ATT Definity Addendum 1 For Ds1, Dmi, Isdn Pri Instructions Manual

TIE TRUNK SETTINGSE-15
DIAL PLAN RECORD
Area Code: 619
ARS Prefix 1 Required? n
Uniform Dialing Plan? y
FIRST DIGIT TABLE
FirstLength
Digit - 1 --2--3--4-
1:factac2:
3:
4:
5:
6:7:
8:fac9: fac
0: attendant
*.fac#:fac
Plan Length: 5
-5--6-
extension
extension
extension
extension
extension
extension
Figure E-4. DIAL PLAN RECORD Screen
DS1 Circuit Pack Screen Settings
For details on how to administer this screen, see DEFINITY® 75/85 Communications System, Generic
1.1 and System 75 Implementation, Issue 1,...

E-16TIE TRUNK SETTINGS
DS1 CIRCUIT PACK
Location: 1C19
Name : TG 92 TO KM4Line Compensation: 1Zero Code Suppression: zcs
Framing Mode: esfSignaling Mode: isdn-pri
Connect: pbx
Interface: user
Slip Detection? yMAINTENANCE PARAMETERS
Remote Loop-Around Test? 
n
Figure E-5. DS1 CIRCUIT PACK Screen
Table E-3, DS-1 Circuit Pack Screen Settings — Generic 1, describes the administration settings for the
ISDN-PRI-specific fields in this administration screen.
TABLE E-3. DS-1 Circuit Pack Screen Settings —...

TIE TRUNK SETTINGSE-17
TABLE E-3 (continued). DS-1 Circuit Pack Screen Settings - Generic 1
FIELD
SETTING
REMARKS
Zero CodezcsUnless you have requested unrestricted facilities from the
Suppressionlocal exchange T1 facility, you should assign zcs here. If
you are guaranteed unrestricted facilities all the way from the
Generic 1 to the far-end System 85 R2V4, then you should
assign b8zs here. The System 85 R2V4 should be
administered for the same option as a Generic 1. ZCS causes
an inverted D-channel....

E-18TIE TRUNK SETTINGS
Processor Interface Data Module Screen Settings
The Generic 1 interface to ISDN-PRI requires a synchronous/asynchronous processor interface circuit
pack (TN765). Each TN765 has four ports (links) for supporting BX.25 and/or ISDN applications. Up
to two TN765 (8 links) are possible in a multiple carrier cabinet or one (4 links) in a single carrier
cabinet. The TN765 has data modules (PDMs) integrated into its ports. These processor interface data
modules must have extensions...

TIE TRUNK SETTINGSE-19
TABLE E-4. Processor Interface Data Module Screen Settings — Generic 1
FIELDSETTINGREMARKS
Data ExtensionYou must assign a data module extension to the physical
channel to be used for the ISDN-PRI link to the far-end
System 85 R2V4. Any valid extension can be used here and
does not require coordination with the System 85. Use the
system command add data-module (extension).
Typeprocr-intf
Physical Channel
Enter the physical channel number (01 - 08) to which you
assigned the data...

E-20TIE TRUNK SETTINGS
Table E-5, Interface Links Screeen Settings — Generic 1, describes the administration settings for the
ISDN-PRI-specific fields in this administration screen.
TABLE E-5. Interface Links Screen Settings — Generic 1
FIELDSETTINGREMARKS
EnableDo not enable any links until all other fields in this screen
and all fields in the Processor Channel Assignment have been
administered. After administering these other fields, come
back to this screen. Enter a y next to the link corresponding
to...

TIE TRUNK SETTINGSE-21
PROCESSOR CHANNEL ASSIGNMENT
ProcInterfaceRemote
Chan Appl.LinkChanPriorityProc Chan Machine-ID1:
2:
3:
4:
5:
6:
7:
8:
9:
10:isdn211:isdn412:
13:
14:
15:
16:
h
h
Figure E-8. PROCESSOR CHANNEL ASSIGNMENT Screen
Table E-6, Processor Channel Assignment Screen Settings — Generic 1, describes the administration
settings for the ISDN-PRI-specific fields in this administration screen.
TABLE E-6. Processor Channel Assignment Screen Settings — Generic 1
FIELD
SETTING
REMARKS
Proc ChanThis...

E-22TIE TRUNK SETTINGS
Trunk Group Screen Settings
This screen is used to administer the ISDN-PRI trunk group.
Following is an example of typical settings for this screen when a Generic 1 is connected to a System 85
R2V4 via ISDN-PRI trunks:
TRUNK GROUP
Group Number: 92
Group Type:Group Name: ISDN-DaleyCOR:Direction: two-wayOutgoing Display?
Dial Access? nBusy Threshold:
Queue Length: 0
Service Type: tandem
isdn-priSMDR Reports? y32n60
Far End Test No: 5767999TRUNK PARAMETERS
Send Display/TCM in codeset...

TIE TRUNK SETTINGSE-23
TRUNK FEATURES
ACA Assignment? yLong Holding Time (hours): 1
Short Holding Time (sec): 3Short Holding Threshold: 10
MIS Measured? n
Used for DCS? yPBX ID: 3Data Restriction? n
Maintenance Tests? ySend SID? y
Send Name? y
Service/CalledCalledDelInsertPer CallNightFeatureLenNumberSID/ANIServ.tandem7867998
Figure E-10. TRUNK GROUP Screen — Page 2
GROUP MEMBER ASSIGNMENTS
PortNameNight
1:
2:
3:
4:
5:
6:
7:
8:
9:
10:
11:
12:
13:
14:
15:
1C1901
1C1902
1C1903
1C1904
1C1905
1C1906
1C1907...

E-24TIE TRUNK SETTINGS
Table E-7, Trunk Group Screen Settings — Generic 1, describes the administration settings for the
ISDN-PRI-specific fields in this administration screen.
TABLE E-7. Trunk Group Screen Settings — Generic 1
FIELDSETTINGREMARKS
Group NumberThis field displays the ISDN-PRI trunk group number.
Group Typeisdn-pri
Group Name
Enter a name one to fifteen characters in length that uniquely
identifies this trunk group.
TACEnter the access code for this trunk group. This is needed for
SMDR...