Vivitek Projector DU8090Z User Manual

DU8090Z
Users Manual
Users Manual 

DU8090Z DLP Projector - User Manual 
 
1
 
Table of Contents 
 
Copyright ............................................................................................................................................................ 2 
Copyright ...................................................................................................................................................... 2 
Disclaimer...

DU8090Z DLP Projector - User Manual 
 
2 
Copyright 
Copyright 
The Users Manual (including all pictures, illustrations and software) is protected by the international copyright right 
law. All rights are reserved. No duplication of the manual or any content included in the manual is allowed without the 
written consent of the manufacturer.   
Vivitek is the trademark of Vivitek Corporation. ©All rights reserved. 2016 
 
Disclaimer 
The information in the manual is subject to change without notice. The...

DU8090Z DLP Projector - User Manual 
 
3 
Important Safety Guidelines 
Thank you for purchasing the high quality product! 
Read the Manual carefully to obtain the best performance. The Manual provides instructions to use the menu and 
implement operation. 
 
Safety Notification 
 To turn off main power, ensure to unplug from power outlet. 
 To prevent electric shock, do not open the cabinet. There are high-voltage components inside. 
Refer service to qualified service personnel. 
 The symbol warns the...

DU8090Z DLP Projector - User Manual 
 
4    These laser diodes are sealed in the light module. It is recommended to ask dealer for maintenance or repair 
services of the light module. 
  End user is not allowed to replace the light module. 
  Contact distributor who provides the qualified service for light module replacement and further information. 
LASER SAFETY NOTIFICATION AND CAUTION 
 Do not stare at the lens while in use 
  CLASS 3R LASER PRODUCT   
  This Laser Product is designated as Class...

DU8090Z DLP Projector - User Manual 
 
5 
Installation and Use Notices 
1.  Read and keep this manual properly. 
2.  Pay attention to all the noted warnings, and follow all the guidelines and descriptions in this manual. 
3.  Do not use the projector near water. 
4.  Do not install the equipment near the thermal sources, such as heaters, radiators, furnace, amplifiers, and any 
other equipment that may generate heat. 
5.  Be careful while holding the equipment or moving the trolley with projector to...

DU8090Z DLP Projector - User Manual 
 
6 
Introduction 
 
The Users Manual describes the installation, setup and operation of the DU8090Z projector and provides assistance 
to the installation personnel and the end-user to fully develop the performance of the projector. VIVITEK has made 
every effort to ensure that the information in the Manual is correct at the time of printing. The contents may be 
frequently updated due to the continuously product improvement and customer feedback. 
You can find the...

DU8090Z DLP Projector - User Manual 
 
7 
Projector Overview 
 
Front-right View 
 
 
 
 
 
 1. Front IR Receiver 
The Receiver for IR signals from remote control. 
2. LED Indicator 
Display current projector status such as power, light source status 
and warning. 
3. Air Intake 
      The fan pulls the cool air to the projector for system cooling. 
4.  Lens Release Button 
        Press the Lens Change button before removing the lens. 
5. Lens hood 
Remove the cover before installing the lens. 
6....

DU8090Z DLP Projector - User Manual 
 
8  Bottom View 
 
 
 
 
 15.  Anti-thief Screw hole 
The anti-thief screw can be fastened to prevent 
Lens removing by unauthorized person. 
16.  Mounting Holes of Support Kit 
These two screws holes can be used to fix 
support kits of ultra-short throw lens. 
Note: The screws are for Lens support kits only; 
overloading may damage the projector or cause 
injury. 
17.  Recess for projector handling. 
These four recesses can be used for handling 
the projector. 
18....

DU8090Z DLP Projector - User Manual 
 
9 
IO Panel 
 
TRIGGER(12V +/-1.5V) 
When connected to the screen thtough a 3.5mm cable, 
the screen deploys automatically on start up of the 
projector. The screen reacts when the projector is 
powered off.   
 
RS-232 
The 9-pin D-sub interface is used to connect to the PC 
control system and projector maintenance. 
 
Component (V, H, B/Pb, G/Y, R/Pr) 
Connect RGBHV or Component signal from computer or 
component video enabled device 
 
VGA 
Provide the standard...