ATT DEFINITY Communications System Generic 3V4 Instructions Manual

ASAI and Feature Interactionsbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Facility Restriction Levels (FRLs)bbbbbbbb
Third Party Make Calls are placed using the originators COR, the stations COR,
or the splits COR.
Forced Entry of Account Codesbbbbbbbb
Third Party Auto Dial or Third Party Make Call call attempts to Trunk Groups with
the Forced Entry of Account Codes feature assigned are allowed.  It is up to the
originating station user to enter the account codes via the touch-tone pad.
Account...

ASAI and Feature Interactionsbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Leave Word Callingbbbbbbbb
When activated at the callers extension, Leave Word Calling will attach itself to
the principals extension, even if the call was redirected via Redirect Call.
Lookahead Interflowbbbbbbbb
When a DEFINITY switch attempts to send a monitored call to another
DEFINITY using the Lookahead Interflow capability, the second switch may
reject the interflow attempt. If this happens, any ASAI message associated...

ASAI and Feature Interactionsbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
When the only connected member of the PCOL transitions to the held state, the
state for all members of the PCOL changes to the held state even if they were
perviously in bridged state. No event report is sent to any domain-control
association(s) for bridged users for this transition.
All members of the PCOL may be individually domain-controlled.  Each receives
appropriate events as applicable.  Call Control requests are not...

ASAI and Feature Interactionsbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Disconnect/Drop, and/or Call Ended Event Reports.  If such a call goes ISDN
end-to-end, other events are possible (for example, Alerting, Connected Event
Reports).  If such a call interworks, the PROgress message is mapped into a
Cut-Through Event Report.  In this case, only the Disconnect/Drop or Call Ended
Event Reports may follow.
ASAI may provide UUI for inclusion in the Setup message for an outgoing ISDN-
PRI call.  This...

ASAI and Feature Interactionsbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Ringback Queuingbbbbbbbb
Adjunct-routed or switch-classified calls are allowed to queue on busy trunks or
stations.
When activated, the call back call reports events on the same call_id as the
original call.
Send All Calls (SAC)bbbbbbbb
The adjunct can activate this feature by issuing a Request Feature capability. An
adjunct can request a Third Party Make Call or Third Party Auto Dial capability
for a station that has SAC...

ASAI and Feature Interactionsbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
A Third Party Auto Dial call to a station with the SAC feature active redirects to
the covering station.
For incoming calls, the Alerting Event Report is sent only for multifunction sets
receiving calls while having SAC activated. The Alerting Event Report is not
generated for analog sets when the SAC feature is activated and the set is
receiving a call.
Direct-agent calls existing in the agent queue when this feature is...

ASAI and Feature Interactionsbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
condition code ``B.  Switch-classified calls are marked with condition code ``B
and show either the ACD split or the agents extension (depending on how it has
been administered) as the originator.
System Reportsbbbbbbbb
The list station command indicates whether or not a given BRI link is ASAI.
Temporary Bridged Appearancesbbbbbbbb
The operation of this feature has not changed with ASAI. No event is provided
when a temporary...

ASAI and Feature Interactionsbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
buttons) receive a Call Redirected Event Report.  When a button TEG member
goes on-hook but the TEG itself does not drop from the call, no event is sent but
the state of that party changes from the connected state to the bridged state.
The Disconnect/Drop Event Report is not sent to each members domain control
associations until the entire TEG drops from the call (as opposed to an individual
member going on-hook).
Members not...

ASAI and Feature Interactionsbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Transferbbbbbbbb
Manual transfer from a domain-controlled station is allowed subject to the
features restrictions.  The Hold Event Report is provided as a result of the first
button push (or switch-hook flash for analog sets).  The Call Transferred Event
Report is provided as a result of the second button push (or on-hook for analog
sets), and only if the transfer is successfully completed.  The Transfer Event
Report is sent...

bbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
bbbbb
CallVisor ASAI Over the
DEFINITY LAN Gateway
13
bbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Overviewbbbbbbbb
A new transport option, CallVisor ASAI Over the DEFINITY LAN Gateway, is
available in DEFINITY G3V4, and in DEFINITY G3V2/G3V3 with a field
maintenance upgrade.  This option incorporates a system assembly that uses a
Multi-Function Board (MFB), a DEFINITY LAN Gateway circuit pack that
supports an Ethernet controller and a software environment. The...