Brother Printers Intellifax 2750 Plain Paper Laser Fax Owners Manual
Have a look at the manual Brother Printers Intellifax 2750 Plain Paper Laser Fax Owners Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 331 Brother manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
119TROUBLESHOOTING AND MAINTENANCE 3Remove the toner cartridge from the drum unit and keep it in a safe place. For more information, see ÒReplacing the Toner CartridgeÓ on pages 112Ð116. Toner Cartridge Toner Cartridge Discard the used drum unit according to local regulations. If you are not sure of them, call your local Sanitation Department. Be sure to seal the drum unit tightly so toner powder does not spill out of the unit. When discarding used drum units, keep them separate from domestic garbarage. 4Wait to unpack the new drum unit until immediately before installing it. Place the old drum unit into the aluminum bag and discard it according to local regulations. Aluminum Bag New Toner Cartridge Old Toner Cartridge
120CHAPTER THIRTEEN 5Gently rock the new drum from side to side five or six times. WARNING Do NOT remove the clear plastic starter sheet! Clear Plastic Starter Sheet nWait to unpack the drum unit immediately before installing it into the fax machine. If an unpacked drum unit is subjected to excessive direct sunlight or room light, the unit may be damaged. nHandle the toner cartridge and the drum unit carefully because they contain toner. If toner scatters and your hands or clothes get dirty, immediately wipe or wash with cold water.
121TROUBLESHOOTING AND MAINTENANCE 6Reinstall the toner cartridge into the new drum unit. For more information, see ÒReplacing the Toner CartridgeÓ on pages 112Ð116. 7Holding the new drum unit by its handles, install it. Close the top cover. Drum Unit Top Cover 8The fax machine will eject the clear plastic starter sheet automatically. Clear Plastic Starter Sheet WARNING nDo not touch the scanner window with your finger. nHandle the toner cartridge and drum unit carefully because they contain toner. If toner scatters and your hands or clothes get dirty, immediately wipe or wash it off with cold water.
122CHAPTER THIRTEEN For Customer Service USA:1-800-284-4329 (voice) 1-908-575-8790 (fax) From within Canada:1-800-853-6660 (voice) 1-514-685-4898 (fax) From within Montreal:1-514-685-6464 (voice)
14 CHAPTER FOURTEEN 123 Standard Telephone and FCC Notices (For 120V Models Only) These notices are in effect on models sold and used in the United States only. This equipment is hearing aid compatible. When programming emergency numbers and/or making test calls to emergency numbers: nRemain on the line and briefly explain to the dispatcher the reason for the call before hanging up. nPerform these activities in the off-peak hours, such as early morning or late evening. This equipment complies with Part 68 of FCC Rules. On the rear panel of this equipment is a label that contains, among other information, the FCC Registration Number and Ringer Equivalence Number (REN) for this equipment. You must, upon request, provide this information to your telephone company. You may safely connect this equipment to the telephone line by means of a standard modular jack, USOC RJ11C. An FCC compliant telephone cord with a modular plug is provided with this equipment. This equipment is designed to be connected to the telephone line or premiseÕs wiring using a compatible modular jack that is Part 68 compliant. See the Installation section of this manual for details.
124CHAPTER FOURTEEN The REN is useful to determine the quantity of devices you may connect to your telephone line and still have those devices ring when your telephone number is called. In most, but not all areas, the sum of the RENs of all devices connected to one line should not exceed five (5). To be certain of the number of devices you may connect to your line, as determined by the REN, you should contact your local telephone company to determine the maximum REN for your calling area. If your FAX 2750 or FAX 3750 damages the telephone line, the telephone company may discontinue your service temporarily. If possible, they will notify you in advance. If advanced notice is not practical, you will be notified as soon as possible. You will be informed of your right to file a complaint with the FCC. Your telephone company may make changes to its facilities, equipment, operations or procedures that could affect the proper functioning of your equipment. If they do, you will be notified in advance to give you an opportunity to maintain uninterrupted telephone service. If you experience trouble with your fax machine, please contact a Brother Authorized Service Center for information on obtaining service or repair. The telephone company may ask that you disconnect this equipment from the line until the problem has been corrected or until you are sure that the equipment is not malfunctioning. If you are not able to solve a problem with your fax machine, contact Brother Customer Service at USA:1-800-284-4329(voice) 1-908-575-8790(fax) From within Canada:1-800-853-6660(voice) 1-514-685-4898 (fax) From within Montreal:1-514-685-6464(voice) The serial number is on the back of the unit. Please circle the model number below and retain this OwnerÕs Manual with your sales receipt to serve as a permanent record of your purchase, in the event of a theft, fire or warranty service. MODEL NO: FAX 2750 or FAX 3750 (circle one) SERIAL NUMBER _____________________________ NAME OF DEALER ____________________________ DATE OF PURCHASE __________________________
125IMPORTANT INFORMATION WARNING For protection against the risk of electrical shock, always disconnect all cables from the wall outlet before servicing, modifying or installing the equipment. This equipment may not be used on coin service lines provided by the telephone company or connected to party lines. Brother cannot accept any financial or other responsibilities that may be the result of your use of this information, including direct, special or consequential damages. There are no warranties extended or granted by this document. Laser Safety (For 110Ð120V Models Only) This equipment is certified as a Class I laser product under the U.S. Department of Health and Human Services (DHHS) Radiation Performance Standard according to the Radiation Control for Health and Safety Act of 1968. This means that the equipment does not produce hazardous laser radiation. Since radiation emitted inside the equipment is completely confined within protective housings and external covers, the laser beam cannot escape from the fax machine during any phase of user operation. FDA Regulations U.S. Food and Drug Administration (FDA) has implemented regulations for laser products manufactured on and after August 2, 1976. Compliance is mandatory for products marketed in the United States. One of the following labels on the back of the printer indicates compliance with the FDA regulations and must be attached to laser products marketed in the United States. Manufactured BROTHER INDUSTRIES, LTD. 15-1 Naeshiro-cho Mizuho Nagoya, 467-8561 Japan This product complies with FDA radiation performance standards, 21 CFR Subchapter J. Caution Use of controls, adjustments or performance of procedures other than those specified in this manual may result in hazardous invisible radiation exposure. Caution Changes or modifications not expressly approved by Brother Industries, Ltd. may void the userÕs authority to operate the equipment.
126CHAPTER FOURTEEN Federal Communications Commission (FCC) Declaration of Conformity (For USA Only) Responsible Party: Brother International Corporation 100 Somerset Corporate Boulevard Bridgewater, NJ 08807-0911 USA TEL: (908) 704-1700 declares, that the products Product Name: FAX 2750, FAX 3750 comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Industry Canada Compliance Statement (For Canada Only) This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numŽrique de la classe B est conforme ˆ la norme NMB-003 du Canada. ImportantÑAbout the Interface Cable A shielded interface cable should be used in order to ensure compliance with the limits for a Class B digital device. Changes or modifications not expressly approved by Brother Industries, Ltd. could void the userÕs authority to operate the equipment. Warranty You must use the IEEE-1284 shielded cable provided by Brother Industries, Ltd. (See ÒOrdering Accessories and Supplies,Ó p. 191)ÐÐORÐÐattach a free filter core to your standard shielded printer cable. (To receive a free filter core with instructions, call 1-888-879-3232 (USA) or 1-800-668-2768 (from within Canada) and order item number FCYL2.) International Energy Star Compliance Statement The purpose of the International Energy Star Program is to promote the development and popularization of energy-efficient office equipment, which includes computers, monitors, printers, facsimile receivers and copy machines world-wide. As an International Energy Star partner, Brother Industries, Ltd. has decided that this product meets the guidelines of the program.
127IMPORTANT INFORMATION Important Safety Instructions 1Read all of these instructions. 2Save them for later reference. 3Follow all warnings and instructions marked on the product. 4Unplug this product from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning. 5Do not use this product near water. 6Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to the product. 7Slots and openings in the cabinet and the back or bottom are provided for ventilation; to ensure reliable operation of the product and to protect it from overheating, these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should never be placed near or over a radiator or heater. This product should never be placed in a built-in wall unit or cabinet unless proper ventilation is provided. 8This product should be operated from the type of power source indicated on the label. If you are not sure of the type of power available, consult your dealer or local power company. 9This product is equipped with a 3-wire grounding type plug, a plug having a third (grounding) pin. This plug will fit into only a grounding- type power outlet. This is a safety feature. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the purpose of the grounding-type plug, by using an adapter. 10Do not allow anything to rest on the power cord. Do not place this product where people can walk on the cord. 11If an extension cord is used with this product, make sure that the total ampere ratings on the products plugged into the extension cord do not exceed the extension cord ampere rating. Also, make sure that the total of all products plugged into the wall outlet does not exceed 15 amperes (USA only). 12Never push objects of any kind into this product through cabinet slots, since they may touch dangerous voltage points or short out parts resulting in the risk of fire or electric shock. Never spill liquid of any kind on the product.
128CHAPTER FOURTEEN 13Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage points and/or other risks, and may void your warranty. Refer all servicing to a Brother Authorized Service Center. A list of Brother Authorized Service Centers has been included for your convenience, or you may contact the following Brother Customer Service Numbers for your nearest Brother Authorized Service Center: USA:1-800-284-4329 (voice) 1-908-575-8790 (fax) 1-800-521-2846 (Fax-Back System) From within Canada:1-800-853-6660 (voice) 1-514-685-4898 (fax) 1-800-681-9838 (Fax-Back System) From within Montreal:1-514-685-6464 (voice) 14This product has no main ON/OFF switch. Therefore, it is very important that you have easy access to the main plug and the main socket to which the plug is connected, in case the main power to the machine must be disconnected quickly. 15Unplug this product from the wall outlet and refer servicing to a Brother Authorized Service Center under the following conditions: AWhen the power cord is damaged or frayed. BIf liquid has been spilled into the product. CIf the product has been exposed to rain or water. DIf the product does not operate normally when the operating instructions are followed. Adjust only those controls that are covered by the operating instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation. EIf the product has been dropped or the cabinet has been damaged. FIf the product exhibits a distinct change in performance, indicating a need for service. 16To protect your product against power surges, we recommend the use of a power protection device (Surge Protector).