Canon printer MAXIFY MB5020 User Manual

Problems with the Machine While Using with Network
The Machine Stopped Working Suddenly
Ink Remaining Level Is Not Displayed on Printer Status Monitor of the Machine
Printing Speed Is Slow
Cannot Use the Machine on Replacing an Access Point or Changing Its settings
901 

The Machine Stopped Working Suddenly
Cannot Communicate with the Machine After the Network Settings Are Changed
Cannot Communicate with the Machine over the Wireless LAN
Cannot Communicate with the Machine Using the Access Point Mode
Cannot Communicate with the Machine over the Wired LAN
Cannot Print, Scan, or Fax from a Computer Connected to the Network
Cannot Communicate with the Machine After the Network Settings Are
Changed
It may take a while for the computer to obtain the IP address, or you may...

For the procedures to connect a network device to the computer and set them up, refer to the instructionmanual of your network device or contact its manufacturer.
Check7  Make sure that the radio status is good and adjust the installation positions
while monitoring the radio status with IJ Network Tool.
Monitoring Wireless Network Status
Check8  Make sure that a valid wireless channel is used.
The wireless channel to be used may be limited depending on wireless network devices installed in the
computer....

Cannot Communicate with the Machine Using the Access Point Mode
Check1 Make sure that the machine is turned on.
Check2 Is Change LAN  in LAN settings  under Device settings  set to Disable LAN ,
Wireless LAN active , or Wired LAN active ?
Select  Access point mode active .
Check3
 Is the machine selected to connect external communication devices (e.g.
computers, smartphones, or tablets)?
Select an access point name (SSID) specified for the machine as a destination for external communicationdevices....

If the problem is not resolved, perform setup with the Setup CD-ROM or perform it according to theinstructions on our website.
Cannot Print, Scan, or Fax from a Computer Connected to the
Network
Check1  Make sure that the network settings of the computer are correct.
For the procedures to set up the computer, refer to the instruction manual of your computer or contact its manufacturer.
Check2  If the MP Drivers are not installed, install them.
Install the MP Drivers with the Setup CD-ROM or install them...

Ink Remaining Level Is Not Displayed on Printer Status Monitor of
the Machine
Use the printer driver with bidirectional communication. Select  Enable bidirectional support  in the Ports sheet of the properties dialog box of the printer driver.
How to Open the Printer Driver Setup Window
906 

Printing Speed Is Slow
Check1 The machine may be printing out a large job issued from another computer.
Check2 When using wireless LAN, make sure that the radio status is good and adjust
the installation positions while monitoring the radio status with IJ Network Tool.
Monitoring Wireless Network Status
Make sure that there is no barrier or obstacle between the access point and the machine. Wireless communication between different rooms or floors is generally poor. The metal, concrete, or timber...

Cannot Use the Machine on Replacing an Access Point or
Changing Its settings
When you replace an access point, perform network setup of the machine again. Perform network setup again with the Setup CD-ROM or perform it again according to the instructions on
our website.
If the problem is not resolved, see below.
Cannot Communicate with the Machine After Applying MAC/IP Address Filtering or Entering an
Encryption Key to the Access Point
When Encryption Is Enabled, Cannot Communicate With the Machine After...

When Encryption Is Enabled, Cannot Communicate With the Machine
After the Encryption Type Was Switched on the Access Point
If the machine cannot communicate with the computer after the encryption type of the machine was
switched, make sure that encryption types for the computer and the access point matches that set to the machine.
Cannot Communicate with the Machine After Applying MAC/IP Address Filtering or Entering an
Encryption Key to the Access Point
909 

Cannot Detect a Machine on a Network
Cannot Detect the Machine When Setting up Network Communication
The Machine Cannot Be Detected in the Wireless LAN
The Machine Cannot Be Detected in the Wired LAN
Note
•
You cannot use the wireless LAN and the wired LAN at the same time.
910