 

Appendices123
Chapter 4
3. Troubleshooting
This section describes the possible problems that might occur during use of the 
scanner and how to solve them.
The Scanner Does Not Turn ON ...................................... P. 123
The Scanner Is Not Recognized 
(Connecting via USB) ....................................................... P. 124
The PC Does Not Recognize the Scanner 
(Connecting via SCSI) ...................................................... P. 124
Scanning Is Not Performed...

124Appendices
The Scanner Is Not Recognized (Connecting via USB)
The following are possible causes of the PC failing to recognize the scanner. 
Check each possible cause.
Problem The scanner is not correctly connected.
SolutionMake sure that the scanner and the computer are correctly 
connected with the USB cable. (See “Step 4. Connecting the 
Scanner to Your PC,” in the Easy Start Guide.)
Problem The scanner power is switched OFF.
SolutionMake sure that the scanner is switched ON. If the scanner is OFF,...