Vodavi Discovery Ip Techical Guide

6-6 DOWNLOADING SOFTWARE UPDATES
System OperationAugust 1999
DOWNLOADING SOFTWARE UPDATES 
To download updated versions of Discovery IP software, enter a virtual session ALT F3
:
1. Log in as 
root.  Or in a virtual session already in progress, switch to the /root
 directory by 
typing: cd /root 
(you are automatically in the /root
 directory upon logging in).
2. Then type: updater. 
The following screen is displayed (refer to Figure 45):
Figure 45: Updater Main Menu
3. In making selections, use the...

DOWNLOADING SOFTWARE UPDATES 6-7
August 1999System Operation
Update Using FTP
To update through Vodavi’s ftp site, press ENTER, or to address the updater to a different ftp 
site, enter in the appropriate address for that site (refer to Figure 46)
Figure 46: FPT Server Address
To update via FTP, DNS must be configured in Discovery IP’s 
network configuration. Figure 47 shows the screen that is displayed, 
listing the available versions to update to. Make your selection.
Discovery IP, Vodavi...

6-8 DOWNLOADING SOFTWARE UPDATES
System OperationAugust 1999
Figure 47: FTP Update Menu
When the update is complete, the Discovery IP must be power-cycled for the changes to take 
effect.
1. Power off by pressing CTRL+ALT+DEL
 then hitting the power switch.
2. Turn-on the machine again.
3. Review and save a new Discovery IP configuration file to include any additional 
parameters used with the new version of Discovery IP software.
4. Start all necessary processes as usual.
RESTART/SHUTDOWN OF Discovery...

DOWNLOADING SOFTWARE UPDATES 6-9
August 1999System Operation
Failure to properly restart/shutdown the Discovery IP may result in 
hard-disk damage, if the buffer is unable to repair itself. If the 
system is improperly restarted/shutdown, on startup, the machine 
will display the following message:
dev/hda2 was not cleanly unmounted, check forced. 
This will verify that the hard drive was not damaged in the improper 
restart/shutdown. 

6-10 DOWNLOADING SOFTWARE UPDATES
System OperationAugust 1999 

Discovery IP Technical Manual August 1999
7 Calling Instructions
ESTABLISHING/MAINTAINING A VoIP CONNECTION
The connection is established as the user accesses a CO line connected to the Discovery IP unit. 
CO lines can be accessed using a CO line group access code, off hook preference, or direct 
access:
1. A voice message (message 043) prompts for the phone number to be called or caller is 
connected directly to another IP unit (NOMAP), followed by a 
#.  If the caller does not 
enter a 
#, after 3...

7-2 ESTABLISHING/MAINTAINING A VoIP CONNECTION
Calling InstructionsAugust 1999 

Discovery IP Technical Manual August 1999
A Interface Card
ICV-8 CARD
ICV-8 Layout
The ICV Board (refer to Figure A1) provides four analog FXS phone connections to the external 
world.  Two FXS phones can be plugged into each of the four external connectors.  The 
equipment is identified by a model and serial number printed on the printed circuit board.  The 
ICV Board mounts in one slot of a PC/AT chassis ISA Bus. 
Figure A-1: ICV -8 Jumper and Connector Layout
The analog phone lines are connected to...

A-2ICV-8 CARD
Interface CardAugust 1999
Figure A-2: RJ-14 Pinout
Jumper Settings
JP2 and JP3 select one of eight streams of the MVIP bus.  JP2 makes the transmit stream 
connection, while JP3 makes the corresponding receive connection.  These two jumpers are 
typically set to the same stream number.  One jumper is placed on each block according Table 
A1:
Table A-1: JP2 and JP3 MVIP Bus Stream Selection
Position Stream in MVIP Bus Stream in Vodavi ABB
100
211
322
433
5 Not used None
6 Not used None
7 Not...

Discovery IP Technical Manual August 1999
B Parts Specifications
NETWORK CONNECTION
10/100BaseT 
POWER SUPPLY 
SBC
HARD DISK
Data Rate 10 Mbps or 100Mbps
Network Interface Standard IEEE 802.3
Connector RJ45
Data AC Input 115 ~/230 , 6/3 A 60/50 HzV
Network Interface Standard IEEE 802.3
Approvals UL, CSA, TUV, CE
Speed supported up to 133 MHz
Capacity 4.3 Gb