Vodavi Starplus Triad S Description Manual

KEY STATION FEATURESCentrexlPBX Transfer2-15
Programmable Flash Timer
CO line flash is a momentary opening on a CO line used for signaling. When using the Triad-S system in a
@$
Centrex environment, the CO line flash is to signal the intention to transfer a caller using Centrex transfer.
. .,.The CO line flash timer is programmable on a per CO line bases to facilitate a mixture of Centrex and CO. . . . .
lines within the same system.
Programming g, #, and Hook-Flashes into Speed Dial
Many Centrex codes...

2-16KEY STATION FEATURES
CO Line - Class Of Service (COS)
CO Line 
- Class Of Service (COS)
Each CO Line may be programmed with a Class-of-Service to provide dialing privileges. The Triad-S system
use an array between CO Line Class-of-Service and Station Class-Of-Service to offer a wide variety of dialing
privilege possibilities.
CO Line - Control (Contact)
On the Triad-S system, there are two (2) control contacts which may be individually programmed as either
CO Line Control (to control ancillary...

KEY STATION FEATURES
CO Line - Incoming Ringing Assignment2-17
SMDR always print the line number in place of the programmed name. A programmable data field is
available for each line in the system.This feature is for LCD Display appearance 
only!
CO Line - Incoming Ringing Assignment
Each CO line may be programmed (in database admin) so that incoming ringing on the specified CO line(s)
may be assigned initial ringing to one of the following destinations:
9One or more stations (Keyset or SLT)
+To an ACD,...

2-18KEY STATION FEATURESCO Line - Loop Supervision
CO Line - Loop Supervision
The Triad-S system can be programmed to monitor CO lines while on-hold or connected to RAN devices or
Voice Mail systems, or in Trunk-to-Trunk connections for disconnect signal provided by the 
Telco.
After a disconnect signal is detected, the Triad-S system releases the CO lines and automatically place them
back in service.
CO Line - Pool Button Operation
The Pool Group Key is used primarily to access CO lines that do not...

KEY STATION FEATURES
ConferenceConference
There are two different types of conferencing.
Multi-Party Conference
Up to eight parties can engage in a conference. A maximum of five external parties can be conferenced.
Unsupervised Conference
The conference initiator can exit a conference with two outside parties and leave them in an unsupervised
conference. The initiator can re-enter the conference at any time. The Triad-S system can automatically
terminate the call when both parties hang up, when Loop...

KEY STATION FEATURES
Class Of Service (COS) Day/night
Class Of Service (COS) Day/nightThis feature allows stations that are a certain COS during the day, to be assigned a different COS when the
system is put in the night mode. The night COS goes into affect when the system is placed into the night
mode, manually or automatically. This prevents the misuse of phones after hours.
Dial By Name
The system allows station users to dial extension numbers, or speed bins by entering the name of a person
that has...

KEY STATION FEATURESDialing Privileges
Dialing Privileges
The system provides a flexible means of providing toll or dialing restriction. Through the assignment of class
of service (both station and outside line) many combinations of allow and deny numbers can be set. Both
area and office codes can be screened for allow/deny privileges.
Figure 2-1: Digital Enhanced (8-Button) Terminal
STARPLUS Triad-S Product Description ManualIssue I- December 1998 

KEY STATION FEATURESDialing Privileges
Figure 2-2: Digital Executive (IP-Btn) Terminal
Figure 2-3: Digital Executive (24-Button) Terminal
Issue I- December 1998STARPLUS Triad-S Product Description Manual 

KEY STATION FEATURES2-23
Direct Inward System Access (DISA)Direct Inward System Access (DISA)
The Triad-S system allows programming of an unlimited number of outside line calls to provide direct access
to the system and use of features such as WATS lines, intercom dial tone or the ability to dial out on outgoing
trunks without going through the attendant. The duration of a Trunk-to-Trunk DISA call can be set by the
system administrator. DISA callers may also access LCR, All Internal/External paging, All...

2-24KEY STATION FEATURES
Direct Station Selection (DDS)Direct Station Selection (
A user with DSS buttons assigned at their Key Station can call an intercom station or transfer a CO call by
simply pressing the appropriate DSS button.
Direct Transfer Mode
An outside CO line can be transferred from one keyset to another. By using the TRANS button, a screened
(announced) transfer can be transferred directly to the handset on any key station. Any number of attempts
can be made to locate someone by calling...