AEG S 75267 Kg1 User Manual

							71
Installation
Installation Location
The appliance should be set up in a well ventilated, dry room.
Energy use is affected by the ambient temperature. The appliance should
therefore
– not be exposed to direct sunlight;
– not be installed next to radiators, cookers or other sources of heat;
– only be installed at a location whose ambient temperature corresponds to
the climate classification, for which the appliance is designed.
The climate classification can be found on the serial plate, which is located
at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for each
climate classification: each climate classification:
Climate classificationfor an ambient temperature of
SN+10 bis +32 °C
N+16 bis +32 °C
ST+16 bis +38 °C
T+16 bis +43 °C
If installation next to a source of heat is unavoidable, the following mini-
mum clearances must be maintained at the sides of the appliance:
– for electric cookers 3 cm;
– for oil and coal fired ranges 30 cm.
If these clearances cannot be maintained a heat insulating pad is required
between the cooker and the refrigeration appliance.
If the refrigeration appliance is installed next to another refrigerator or free-
zer a clearance of 5 cm at the sides is required, in order to prevent the for-
mation of condensation on the outside of the appliance.
 
						

							72
Operating and indicator panel Wine cooler
A. Mains pilot indicator (green)
B Fridge button ON/OFF
C Temperature setting button (for warmer temperatures)
D Temperature display 
E Temperature setting button (for colder temperatures)
Temperature setting buttons
The temperature is adjusted using the “C“ (+) and “E“ (-) buttons. These but-
tons are connected to the temperature display.
 The temperature display is switched over from the display of the ACTUAL
temperature (Temperature display is illuminated) to the display of the DESI-
RED temperature (Temperature display flashes) by pressing one of the two
buttons, “C“ (+) or “E“ (-). 
 Each time one of the two buttons is pressed again the DESIRED temperatu-
re is adjusted by 1 °C. The DESIRED temperature must be reached within 24
hours.
If neither button is pressed, the temperature display automatically switches
back after a short period (approx. 5 sec.) to the display of the ACTUAL tem-
perature.
DESIRED temperature means: 
The temperature that has been selected for inside the fridge. The DESIRED
temperature is indicated by flashing numbers.
ACTUAL temperature means: 
The temperature display indicates the current temperature inside the fridge.
The ACTUAL temperature is indicated with illuminated numbers.
Temperature display
The temperature display can indicate several pieces of information.
 During normal operation, the temperature currently present in the fridge
(ACTUAL temperature) is displayed. 



 







	


   
 
						

							73
 When the temperature is being adjusted a flashing display indicates the
fridge temperature currently set (DESIRED temperature). 
Starting Up - Setting the Temperature
1. Plug the mains plug into the mains socket. 
2. Press ON/OFF, button B can function the wine cooler compartment separa-
tely with the appliance in function. The green mains pilot indicator illumi-
nates. 
3. Press either the “C“ (+) or “E“ (-) button. The temperature display switches
over and the DESIRED temperature currently set flashes on the temperatu-
re display.
4. Set the required temperature by pressing the “C“ (+) or “E“ (-) buttons (see
section Temperature setting buttons). The temperature display will imme-
diately show the changed setting. Each time the button is pressed the tem-
perature is adjusted by 1 °C.
From a food safety point of view +5 °C should be considered sufficiently
cold for storing food in the fridge.
5. Once the required temperature has been set, after a short period (approx. 5
sec.) the temperature display will change and again indicate the current
ACTUAL temperature inside the fridge. The display will change from flashing
to continuous illumination.
Information!When the setting is changed, the compressor does not start
immediately if automatic defrosting is currently taking place. As the stora-
ge temperature within the fridge is reached quickly you can store food
immediately after switching on.
Important: If the wine cooler compartment is off, the door must be clo-
sed in order that the freezer is working properly.
In this condition, the electronic control of the appliance functions auto-
matically and periodically circulating the air to prevent unpleasant smel-
ls and humidity.
Switching the appliance off
The wine cooler can be switched off independently of the freezer compart-
ment. By switching off the freezer compartment you also switch off the
wine cooler. To switch off the wine cooler, hold down the On/Off button (B)
for the wine cooler for a count of 5 Sec. 
To switch off the appliance hold down the On/Off button (G) for approx.5
seconds. This will result in acount down from 3 to 1 taking place in the
temperature display. On reaching 1 the appliance will switch off. The tem-
perature display will go off.
 
						

							74
Using the wine cooler
Wine cooler
To obtain the best performance the temperature can be adjusted between
+6 and + 16°C.
This compartment is ideal for storing and refining red or white wines for
long periods.
Lay the bottles downin such a way that the corks do not dry.
Keep the wine in the dark.The door is anti-UV darkened double glazed
glass to protect the wine from the light in case the appliance is located in
a well-lit place.
Handle the bottles with care,to avoid agitating the wine.
Follow the recommendations and advice received at the time of purchase
or given in the technical documentation regarding the quality, duration
and optimum storage temperature for the wine.
Air circulation
Do not cover the shelves with any protective material, such as paper, card-
board or plastic, which may obstruct the air circulation through them.
Do not place the bottles at directly against the back wall of the compart-
ment  which will obstruct the air circulation through them. 
Normal operating sounds
 You may hear faint gurgling or bubbling sounds when the refrigerant
is pumped through the coils or tubing at the rear, to the cooling
plate/evaporator or to the fixed freezer shelves.
 When the compressor is on, the refrigerant is being pumped round,
and you will hear a whirring sound or pulsating noise from the com-
pressor.
 
						

							75
Movable shelves
The shelves can be inclined
between the two guides, making
sure that the smallest pins are
properly inserted in the upper
guide seat and the front part of
the shelf is resting on the front
guide.
Adjust the wooden shelves as fol-
lows:
The short shelf can be placed on
the two short guides at the top.
The long shelf can be placed on
the three long middle guides and
inclined between the last short
guide at the bottom and the shelf
support structure.
The shelf support structure must
be placed in the bottom of the
compartment.
Important:Only the long shelves
can be inserted in the shelf sup-
port structure.
 
						

							76
Operating and indicator panel Freezer/ Appliance
F Mains pilot indicator (green)
G. Button ON/OFF for the appliance
H. Temperature setting button (for warmer temperatures)
I. Temperature display 
J. Temperature setting button (for colder temperatures)
K. FROSTMATIC function on indicator (yellow)
L. FROSTMATIC button
M. Alarm reset light
N. Alarm reset button
Temperature setting buttons
The temperature is adjusted using the “H“ and “J“ buttons. These buttons are
connected to the temperature display.
 The temperature display is switched over from the display of the ACTUAL
temperature (Temperature display is illuminated) to the display of the DESI-
RED temperature (Temperature display flashes) by pressing one of the two
buttons, “H” or “J“. 
 Each time one of the two buttons is pressed again the DESIRED temperatu-
re is adjusted by 1 °C. The DESIRED temperature must be reached within 24
hours.
If neither button is pressed, the temperature display automatically switches
back after a short period (approx. 5 sec.) to the display of the ACTUAL tem-
perature.



 


	








	



 
						

							77
DESIRED temperature means: 
The temperature that has been selected for inside the freezer. The DESIRED
temperature is indicated by flashing numbers.
ACTUAL temperature means: 
The temperature display indicates the current temperature inside the freezer.
The ACTUAL temperature is indicated with illuminated numbers.
Temperature display
The temperature display can indicate several pieces of information.
 During normal operation, the temperature currently present in the freezer
(ACTUAL temperature) is displayed. 
 When the temperature is being adjusted a flashing display indicates the
freezer temperature currently set (DESIRED temperature). 
Starting Up - Setting the Temperature
1. Plug the mains plug into the mains socket. 
2. Press ON/OFF button (G) for the functioning of the whole appliance. The
green mains pilot indicator illuminates. The alarm light flashes since the
temperature is reached. The buzzer sounds.
3. Pressing button “N” the buzzer stops.
4. Press either the “K“ or “J” button. The temperature display switches over and
the DESIRED temperature currently set flashes on the temperature display.
5. Set the required temperature by pressing the “K“ or “J“ buttons (see section
Temperature setting buttons). The temperature display will immediately
show the changed setting. Each time the button is pressed the temperatu-
re is adjusted by 1 °C.
From a food safety point of view -18 °C should be considered sufficiently
cold for storing food in the freezer.
6. The alarm light,when the set temperature is reached. Press the alarm but-
ton to turn off the buzzer.
Ice pack
There are 2 ice packs in one drawer of the freezer.
In the event of a power failure or malfunction, the ice pack will lengthen
the amount of time it takes for the frozen food to become too warm by
several hours. The ice pack can only fulfil this task optimally if it is placed in
the uppermost drawer, at the front, above the frozen food. You can use the
ice pack for cooling cold bags.
 
						

							78
FROSTMATIC
The FROSTMATIC function accelerates the freezing of fresh food and, at the
same time, protects foodstuffs already stored from undesirable warming.
1. The FROSTMATIC function is switched on by pressing the FROSTMATIC but-
ton. The yellow light illuminates.
If the FROSTMATIC function is not ended manually, the appliance switch off
the FROSTMATIC function after 52 hours. The yellow light goes out.
2. The FROSTMATIC function can be ended manually at any time by pressing
the FROSTMATIC button again. The yellow light goes out.
Alarm reset button
In the event of an abnormal temperature rise inside the freezer (e.g. power
cut) warning light (M) will start to flash and a buzzer will sound.
After the temperature has returned to normal, the warning light (M) will
continue to flash, although the buzzer has stopped.
When the alarm button is pressed, the warmest temperature reached in the
compartment flashes on the indicator.
Switching the Appliance off
The wine cooler compartment can be switched off independently of the
freezer compartment.
By the switching off of the freezer compartment it is switched off also
the wine cooler compartment.
To switch off the wine cooler, hold down the ON/OFF button (B) for the wine
cooler for a count of 5 Sec. .
To switch off the appliance hold down the ON/OFF button (G) for approx. 5
seconds. This will result in a count down from 3 to 1 taking place in the
temperature display. On reaching 1 the appliance will switch off. The tem-
perature display will go off.
Note:
The appliance cannot be switched on or off if unplugged, or if there is no
power being supplied to it. Following connection to the mains power sup-
ply, the appliance returns to the same operating state as before the inter-
ruption of main power.
If the appliance is not going to be used for an extended period:
1. Remove all refrigerated and deep-frozen packages as well as ice trays.
2. Switch off the appliance, holding down the ON/OFF button (G) until the
display goes off (see above).
3 Remove the mains plug or switch off or turn out the circuit breaker or fuse.
4 Finally, leave the doors open so as to avoid a build up of odours.
 
						

							79
Freezing and storing frozen food
You can use your freezer for freezing fresh food yourself.
Important!
 The temperature in the freezer compartment must be –18 °C or colder
before freezing food.
 Please observe the freezing capacity given on the rating plate. The free-
zing capacity is the maximum quantity of fresh food that can be frozen
within a period of 24 hours. If you wish to freeze food several days in a
row, please observe a maximum capacity of only 2/3 to 3/4 of that on the
rating plate. The quality of the food is best preserved when it is frozen
right through to the core as quickly as possible.
 Allow warm food to cool down before freezing. The warmth will cause
increased ice formation and increase the power consumption.
 Please note the maximum storage times specified by the manufacturer.
 Thawed foods which have not been processed further (cooked into meals)
may not under any circumstances be frozen a second time.
 Containers with flammable gases or liquids can leak at low temperatures.
There is a risk of an explosion! Do not store any containers with flamma-
ble materials such as, for example, spray cans, fire extinguisher refill car-
tridges etc in the refrigerator/freezer.
 Bottles and cans must not be placed in the freezer. They can burst when
the contents freeze, high carbonate content drinks can even explode!
Never store lemonade, juices, beer, wine, sparkling wine etc. in the free-
zer. Exception: high alcohol content spirits can be stored in the freezer.
 All foods must be packed air tight prior to freezing, so that they do not
dry out or lose their flavour, and so that no flavour contamination of
other frozen goods occurs.
Caution!Do not touch frozen food with wet hands. Your hands could free-
ze to the food.
1. Place the packed food in the drawers.
Place food to be frozen in the com-
partment as per the diagram. Unfro-
zen food must not touch items
already frozen, otherwise the frozen
food could begin to defrost. 
2. Place frozen foods in the drawers
sorted by type, as far as possible. 


 
						

							80
Defrosting
Freezer
The freezer compartment of this model, on the other hand, is a no frost
type. This means that there is no buildup of frost when it is in operation,
neither on the internal walls nor on the foods. 
The absence of frost is due to the continuous circulation of cold air inside
the compartment, driven by an automatically controlled fan.
Freezing Calendar
 The symbols on the drawers show
different types of frozen goods.
 The numbers indicate storage times
in months for the appropriate
types of frozen goods. 
Whether the upper or lower value of the indicated storage time is valid
depends on the quality of the foods and pre-treating before freezing. The
lower value applies to foods with high fat content.
Preparation of Ice Cubes
1.  Fill the ice cube tray 3/4 full with cold water, place it in the freezer com-
partment and leave to freeze.
2. To loosen the frozen cubes, either bend the ice cube tray or hold it under
running water for a few seconds.
Important!Never try to free an ice tray that is frozen to the freezer com-
partment using pointed or sharp edged objects. Use the ice scraper supplied.